1. Introduction
This manual provides essential instructions for the proper use, installation, and maintenance of your Vileda JetClean 3-in-1 Floor Cleaner Accessory Set. This set includes two double filters and one microfibre roller, designed to ensure optimal performance of your Vileda JetClean floor cleaner. Please read these instructions carefully before use.
2. Product Overview
The Vileda JetClean 3-in-1 Floor Cleaner Accessory Set is designed to replace worn components of your Vileda JetClean device, maintaining its cleaning efficiency. The set comprises:
- Microfibre Roller: A rotating roller made of 75% polyester and 25% polyamide, designed for effective floor cleaning.
- Double Filters (x2): Filters that capture dirt and debris, ensuring clean water circulation and protecting the motor.

Image 1: Overview of the Vileda JetClean Accessory Set, featuring the microfibre roller and two double filters.
3. Setup and Installation
Follow these steps to install the new microfibre roller and double filters into your Vileda JetClean floor cleaner.
3.1 Installing the Microfibre Roller
- Ensure the Vileda JetClean device is turned off and unplugged from the power source.
- Remove the dirty or worn microfibre roller from the device according to your main Vileda JetClean manual.
- Align the new microfibre roller with the designated slot in the cleaner head.
- Gently push the roller into place until it clicks securely. Ensure it rotates freely.

Image 2: The Vileda JetClean microfibre roller, ready for installation.
3.2 Installing the Double Filters
- Locate the filter compartment on your Vileda JetClean device. Refer to your main device manual if unsure.
- Remove the old filters. Dispose of them responsibly.
- Insert the new double filters into the compartment, ensuring they are seated correctly. The red frame should face outwards.
- Close the filter compartment cover securely.

Image 3: The two Vileda JetClean double filters, ready for installation.
4. Operating with New Accessories
Once the new microfibre roller and double filters are installed, your Vileda JetClean is ready for use. These accessories are integral to the cleaner's function, ensuring efficient dirt removal and water filtration.
- The microfibre roller effectively picks up dirt and liquid from hard floors.
- The double filters prevent debris from entering the motor and ensure the clean water system functions correctly.
Always refer to your main Vileda JetClean device manual for specific operating instructions.
5. Maintenance
Regular maintenance of your accessories is crucial for the longevity and performance of your Vileda JetClean device.
5.1 Microfibre Roller Care
- After each use, remove the roller and rinse it thoroughly under running water to remove trapped dirt and debris.
- Allow the roller to air dry completely before re-installing or storing.
- Replacement Recommendation: It is recommended to replace the microfibre roller after one year of regular use to maintain optimal cleaning performance.
5.2 Double Filter Care
- Rinse the filters under running water after each cleaning session to remove accumulated dirt.
- Ensure the filters are completely dry before re-inserting them into the device.
- Replacement Recommendation: Replace the double filters regularly, or when you notice a decrease in suction or cleaning performance, typically every 6-12 months depending on usage.
6. Troubleshooting
If you experience issues related to the accessories, consider the following:
- Poor Cleaning Performance: Check if the microfibre roller is clean and free from obstructions. If it's old or worn, replace it.
- Reduced Suction: Inspect the double filters for clogging. Clean or replace them if necessary. Ensure they are correctly installed.
- Roller Not Rotating: Ensure the roller is correctly seated and not obstructed by debris. Refer to the main device manual for roller assembly instructions.
For further assistance, consult your Vileda JetClean main device manual or contact Vileda customer support.
7. Specifications
| Product Name | Vileda JetClean 3-in-1 Floor Cleaner Accessory Set |
| Model Number | 4023103231061 |
| Components | 1x Microfibre Roller, 2x Double Filters |
| Microfibre Roller Composition | 75% Polyester, 25% Polyamide |
| Product Dimensions | 4.53 x 1.97 x 9.06 inches (approximate, for the set) |
| Item Weight | 8.1 ounces |
| Manufacturer | Freudenberg Home & Cleaning |
8. Warranty and Support
According to product specifications, there is no explicit warranty provided for this accessory set. For any product-related inquiries or support, please contact Vileda customer service or refer to the official Vileda website for your region.
For information regarding the main Vileda JetClean device, please consult its dedicated instruction manual and warranty information.





