Introduction
The NEBO IllumaTrace Blood Tracker Flashlight is a specialized tool designed for hunters and outdoor enthusiasts. This durable, waterproof, and USB rechargeable flashlight features advanced technology to assist in locating game by enhancing the visibility of blood trails. Its robust construction and dual light modes make it an essential companion for tracking in various environments.

Image: The NEBO IllumaTrace Blood Tracker Flashlight, red with black accents, shown at an angle.
Setup
Charging the Battery
The IllumaTrace Blood Tracker Flashlight is equipped with a 4000mAh Lithium-ion rechargeable battery. Before initial use, ensure the flashlight is fully charged.
- Locate the USB charging port on the flashlight. This is typically covered by a protective cap to maintain water resistance.
- Open the protective cap.
- Connect the included USB-A to USB-C charging cable to the flashlight's USB-C port.
- Connect the USB-A end of the cable to a standard USB power source (e.g., wall adapter, computer USB port, power bank).
- The charging indicator light will illuminate, typically red during charging and green when fully charged.
- Once charging is complete, disconnect the cable and securely close the protective cap to maintain the device's IP67 waterproof rating.
Battery Installation/Replacement
The flashlight comes with a pre-installed Lithium-ion battery. If replacement is necessary, follow these steps:
- Unscrew the tail cap of the flashlight.
- Carefully remove the old battery.
- Insert the new 4000mAh Lithium-ion battery, ensuring the positive (+) and negative (-) terminals are correctly oriented according to the markings inside the battery compartment.
- Screw the tail cap back on securely.
Operating Instructions
Power On/Off
Press the power button, usually located near the head of the flashlight, to turn the device on or off.
Selecting Light Modes
The IllumaTrace flashlight features two primary light modes: Blood Tracker and White Light. A mode select dial allows for easy switching between these functions and adjusting the intensity of the Blood Tracker mode.

Image: A hand holding the NEBO IllumaTrace flashlight, highlighting the mode select dial for adjusting light settings.
- White Light Mode: This mode provides a standard 190 lumen white light, suitable for general illumination. Rotate the mode select dial to the designated white light setting.
- Blood Tracker Mode: This mode utilizes IllumaTrace technology, which employs an alternating strobe effect to enhance the visibility of blood against various backgrounds and terrain. This mode offers 170 lumens.
- Adjusting Blood Tracker Intensity: The Blood Tracker mode typically has three adaptive strobe settings (S1, S2, S3). Rotate the mode select dial to cycle through these settings to find the optimal intensity for your tracking conditions.
Secure Carry Options
The flashlight is designed for convenient and secure transport.
- Pocket Clip: Utilize the removable pocket clip to attach the flashlight to clothing, belts, or gear.
- Lanyard: An included lanyard can be attached for additional security and ease of carrying.

Image: A hunter in camouflage with the NEBO IllumaTrace flashlight securely clipped to a backpack strap.

Image: The NEBO IllumaTrace flashlight shining on leaves, making simulated blood drops highly visible due to the IllumaTrace technology.
Maintenance
Cleaning
To maintain optimal performance and appearance, clean the flashlight regularly.
- Wipe the exterior with a soft, damp cloth.
- Avoid using abrasive cleaners or solvents, as these can damage the anodized aluminum finish.
- Ensure the lens is clean and free of debris for maximum light output.
Water Resistance
The flashlight has an IP67 waterproof rating, meaning it can withstand immersion in 3 feet of water for up to 30 minutes and is dustproof. Always ensure the charging port cover and tail cap are securely closed before exposing the flashlight to water or dusty environments.

Image: A hand holding the NEBO IllumaTrace flashlight, which is covered in water droplets, demonstrating its durable and waterproof construction.
Troubleshooting
- Flashlight not turning on: Ensure the battery is fully charged. Check that the battery is correctly inserted with the correct polarity.
- Light output is dim: Recharge the battery. Clean the lens if it appears dirty.
- Charging issue: Verify that the USB cable is securely connected to both the flashlight and the power source. Try a different USB cable or power source. Ensure the charging port is clean and free of debris.
- Water ingress: If water enters the flashlight, immediately turn it off, remove the battery, and allow all components to dry thoroughly before reassembling. Contact customer support if issues persist.
Specifications
| Feature | Detail |
|---|---|
| Model Number | NEB-FLT-1036 |
| Dimensions (L x W x H) | 7.48" x 2.12" x 2.12" |
| Weight | 0.84 lb (13.44 oz) |
| Battery | 4000mAh Lithium-ion (included) |
| Charging | USB-C (cable included) |
| Light Source | LED |
| Blood Tracker Lumens | 170 lm (with 3 adaptive strobe settings) |
| White Light Lumens | 190 lm |
| Beam Range | Up to 262 feet |
| Run Time | Up to 3 hours |
| Water Resistance | IP67 (Waterproof at 3 ft for 30 minutes, dustproof) |
| Material | Anodized Aircraft-Grade Aluminum |
| Special Features | Adjustable Light Modes, Durable, Non-Slip Grip, Rechargeable |

Image: A side view of the NEBO IllumaTrace flashlight, highlighting the removable pocket clip and the USB-C charging port at the base.
Warranty and Support
This NEBO product is covered by a 1-year manufacturer's limited warranty from the date of purchase. This warranty covers defects in materials and workmanship under normal use.
For warranty claims, technical support, or further assistance, please visit the official NEBO website or contact their customer service department. Keep your proof of purchase for warranty validation.