XtremepowerUS 75117-V

XtremepowerUS 3/4HP Above-Ground Swimming Pool Pump Spa Pump User Manual

Brand: XtremepowerUS

Model: 75117-V

Product Overview

The XtremepowerUS 3/4HP Above-Ground Swimming Pool Pump is designed for efficient water circulation and filtration in above-ground swimming pools and spas. This self-priming pump features a powerful 2.8 Amp 3/4 HP motor, delivering up to 3,450 rotations per minute. It operates on 115V/60Hz and is capable of transferring up to 2400 gallons of liquid per hour with a maximum suction height of 32 feet. The pump is equipped with an extra-large debris basket and a clear lid for easy monitoring and maintenance.

XtremepowerUS 3/4HP Above-Ground Swimming Pool Pump

Image: The XtremepowerUS 3/4HP Above-Ground Swimming Pool Pump, showing its compact design with the motor on the right and the pump housing with a clear lid and debris basket on the left.

Setup and Installation

Before installation, ensure the pump is placed on a solid, level surface near the pool. The pump requires a 115V/60Hz power supply. For optimal performance and safety, follow all local electrical codes and consult a qualified electrician if unsure.

Connecting the Pump

  1. Ensure all power to the pump is disconnected before beginning installation.
  2. Connect the pump to your pool's filtration system using 1.5-inch female union connections or 1.5-inch slip union connections. Ensure all connections are secure and watertight to prevent leaks.
  3. Position the pump so that it is easily accessible for maintenance and inspection.
  4. Verify that the pump's electrical cord is in good condition and connected to a grounded outlet.
Pool pump connected to an above-ground pool

Image: The pool pump positioned next to an above-ground pool, illustrating its typical installation location and connection points to the pool's filtration system.

Operating Instructions

This self-priming pump is designed for ease of use. Before starting the pump for the first time or after draining, ensure the pump housing is filled with water to assist in priming.

Starting the Pump

  1. Ensure all valves are open and water can flow freely to and from the pump.
  2. If the pump is not self-priming immediately, remove the clear lid and fill the debris basket housing with water. Replace the lid securely.
  3. Connect the pump to the power supply. The pump will begin to operate, circulating water at a rate of up to 2400 gallons per hour.
  4. Monitor the pump for the first few minutes to ensure proper operation and no leaks.
Pool pump with 2400GPH transfer rate label

Image: A close-up of the pool pump highlighting its 2400 GPH transfer rate capability, indicating its high flow performance for efficient water circulation.

Maintenance

Regular maintenance ensures the longevity and efficient operation of your XtremepowerUS pool pump. The clear lid and extra-large debris basket simplify routine checks.

Debris Basket Cleaning

  • Periodically check the clear lid to see if the debris basket needs cleaning. A visible accumulation of leaves and other debris indicates it's time for cleaning.
  • Turn off the pump and disconnect it from the power supply before opening the lid.
  • Unscrew the clear lid and remove the debris basket.
  • Empty the basket and rinse it thoroughly with water.
  • Inspect the O-ring seal on the lid for any damage or wear. Replace if necessary to ensure a watertight seal.
  • Reinsert the clean basket and securely fasten the clear lid.
  • Reconnect power and restart the pump.

General Care

  • Keep the pump area clean and free of obstructions.
  • Protect the pump from direct sunlight and harsh weather conditions.
  • Regularly check all connections for leaks and tighten as needed.
Debris basket and clear lid of the pool pump

Image: The internal debris basket and the clear lid of the pool pump, detached for cleaning, demonstrating the components involved in filtering large debris.

Troubleshooting

This section provides solutions to common issues you might encounter with your pool pump. Always disconnect power before performing any inspection or maintenance.

ProblemPossible CauseSolution
Pump does not start or hums but doesn't run.No power, clogged impeller, motor overload.Check power supply and circuit breaker. Clear any debris from the impeller. Allow motor to cool if overloaded.
Low water flow or no water flow.Clogged debris basket, air leak in suction line, low water level in pool, clogged impeller.Clean debris basket. Check and tighten all suction line connections. Ensure adequate pool water level. Inspect and clear impeller.
Pump is noisy.Air in system, cavitation, worn bearings, vibration.Check for air leaks in suction line. Ensure proper water flow to prevent cavitation. If noise persists, professional service may be required for worn bearings. Ensure pump is securely mounted.
Water leaking from pump.Loose connections, damaged O-rings/seals, cracked housing.Tighten all pipe connections. Inspect and replace damaged O-rings or seals (e.g., lid O-ring). If housing is cracked, pump replacement may be necessary.
Pump loses prime.Air leak in suction line, low water level, clogged basket.Check and seal all suction line connections. Ensure pool water level is above skimmer. Clean debris basket.

Specifications

Detailed technical specifications for the XtremepowerUS 3/4HP Above-Ground Swimming Pool Pump.

FeatureDetail
BrandXtremepowerUS
Model Number75117-V
Horsepower3/4 HP
Power SourceCorded Electric
Voltage115 Volts
Frequency60 Hz
Amperage2.8 Amp
Rotations Per Minute (RPM)Up to 3,450 RPM
Maximum Flow Rate2400 Gallons Per Hour (40 Gallons Per Minute)
Maximum Lifting Height32 Feet
Inlet/Outlet Connection1.5 inch NPT Female Union / 1.5 inch Slip Union
MaterialSteel, Metal, ABS Plastic
Product Dimensions (L x W x H)16.25"L x 6"W x 8.5"H
Item Weight11 Pounds
CertificationsETL, UL Certified
Dimensions of the XtremepowerUS pool pump

Image: The XtremepowerUS pool pump with overlaid dimensions, indicating its length (17 inches), width (6.5 inches), and height (9 inches).

Warranty and Support

For warranty information and technical support, please contact XtremepowerUS directly. Keep your purchase receipt and product model number (75117-V) handy when contacting support.

While specific warranty details are not provided here, XtremepowerUS offers various protection plans for extended coverage. For details on available protection plans, please refer to the product's purchase page or contact the seller.

You can visit the official XtremepowerUS store for more information: XtremepowerUS Store

© 2024 XtremepowerUS. All rights reserved.

This manual is for informational purposes only. Always follow safety guidelines and local regulations.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.