AVENLI 29P483
AVENLI Pool Filter Cartridge User Manual
Model: 29P483
Introduction
This manual provides essential information for the proper use, maintenance, and troubleshooting of your AVENLI Pool Filter Cartridge. Please read this manual thoroughly before installation and use to ensure optimal performance and longevity of the product.

Image 1: Full view of the AVENLI Pool Filter Cartridge. This cartridge is designed to absorb large dirt particles from pool water.
Product Features
- Efficient Filtration: Designed to absorb large dirt particles, reducing the need for frequent water changes.
- Reusable and Eco-friendly: The cartridge can be easily cleaned and reused, promoting environmental sustainability.
- Easy Maintenance: Simple washing allows for quick and effective cleaning.
- Optimal Performance: Regular cleaning every 3 to 5 days is recommended for best filtration results.

Image 2: Close-up view of the filter pleats, showing the material designed for efficient particle absorption.
Setup and Installation
- Prepare the Filter System: Ensure your pool's filter pump system is turned off and disconnected from power before beginning installation.
- Access the Filter Housing: Open the filter housing unit according to your pump system's instructions. This usually involves unscrewing a cap or opening a clamp.
- Remove Old Cartridge (if applicable): Carefully remove any existing filter cartridge. Dispose of it properly if it's no longer usable.
- Insert New Cartridge: Place the AVENLI Pool Filter Cartridge into the filter housing. Ensure it sits securely and correctly within the housing. Do not force it.
- Secure the Housing: Close and secure the filter housing unit. Make sure all seals are properly seated to prevent leaks.
- Restart System: Reconnect the filter pump system to power and turn it on. Check for any leaks around the filter housing.
Note: Always refer to your specific pool pump system's manual for detailed instructions on accessing and securing the filter housing.
Operating Instructions
The AVENLI Pool Filter Cartridge operates as part of your pool's filtration system. Once installed, the cartridge will continuously filter pool water as the pump runs.
- Ensure your pool pump runs for an adequate duration each day to circulate and filter the entire volume of pool water. Consult your pool system's recommendations for daily run times.
- Monitor pool water clarity. A decrease in clarity may indicate the filter cartridge needs cleaning or replacement.
Maintenance
Regular maintenance of your AVENLI Pool Filter Cartridge is crucial for maintaining clear pool water and extending the life of the cartridge.
Cleaning the Filter Cartridge:
- Frequency: For optimal filtration, the cartridge should be cleaned every 3 to 5 days, or more frequently depending on pool usage and debris levels.
- Turn Off Pump: Always turn off and disconnect the pool pump system from power before removing the cartridge.
- Remove Cartridge: Open the filter housing and carefully remove the dirty cartridge.
- Rinse: Use a garden hose with a strong spray nozzle to rinse debris from between the pleats of the cartridge. Work from top to bottom, rotating the cartridge to ensure all surfaces are cleaned.
- Deep Cleaning (Optional): For stubborn dirt or buildup, you may soak the cartridge in a specialized filter cleaning solution (available at pool supply stores) according to the solution's instructions. Rinse thoroughly after soaking.
- Reinstall: Once clean, reinstall the cartridge into the filter housing as described in the "Setup and Installation" section.
Caution: Do not use a high-pressure washer, stiff brushes, or abrasive cleaners, as these can damage the filter material.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Cloudy Pool Water | Clogged or dirty filter cartridge. Insufficient pump run time. | Clean the filter cartridge thoroughly. Increase daily pump run time. Check pool chemical balance. |
| Reduced Water Flow from Jets | Clogged filter cartridge. Air in the system. | Clean the filter cartridge. Bleed air from the pump system (refer to pump manual). |
| Filter Housing Leaks | Improperly seated O-ring/gasket. Housing not tightened correctly. | Turn off pump, open and re-seat O-ring/gasket. Ensure housing is securely tightened. Inspect O-ring for damage. |
Specifications
- Model: 29P483
- Type: Pool Filter Cartridge (Size S/1/I Antibacterial)
- Dimensions: Approximately Φ 80 mm (diameter) x 90 mm (height)
- Material: Filter media designed for absorbing large dirt particles.
- Compatibility: Designed for specific pool pump systems requiring Size S/1/I cartridges.
Warranty and Support
Information regarding specific warranty terms for the AVENLI Pool Filter Cartridge is not provided in this manual. For warranty claims or technical support, please contact the retailer or manufacturer directly using the contact information provided at the point of purchase.
For general inquiries or to find more information about AVENLI products, please visit the official AVENLI website or contact their customer service department.
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.
