1. Introduction
Thank you for choosing the Roco RQ-W1LT1700 HB Mechanical Pencil set. This set includes four 0.5 mm mechanical pencils designed for smooth and consistent writing and drawing. This manual provides essential information on how to set up, operate, maintain, and troubleshoot your mechanical pencils to ensure optimal performance and longevity.
Figure 1: Front view of the Roco RQ-W1LT1700 HB Mechanical Pencil 4-Pieces package, showing four pencils in various colors.
2. Setup
Your Roco mechanical pencils come pre-loaded with HB lead. To load or replace lead:
- Locate the eraser at the top of the pencil.
- Gently pull the eraser and the attached mechanism straight out from the pencil body. This will reveal the lead reservoir.
- Insert new 0.5 mm lead sticks into the reservoir. Do not overfill; typically, 2-3 lead sticks are sufficient.
- Carefully push the eraser and mechanism back into the pencil body until it is securely seated.
Figure 2: Back of the product packaging illustrating the "PULL OUT" and "PUSH IN" steps for lead replacement.
3. Operating Instructions
Using your Roco mechanical pencil is straightforward:
- To extend the lead, press the top button (where the eraser is located) repeatedly until the desired lead length is exposed.
- To retract the lead, press and hold the top button, then gently push the lead back into the tip.
- The eraser can be used by removing the cap or by simply using the exposed part.
4. Maintenance
Proper maintenance ensures the longevity and smooth operation of your mechanical pencils:
- Cleaning the Tip: If lead dust accumulates in the tip, gently remove it using a soft brush or a piece of cloth. Avoid using sharp objects that could damage the mechanism.
- Lead Storage: Store extra lead in a secure container to prevent breakage.
- Avoid Drops: Dropping the pencil, especially on its tip, can damage the internal mechanism or bend the lead sleeve, leading to lead breakage or jamming.
- Eraser Replacement: When the eraser wears down, it can be replaced by pulling out the old one and inserting a new compatible eraser.
5. Troubleshooting
Here are solutions to common issues you might encounter:
- Lead Not Advancing:
- Check if the lead reservoir is empty. Load new lead if necessary.
- Ensure the lead is the correct 0.5 mm diameter. Incorrect lead size can cause jamming.
- Inspect the tip for broken lead pieces or debris. Clear any obstructions carefully.
- Lead Breaking Frequently:
- Avoid extending too much lead at once. A short extension provides better support.
- Apply less pressure when writing.
- Ensure you are using good quality 0.5 mm HB lead.
- Eraser Not Staying In:
- Ensure the eraser is fully pushed into the mechanism.
- If the eraser is old or worn, it might have shrunk. Replace it with a new one.
6. Specifications
| Feature | Detail |
|---|---|
| Brand | Roco |
| Model Name | RQ W1LT1700 |
| Tip Size | 0.5 mm |
| Lead Hardness | HB |
| Quantity | 4 Pieces |
| Closure Type | Retractable |
| Body Shape | Round |
| Item Weight (Package) | 40 g |
| Package Dimensions | 20.5 x 5.8 x 1.6 cm |
7. Warranty and Support
Roco mechanical pencils are manufactured to high-quality standards. While specific warranty details are not provided in this manual, please retain your proof of purchase for any potential warranty claims. For product support or inquiries, please refer to the retailer where the product was purchased or visit the official Roco website for contact information.
For general information about Roco products, you may visit: www.roco.com (Note: This is a placeholder URL as no specific support link was provided in the product data.)
