LKPower AC Power Adapter Instruction Manual

Introduction

This manual provides essential information for the safe and effective use of your LKPower AC Power Adapter. This adapter is designed to provide reliable power to compatible ZMODO Wireless Security IP Cameras.

Safety Information

• Use only with compatible devices.
• Do not expose to water or excessive moisture.
• Do not disassemble or attempt to repair the adapter.
• Ensure proper ventilation; do not cover the adapter during use.
• Keep out of reach of children.
• Unplug from the power outlet when not in use for extended periods.

Package Contents

• 1 x LKPower AC Power Adapter

Setup Instructions

1. Inspect the Adapter: Before use, visually inspect the AC power adapter for any signs of damage to the casing or cable.
2. Connect to Device: Plug the DC output connector of the adapter into the power input port of your compatible ZMODO ZP-KB1I04-W or ZP-IBI13-W Wireless Security IP Camera.
3. Connect to Power Outlet: Insert the AC input prongs of the adapter into a standard AC 100-240V 50/61Hz electrical wall outlet.
4. Verify Power: Once connected, your camera should receive power and begin its normal operation.

Operating Instructions

The LKPower AC Power Adapter is designed for continuous operation. Once connected, it will supply the necessary DC power to your compatible device.

• Power On/Off: The adapter does not have a separate power switch. Power is supplied when plugged into an active outlet and connected to the device. To power off, disconnect from the wall outlet.
• Compatibility: This adapter is specifically designed for ZMODO ZP-KB1I04-W and ZP-IBI13-W Wireless Security IP Cameras. Using it with incompatible devices may cause damage.

Maintenance

• Cleaning: Disconnect the adapter from both the power outlet and the device before cleaning. Use a soft, dry cloth to wipe the surface. Do not use liquid cleaners.
• Storage: When not in use, store the adapter in a cool, dry place, away from direct sunlight and extreme temperatures. Avoid wrapping the cable too tightly.

Troubleshooting

No Power to Device

• Check Connections: Ensure the adapter is securely plugged into both the wall outlet and the camera.
• Verify Outlet: Test the wall outlet with another device to confirm it is functional.
• Inspect Cable: Check the adapter's cable for any visible damage or kinks. If damaged, discontinue use.
• Device Compatibility: Confirm that your camera model is listed as compatible with this adapter.

Adapter Overheating

• Ventilation: Ensure the adapter is not covered and has adequate airflow around it.
• Load: Confirm the connected device is compatible and not drawing excessive power. If overheating persists, discontinue use and contact support.

Specifications

Warranty and Support

For warranty information or technical support, please refer to the documentation provided with your purchase or contact your retailer.

For general inquiries about LKPower products, visit the official LKPower website.