1. Introduction
The Garmin Striker Vivid 5cv is a 5-inch color fishfinder designed to assist in locating fish and underwater structures. This device incorporates high-contrast color palettes for enhanced visibility and supports Garmin CHIRP traditional sonar and CHIRP ClearVü scanning sonar. It features high-sensitivity GPS for waypoint marking, route planning, and speed display. Additionally, it includes Quickdraw Contours software for creating and saving custom maps with 1-foot contours.
Figure 1.1: Garmin Striker Vivid 5cv fishfinder displaying navigation and sonar data.
2. What's in the Box
Verify that all components are present before beginning installation:
- STRIKER Vivid 5cv fishfinder unit
- GT20-TM transducer
- Power/data cable
- Tilt/swivel mount
- Hardware for mounting
- Garmin bumper sticker (informational item)
- Documentation (this manual and other guides)
Figure 2.1: The Striker Vivid 5cv includes the fishfinder, transducer, cables, and mounting hardware.
3. Setup and Installation
3.1 Mounting the Device
The STRIKER Vivid 5cv unit can be mounted using the included tilt/swivel mount. Select a location that provides clear visibility and easy access to controls, ensuring it is secure and stable. The mount allows for adjustment of the viewing angle.
Figure 3.1: Side profile of the Striker Vivid 5cv on its adjustable mount.
3.2 Transducer Installation
The GT20-TM transducer is designed for transom or trolling motor mounting. Follow the specific instructions provided in the transducer installation guide for optimal performance. Ensure the transducer is positioned correctly to avoid interference and achieve accurate sonar readings.
3.3 Power and Data Connection
Connect the power/data cable to the corresponding ports on the back of the STRIKER Vivid 5cv unit. Ensure a secure connection to a 12V DC power source. The power/data cable also facilitates communication between the unit and other compatible devices if applicable.
Figure 3.2: Rear view of the unit showing transducer (XDCR) and power ports.
4. Operating Instructions
4.1 Powering On/Off
To power on the device, press and hold the power button until the screen illuminates. To power off, press and hold the power button again until the shutdown prompt appears, then confirm.
4.2 Sonar Functionality
The STRIKER Vivid 5cv supports two primary sonar types:
- Garmin CHIRP Traditional Sonar: Provides clear target separation and definition.
- CHIRP ClearVü Scanning Sonar: Offers a photographic view of fish and structure below the boat.
Navigate through the sonar views using the unit's buttons to select your preferred display. Adjust gain, range, and frequency settings as needed for optimal performance in varying water conditions.
Figure 4.1: Split-screen view of traditional and ClearVü sonar.
Figure 4.2: Detailed ClearVü sonar display showing submerged objects.
Figure 4.3: Example of a vivid color palette on the ClearVü sonar display.
Figure 4.4: The device offers 7 new vivid color options for sonar display.
4.3 GPS and Navigation
The integrated high-sensitivity GPS allows you to:
- Mark Waypoints: Save specific locations (e.g., fishing spots, hazards) for future reference.
- Create Routes: Plan navigation paths between multiple waypoints.
- View Boat Speed: Monitor your vessel's speed directly on the display.
Figure 4.5: Waypoint marking helps in revisiting productive fishing areas.
Figure 4.6: High-sensitivity GPS enables accurate navigation and speed tracking.
4.4 Quickdraw Contours
The built-in Quickdraw Contours software allows you to create personalized fishing maps with 1-foot contours as you navigate. These maps can be saved and are useful for identifying changes in depth and bottom structure.
Figure 4.7: Quickdraw Contours map showing detailed depth information.
5. Maintenance
5.1 Cleaning the Unit
Clean the device screen and exterior with a soft, damp cloth. Avoid using abrasive cleaners or solvents, as these can damage the display and casing. For stubborn dirt, a mild soap solution can be used, followed by rinsing with fresh water and drying.
5.2 Transducer Care
Regularly inspect the transducer for marine growth or damage. Clean the transducer face with a soft cloth and mild soap. Ensure no debris obstructs the transducer's signal. If the transducer is mounted on a trolling motor, check for proper alignment.
5.3 Storage
When storing the device for extended periods, disconnect it from power and store it in a dry environment, away from extreme temperatures. Protect the screen from scratches. If storing the boat, ensure the transducer is not exposed to freezing temperatures if water is present.
6. Troubleshooting
This section addresses common issues you might encounter with your Garmin Striker Vivid 5cv.
| Issue | Possible Cause | Solution |
|---|---|---|
| Unit does not power on | No power, faulty cable, blown fuse | Check power connections, inspect cable for damage, verify fuse in power line. |
| No sonar reading or erratic readings | Transducer not connected, obstructed, or damaged; air bubbles under transducer | Ensure transducer is securely connected. Clean transducer face. Reposition transducer to avoid air bubbles. Check for transducer damage. |
| GPS signal lost or inaccurate | Obstruction to sky view, unit interference, software issue | Move to an open area with clear sky view. Ensure no other electronics are causing interference. Perform a software update if available. |
| Screen difficult to read in sunlight | Direct sunlight, incorrect backlight setting | Adjust the tilt/swivel mount to minimize glare. Increase backlight brightness in display settings. |
7. Specifications
| Feature | Detail |
|---|---|
| Brand | Garmin |
| Model Name | Striker Vivid 5cv |
| Item Model Number | 010-02551-00 |
| Screen Size | 5 Inches |
| Display Type | LCD |
| Product Dimensions | 5"L x 7.4"W x 2.1"H |
| Item Weight | 3.8 Pounds |
| Power Source | Corded Electric (12V DC) |
| Mounting Type | Panel Mount (Tilt/Swivel) |
| Sonar Support | Garmin CHIRP Traditional, CHIRP ClearVü |
| GPS Features | High-sensitivity GPS, Waypoint Marking, Route Planning, Speed Display |
| Mapping | Quickdraw Contours (1-foot contours) |
| Connectivity | Wi-Fi (for ActiveCaptain app) |
| Color | Black |
8. Warranty and Support
This Garmin product is backed by a limited warranty. For specific warranty terms and conditions, please refer to the warranty information included with your product or visit the official Garmin website. For technical assistance, product registration, or to download the latest software updates, please visit garmin.com/support.
