Important Safety Information
Read all instructions before assembling or operating this appliance. Failure to follow these instructions could result in property damage, bodily injury, or death.
- For outdoor use only. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
- If the table falls over accidentally, the automatic air cutoff device will automatically cut off the gas transmission, enhancing safety.
- Keep children and pets away from the fire pit.
- Ensure proper ventilation. Do not obstruct the flow of combustion and ventilation air.
- This fire pit is CSA certified, ensuring compliance with safety standards.
- Always turn off the gas supply at the cylinder when the appliance is not in use.
Package Contents
Verify that all components are present before assembly.
- Fire Pit Table Unit
- Lid for Fire Pit
- Blue Fire Glass (approximately 11 lbs)
- Hardware Accessories
- Instruction Manual

Image: Key components including the burner, igniter, and fire glass.
Assembly Instructions
Assembly requires minimal installation. All necessary hardware and detailed instructions are included. It is recommended to have two people for assembly to ensure stability and ease of handling.
- Unpack all components and place them on a soft, clean surface to prevent scratches.
- Follow the step-by-step diagrams provided in the included instruction manual for attaching the base to the tabletop.
- Secure all connections firmly using the provided hardware.
- Place the blue fire glass into the burner pan.
- Connect the propane tank (not included) to the pre-installed line hose. Ensure the connection is tight and check for leaks using a soapy water solution.

Image: Fully assembled fire pit table with the lid detached.
Operating Instructions
Follow these steps for safe operation of your gas fire pit table.
- Ensure the propane tank is securely connected and the gas valve on the tank is open.
- Locate the ignition control knob on the side of the fire pit table.
- Push and hold the ignition control knob in, then turn it to the 'LOW' position.
- While holding the knob, press the igniter button repeatedly until the burner ignites. You may need to hold the knob for 10-15 seconds after ignition to allow the thermocouple to heat up.
- Once lit, release the knob. You can adjust the flame height by turning the control knob between 'LOW' and 'HIGH'.
- To turn off the fire pit, turn the control knob to the 'OFF' position and close the gas valve on the propane tank.

Image: Details of the ignition control and lid.
Maintenance
Proper maintenance ensures longevity and safe operation of your fire pit table.
- Cleaning: The fire pit table is easy to clean. Use a soft cloth with mild soap and water to wipe down surfaces. Avoid abrasive cleaners.
- Storage: When not in use, especially during inclement weather or off-season, it is recommended to cover the fire pit table to protect it from elements.
- Inspection: Regularly inspect the gas hose and connections for any signs of wear, damage, or leaks.
- No special maintenance is typically needed beyond routine cleaning and inspection.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Burner does not ignite | Gas valve closed, low propane, igniter issue, air in line | Open gas valve, check propane level, check igniter battery, purge air from line by attempting ignition several times. |
| Low flame or inconsistent flame | Low propane, partially closed valve, regulator issue | Check propane level, ensure all valves are fully open, consult manufacturer if regulator is suspected. |
| Gas odor detected | Gas leak | Immediately turn off gas supply. Check all connections for leaks using soapy water. Do not operate if leak persists. Contact qualified service personnel. |
Specifications
- Product Dimensions: 28"D x 28"W x 25"H
- Material: Iron
- Heat Output: 50,000 BTU
- Fuel Type: Liquefied Petroleum Gas (Propane)
- Item Weight: Approximately 50 Pounds
- Shape: Square
- Finish Type: Painted
- Color: Black
- Certification: CSA Certified

Image: Product dimensions diagram.
Warranty and Support
For warranty information or customer support, please refer to the contact details provided in your product packaging or visit the official PHI VILLA website. The manufacturer, PHI VILLA, is committed to providing assistance for product-related inquiries.
You can also visit the PHI VILLA Store on Amazon for additional product information and support resources.







