BLACK+DECKER BXCSH2001E

BLACK+DECKER BXCSH2001E 2000W Digital Electric Convection Heater Instruction Manual

1. Introduction

Thank you for purchasing the BLACK+DECKER BXCSH2001E 2000W Digital Electric Convection Heater. This manual provides essential information for the safe and efficient operation, installation, and maintenance of your new appliance. Please read these instructions thoroughly before use and retain them for future reference.

2. Important Safety Instructions

When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

  • Read all instructions before using this heater.
  • This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handles when moving this heater.
  • Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 1 meter (3 feet) from the front of the heater and keep them away from the sides and rear.
  • Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating unattended.
  • Always unplug heater when not in use.
  • Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
  • Do not use outdoors.
  • This heater is not intended for use in bathrooms, laundry areas, and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
  • Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over.
  • To disconnect heater, turn controls to OFF, then remove plug from outlet.
  • Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
  • To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
  • A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
  • Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
  • Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
  • This heater includes an automatic shut-off safety feature that activates if a sudden temperature change is detected, such as when a window is opened.

3. Product Overview

The BLACK+DECKER BXCSH2001E is a digital electric convection heater designed to provide comfortable warmth with advanced features for convenience and safety.

Key Features:

  • Two Heating Powers: Select between 1250W and 2000W to suit your heating needs.
  • Digital Control Panel: Features a tactile, illuminated display for easy operation and temperature monitoring.
  • Adjustable Thermostat: Set your desired temperature up to 35°C. The heater automatically maintains the set temperature.
  • 24-Hour Timer: Program daily or weekly operation for consistent warmth.
  • Automatic Shut-off Detector: Enhances energy efficiency and safety by turning off the heater if a sudden temperature drop (e.g., open window) is detected.
  • Integrated Carry Handle: For easy portability.
  • Stable Feet: Ensures maximum stability on various floor types.

Product Components:

BLACK+DECKER BXCSH2001E heater in a living room with a person reading on a sofa.
Figure 1: The BLACK+DECKER BXCSH2001E heater in a living room setting, demonstrating its compact design and 2000W power capability.
Close-up of the heater's LED digital display showing '24' degrees Celsius.
Figure 2: A detailed view of the heater's LED digital display, showing the current temperature and control icons.
A hand adjusting the thermostat on the heater's control panel, with labels for adjustable thermostat and 24-hour timer.
Figure 3: User interacting with the control panel to adjust the thermostat and utilize the 24-hour timer function.
Two images of the heater's control panel, showing a transition from brighter to dimmer display light intensity.
Figure 4: Illustration of the control panel's adjustable light intensity feature.
A hand gripping the integrated carry handle on the side of the heater.
Figure 5: The integrated carry handle, designed for easy and safe transportation of the heater.
Close-up of the heater's stable feet on a wooden floor.
Figure 6: The design of the heater's feet, ensuring maximum stability during operation.

4. Setup

Unpacking:

  • Carefully remove the heater from its packaging.
  • Check for any damage during transit. If damaged, do not operate and contact customer support.
  • Ensure all components, including the feet, are present.

Placement:

  • Place the heater on a firm, level surface.
  • Ensure there is at least 1 meter (3 feet) of clear space around the heater from walls, furniture, curtains, and other combustible materials.
  • Do not place the heater directly below a power outlet.
  • Avoid placing the heater in high-traffic areas where it could be easily knocked over.

Power Connection:

  • Ensure the heater is switched off before plugging it into a power outlet.
  • Plug the heater directly into a suitable 240V AC wall outlet. Do not use extension cords or power strips.

5. Operating Instructions

Powering On/Off:

  • To turn on the heater, press the Power button (I) on the digital control panel. The LED display will illuminate.
  • To turn off the heater, press the Power button again.

Setting Heating Power:

  • Once powered on, use the heating power selection button (often indicated by 'SSS' or similar icon) to cycle between the two power settings: 1250W and 2000W.
  • Select the appropriate power level based on the room size and desired heating speed.

Adjusting the Thermostat:

  • Use the '+' and '-' buttons on the control panel to increase or decrease the desired temperature.
  • The heater will operate until the set temperature is reached, then automatically switch off. It will reactivate when the room temperature drops below the set level.
  • The thermostat can be set up to 35°C.

Using the Timer:

  • Press the Timer button (often indicated by a clock icon) to access the programming functions.
  • Follow the on-screen prompts to set daily or weekly operating schedules. Refer to the display for specific timer settings.

Control Light Intensity:

  • The control panel display light intensity can be adjusted. Consult the specific icon on the panel (e.g., a sun or light bulb icon) and press to cycle through brightness levels.

Automatic Shut-off Feature:

  • The heater is equipped with a safety feature that detects sudden drops in room temperature, such as when a window is opened. In such cases, the heater will automatically shut off to conserve energy and prevent overheating.
  • To resume operation, close the window and restart the heater manually if it does not resume automatically.

6. Maintenance

Cleaning:

  • Always unplug the heater from the power outlet and allow it to cool completely before cleaning.
  • Wipe the exterior surfaces with a soft, damp cloth. Do not use abrasive cleaners or solvents.
  • Ensure no water enters the interior of the heater.
  • Do not immerse the heater in water or any other liquid.

Storage:

  • If storing the heater for an extended period, clean it thoroughly as described above.
  • Store the heater in a cool, dry place, preferably in its original packaging, away from direct sunlight and moisture.
  • Do not place heavy objects on top of the heater during storage.

7. Troubleshooting

If your heater is not operating correctly, please check the following before contacting customer support:

ProblemPossible CauseSolution
Heater does not turn on.No power supply.
Power button not pressed.
Overheat protection activated.
Check if the heater is properly plugged into a working outlet.
Press the Power button.
Unplug, let cool for 10-15 minutes, then plug in and restart. Ensure proper ventilation.
Heater stops unexpectedly.Automatic shut-off (open window detected).
Overheat protection activated.
Close any open windows or doors causing a sudden temperature drop. Restart the heater.
Unplug, let cool for 10-15 minutes, then plug in and restart. Ensure proper ventilation.
Heater is on but not heating.Thermostat set too low.
Heating power set to 0 (if applicable).
Increase the set temperature using the '+' button.
Ensure a heating power (1250W or 2000W) is selected.
Unusual odor during first use.Normal for new appliances.This is usually temporary. Ensure good ventilation in the room. The odor should dissipate after a few hours of use.

8. Specifications

  • Brand: BLACK+DECKER
  • Model: BXCSH2001E
  • Power: 2000 Watts (with 1250W option)
  • Voltage: 240V
  • Dimensions (L x W x H): 62 x 23 x 43 cm
  • Weight: 4.9 Kilograms
  • Heating Method: Convection
  • Special Features: Adjustable temperature, digital controls, 24-hour timer, automatic shut-off (open window detection), 2 heating powers.
  • Indoor/Outdoor Use: Indoor

9. Warranty and Support

For warranty information, please refer to the documentation provided with your purchase or contact your retailer. Spare parts availability information is not provided by the manufacturer for this product.

For technical support or service inquiries, please contact BLACK+DECKER customer service or your authorized dealer.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.