1. Introduction
Thank you for choosing the EILISON Remote Control. This manual provides essential information for the proper setup, operation, and maintenance of your remote. Please read these instructions carefully before use to ensure optimal performance and longevity of your device. This remote is designed for use with EILISON Bolt 560 and Atom 816 Vibration Plates.
2. Product Overview
Figure 1: EILISON Remote Control and examples of compatible vibration plates (Bolt 560, Atom 816).
The image displays the EILISON remote control, which is brown with white buttons. The remote features a power button, play/pause button, directional buttons for speed and time adjustments, and 'M' and 'P' buttons for mode and program selection. To the right of the remote, three different EILISON vibration plates are shown, illustrating the types of devices this remote is compatible with.
The EILISON Remote Control is an ergonomic device designed to provide convenient control over your compatible EILISON vibration plate. Its intuitive button layout allows for easy adjustment of speed, time, and program modes during your workout.
3. Setup
3.1 Battery Installation
- Locate the battery compartment on the back of the remote control.
- Slide open the battery compartment cover.
- Insert two (2) AAA batteries, ensuring the correct polarity (+ and -) as indicated inside the compartment. (Batteries are not included)
- Close the battery compartment cover securely.
3.2 Initial Use
Once batteries are installed, the remote control is ready for use. Point the remote directly at the receiver on your EILISON vibration plate. No pairing process is typically required for this remote model; it should function directly with compatible EILISON Bolt 560 and Atom 816 Vibration Plates.
4. Operating Instructions
Familiarize yourself with the buttons on your EILISON remote control:
- Power Button (Red, Top Left): Press to turn the vibration plate ON or OFF.
- Play/Pause Button (White, Top Right): Press to start or pause the vibration plate's operation.
- SPEED ▲ (Up Arrow): Increases the vibration speed level.
- SPEED ▼ (Down Arrow): Decreases the vibration speed level.
- TIME ► (Right Arrow): Increases the workout duration.
- TIME ◄ (Left Arrow): Decreases the workout duration.
- M (Mode Button): Cycles through different vibration modes (e.g., oscillation, linear, 3D, if supported by your vibration plate).
- P (Program Button): Selects pre-set workout programs available on your vibration plate.
Ensure there is a clear line of sight between the remote control and the vibration plate's receiver for proper function.
5. Maintenance
5.1 Cleaning
To clean the remote control, gently wipe it with a soft, dry cloth. Do not use abrasive cleaners, solvents, or immerse the remote in water, as this can damage the electronic components.
5.2 Battery Replacement
Replace batteries when the remote's response becomes sluggish or stops working. Always replace both batteries at the same time with new ones of the same type (AAA). Dispose of used batteries responsibly according to local regulations.
5.3 Storage
Store the remote control in a cool, dry place away from direct sunlight and extreme temperatures. If the remote will not be used for an extended period, it is recommended to remove the batteries to prevent leakage.
6. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Remote not responding. | Dead or incorrectly installed batteries. | Check battery polarity. Replace batteries with new ones. |
| Remote has limited range or intermittent response. | Obstruction between remote and vibration plate. Weak batteries. | Ensure clear line of sight. Replace batteries. |
| Specific buttons not working. | Button malfunction or debris. | Clean the remote surface. If problem persists, contact customer support. |
| Remote does not control the vibration plate. | Incompatibility with the vibration plate model. | Verify that your vibration plate is an EILISON Bolt 560 or Atom 816 model. |
7. Specifications
- Brand: EILISON
- Model Compatibility: EILISON Bolt 560, EILISON Atom 816 Vibration Plates
- Color: Brown
- Special Feature: Ergonomic design
- Package Dimensions: 6.57 x 2.17 x 0.83 inches
- Item Weight: 1.13 ounces
- Power Source: 2 x AAA Batteries (not included)
8. Warranty and Support
EILISON products are manufactured with quality and reliability in mind. For any questions, technical support, or warranty inquiries regarding your EILISON Remote Control, please contact EILISON customer service. Refer to your product packaging or the official EILISON website for the most current contact information.
You can also visit the EILISON Store on Amazon for more information and product support.
