NKF NB887UD

NKF NB887UD Replacement Remote Control Instruction Manual

For Magnavox DVD and VCR Models: MDR161V, RZV427MG9, ZV427MG9

1. Introduction

This manual provides instructions for the NKF NB887UD replacement infrared (IR) remote control. This remote is designed to operate various Magnavox DVD and VCR recorder models without the need for programming or pairing. Simply install batteries, and the remote is ready for use.

Compatible Magnavox Models:

  • MDR161V
  • MDR161V/F7
  • NB887UH
  • RZV427MG9
  • RZV427MG9A
  • ZV427MG9
  • ZV427MG9A
  • ZV427MG9B

2. Setup

2.1 Battery Installation

The remote control requires two (2) AAA alkaline batteries (not included) for operation. Follow these steps to install the batteries:

  1. Locate the battery compartment on the back of the remote control.
  2. Press down on the latch and slide the battery cover downwards to open it.
  3. Insert two new AAA batteries, ensuring the positive (+) and negative (-) terminals match the diagrams inside the compartment.
  4. Slide the battery cover back into place until it clicks securely.
Back of the NB887UD remote control with the battery compartment open, showing where to insert two AAA batteries.

Image 2.1: Back view of the NB887UD remote control with the battery compartment open, illustrating the correct orientation for AAA battery insertion.

2.2 Initial Use

This replacement remote control is pre-programmed for the listed Magnavox models. No additional programming or pairing is required. Once batteries are installed, the remote is ready for immediate use.

3. Operating Instructions

Point the remote control directly at the infrared sensor on your Magnavox DVD/VCR unit. Ensure there are no obstructions between the remote and the unit.

Front view of the NB887UD remote control, showing all buttons and their labels.

Image 3.1: Front view of the NB887UD remote control, displaying the layout of all control buttons.

3.1 Basic Functions

  • STANDBY-ON (Power): Turns the DVD/VCR unit on or off.
  • OPEN/CLOSE: Opens or closes the disc tray.
  • Number Buttons (0-9): Used for direct track/chapter selection or inputting numbers.
  • TOP MENU / TITLE: Accesses the main menu or title menu of a DVD.
  • POP/DISC MENU: Accesses the pop-up menu or disc menu.
  • Directional Arrows (Up, Down, Left, Right) & OK/ENTER: Navigates menus and confirms selections.
  • RETURN: Returns to the previous menu or screen.
  • DVD / VCR: Switches between DVD and VCR modes.
  • PLAY (►): Starts playback.
  • PAUSE (∥∥): Pauses playback.
  • STOP (■): Stops playback.
  • REWIND (◀◀) / FAST FORWARD (►►): Rewinds or fast forwards playback.
  • SKIP BACK (◀|) / SKIP FORWARD (|►): Skips to the previous or next track/chapter.
  • REC (●): Initiates recording (VCR mode).
  • SOURCE: Selects input source.
  • SUBTITLE: Toggles subtitle display.
  • SETUP: Accesses the system setup menu.

Note: Not all buttons may be functional with every compatible Magnavox model, depending on the original unit's features.

4. Maintenance

4.1 Cleaning

To clean the remote control, use a soft, dry cloth. For stubborn dirt, lightly dampen the cloth with water or a mild cleaning solution. Do not use abrasive cleaners, alcohol, or solvents, as these can damage the remote's surface or internal components.

4.2 Battery Replacement

Replace batteries when the remote's response becomes sluggish or stops working. Always replace both batteries at the same time with new AAA alkaline batteries. Do not mix old and new batteries, or different types of batteries, as this can lead to leakage or malfunction.

4.3 Storage

If the remote control will not be used for an extended period, remove the batteries to prevent potential leakage and damage to the remote.

5. Troubleshooting

  • Remote not responding:
    • Check if the batteries are correctly installed with the correct polarity (+/-).
    • Replace old batteries with new AAA alkaline batteries.
    • Ensure there are no obstructions between the remote control and the DVD/VCR unit's infrared sensor.
    • Make sure you are within the effective operating range (approximately 10 meters) and pointing the remote directly at the unit.
  • Certain buttons not working:
    • Verify that the function you are trying to use is supported by your specific Magnavox DVD/VCR model. Some advanced functions may not be present on all units.
    • Ensure the remote is in the correct mode (e.g., DVD or VCR) if applicable.

6. Specifications

FeatureSpecification
BrandNKF
Model NameNB887UD
Connectivity TechnologyInfrared (IR)
Compatible DevicesMagnavox DVD/VCR (MDR161V, RZV427MG9, ZV427MG9 series)
Power Source2 x AAA Batteries (not included)
Maximum Range10 Meters (approx. 33 feet)
Number of Buttons63
Dimensions (L x W x H)7.8" x 2" x 0.72" (approx.)
Item Weight2.79 Ounces (approx.)

7. Support

If you have any questions or encounter issues not covered in this manual, please contact the seller for assistance. Provide your product model number (NB887UD) and a detailed description of the issue for faster support.

© 2026 NKF. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.