Introduction
Welcome to your new SCHOCK COSMO single-lever mixer faucet. This high-quality kitchen faucet is designed for durability and ease of use, perfectly complementing SCHOCK kitchen sinks. This manual provides essential information for proper installation, operation, and maintenance to ensure optimal performance and longevity of your faucet.
Safety Information
- Always turn off the main water supply before beginning any installation or maintenance work.
- Use appropriate tools and wear protective gear when necessary.
- If you are unsure about any step of the installation process, consult a qualified plumber.
- Avoid overtightening connections, as this can damage components.
- Protect surrounding surfaces from scratches or damage during installation.
Package Contents
Please verify that all components are present before beginning installation:
- SCHOCK COSMO Single-Lever Mixer Faucet (Main unit)
- Flexible connection hoses
- Mounting hardware (gasket, washer, nut)
- Counterweight for pull-out spray hose
- User Manual (this document)
Setup (Installation)
Pre-Installation Checks
- Ensure your sink has a single faucet hole (35mm diameter recommended).
- Clear the area under the sink for easy access.
- Turn off the hot and cold water supply at the stopcocks.
Installation Steps
- Prepare the Faucet: Screw the flexible connection hoses into the base of the faucet. Ensure a tight seal.
- Insert Faucet: Place the faucet into the designated hole on your sink or countertop.
- Secure Faucet: From underneath the sink, slide the rubber gasket, then the metal washer, and finally tighten the mounting nut onto the threaded rod of the faucet. Ensure the faucet is aligned correctly before fully tightening.
- Connect Water Supply: Connect the flexible hoses to your hot and cold water supply lines. The hot water connection is typically on the left, and cold on the right. Use appropriate wrenches and ensure connections are secure but not overtightened.
- Install Pull-Out Spray Hose: Connect the pull-out spray hose to the dedicated port on the faucet body under the sink. Attach the counterweight to the pull-out hose at a position that allows smooth retraction and extension of the spray head.
- Test for Leaks: Slowly turn on the hot and cold water supply. Check all connections for any signs of leakage. Run the faucet for a few minutes to flush out any debris and re-check for leaks.


Operating Instructions
Water Flow and Temperature Control
The single lever controls both water flow and temperature:
- Water Flow: Lift the lever upwards to increase water flow; push it downwards to decrease flow and turn off the water.
- Water Temperature: Move the lever to the left for hot water and to the right for cold water. Adjust the position between left and right to achieve the desired temperature.
Pull-Out Spray Function
Your SCHOCK COSMO faucet features a convenient pull-out spray:
- Extend Spray Head: Gently pull the spray head from the faucet spout to extend the hose.
- Switch Spray Modes: Use the button located on the spray head to switch between a steady stream and a wider spray function.
- Retract Spray Head: After use, guide the spray head back into the spout. The integrated counterweight will assist in smooth retraction.

Maintenance
Cleaning the Faucet
- Clean the faucet regularly with a soft, damp cloth and a mild, non-abrasive soap.
- Do not use abrasive cleaners, scouring pads, harsh chemicals, or acidic cleaning agents, as these can damage the lacquered finish and internal components.
- Rinse the faucet thoroughly with clean water after cleaning and dry it with a soft cloth to prevent water spots and maintain its appearance.
Aerator Maintenance
If water flow becomes weak or uneven, the aerator may be clogged with mineral deposits:
- Carefully unscrew the aerator from the tip of the spout.
- Rinse the aerator under running water and gently remove any debris or mineral buildup. You can use a soft brush or a toothpick for stubborn deposits.
- Screw the aerator back into place, ensuring it is snug but not overtightened.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Low Water Flow | Clogged aerator; partially closed water supply valves; kinked hose. | Clean the aerator (see Maintenance); ensure water supply valves are fully open; check for kinks in flexible hoses under the sink. |
| Leaks from Faucet Base or Connections | Loose connections; damaged gaskets. | Carefully tighten connections, ensuring not to overtighten. If leaks persist, turn off water supply and inspect gaskets for damage. Replace if necessary or consult a plumber. |
| Pull-Out Spray Does Not Retract Smoothly | Obstructed counterweight; kinked or tangled hose. | Check under the sink to ensure the counterweight is free to move and the hose is not kinked or tangled. Adjust the counterweight position if needed. |
| Water Temperature Not Adjusting | Issue with water heater or supply; cartridge malfunction. | Check your hot water supply. If the problem persists, the internal cartridge may need inspection or replacement by a qualified professional. |
Specifications
| Feature | Detail |
|---|---|
| Brand | SCHOCK |
| Model Number | 525122GNE |
| Color | Black (Nero) |
| Style | Modern |
| Finish | Lacquered |
| Material | Brass |
| Dimensions (L x W x H) | 22.5 x 5 x 16.5 cm (approx. 8.86 x 1.97 x 6.5 inches) |
| Weight | 1.98 kg (approx. 4.37 lbs) |
| Installation Method | Deck Mounted |
| Number of Holes Required | 1 |
| Number of Handles | 1 |
| Special Features | Switchable jet and spray function, pull-out spout, flexible connection hose, 360° swivel spout |

Warranty and Support
For detailed warranty information, please refer to the official SCHOCK manufacturer's warranty documentation that accompanied your purchase. This document outlines the terms and conditions of your product's warranty.
For technical support, spare parts, or any other inquiries, please contact SCHOCK customer service through their official website or the contact information provided in your purchase documentation.