Anton/Bauer VM2 Dual V-Mount Battery Charger Instruction Manual

Introduction

The Anton/Bauer VM2 Dual V-Mount Battery Charger is a lightweight and portable solution designed for simultaneously charging two V-Mount batteries while also providing power to camera accessories. This intelligent charger features an XLR4 output for converting AC to DC power or delivering battery power to compatible devices. Its compact design makes it ideal for transport and use in various production environments.

Figure 1: Front view of the Anton/Bauer VM2 Dual V-Mount Battery Charger.

Setup

Follow these steps to set up your VM2 Dual V-Mount Battery Charger:

1. Unpack the Charger: Carefully remove the VM2 charger from its packaging.
2. Connect to AC Power: Locate the AC input port on the side of the charger. Connect the provided power cable to the charger and then to a standard AC power outlet (100-240V).
3. Activate Power: Flip the 'ON/OFF' switch to the 'ON' position. The charger is now ready for operation.
4. Deploy Support Stand: For stable placement, extend the integrated support stand located at the bottom of the charger.

Figure 2: Rear view of the charger showing the AC input and power switch.

Operating

The VM2 charger offers intelligent charging and power delivery capabilities:

• Battery Charging: Attach up to two V-Mount batteries to the V-Mount plates on the charger. The charger will automatically begin intelligent charging. For example, an Anton/Bauer GO 90 (98Wh 8A) battery typically charges in approximately 3 hours.
• Simultaneous Charging: The VM2 is designed to charge both batteries concurrently, optimizing your workflow.
• DC Power Output: The XLR4 DC output (16.7VDC 4.5A) can be used to power devices that accept an XLR input, either directly from AC power when the charger is plugged in, or by drawing power from attached batteries.
• Charging Indicators: Observe the indicator lights on the front panel to monitor the charging status of each battery.

Figure 3: The VM2 charger with two V-Mount batteries attached for simultaneous charging.

Figure 4: The VM2 charger demonstrating the XLR4 DC output connection.

Maintenance

To ensure the longevity and optimal performance of your Anton/Bauer VM2 charger, consider the following maintenance guidelines:

• Cleaning: Regularly wipe the exterior of the charger with a soft, dry cloth. Avoid using abrasive cleaners or solvents.
• Ventilation: Ensure the built-in fan and ventilation openings are clear of obstructions to allow for proper cooling during operation.
• Storage: When not in use, store the charger in a cool, dry place away from direct sunlight and extreme temperatures.
• Cable Care: Inspect power cables and connectors periodically for any signs of wear or damage. Replace if necessary.

Troubleshooting

The VM2 charger incorporates advanced safety features to protect your batteries and devices. If you encounter an issue, consider the following:

• Charging Stops Automatically: The intelligent safety technology in the VM2 will automatically stop charging if a fault is detected or if an attached battery reaches an overvoltage condition. Check the battery for issues or try a different battery.
• No Power/Indicators Off: Ensure the charger is securely plugged into a working AC outlet and the 'ON/OFF' switch is in the 'ON' position. Check the power cable for damage.
• Overheating: The built-in fan helps maintain optimal operating temperature. Ensure ventilation openings are not blocked. If the charger feels excessively hot, disconnect it and allow it to cool down in a well-ventilated area.

For persistent issues not covered here, please refer to the support section.

Specifications

Warranty and Support

For information regarding warranty coverage, technical support, or service for your Anton/Bauer VM2 Dual V-Mount Battery Charger, please visit the official Anton/Bauer website or contact their customer service department. Keep your purchase receipt as proof of purchase for warranty claims.