Sylvac S_Cal EVO Basic Digital Caliper User Manual

Introduction

This manual provides essential information for the proper use, setup, operation, and maintenance of your Sylvac S_Cal EVO Basic Digital Caliper. This basic digital caliper is designed for precise dimensional measurements and does not feature data output capabilities.

Image: The Sylvac S_Cal EVO Basic Digital Caliper, displaying a measurement of 20.58 mm on its digital screen. The caliper features a main scale marked in millimeters and inches, with the Sylvac logo and "S_Cal EVO Basic" text visible on the beam. It also indicates an IP67 rating for protection against dust and water.

Setup

Battery Installation

The S_Cal EVO Basic requires a Lithium battery for operation. Ensure the battery is correctly inserted before first use.

1. Locate the battery compartment cover on the digital unit.
2. Carefully remove the cover.
3. Insert the Lithium battery, observing the correct polarity (+/-) as indicated inside the compartment.
4. Replace the battery compartment cover securely.

Initial Power On and Zero Setting

After battery installation, the caliper should power on. If not, press the 'ON' button (if present, otherwise it might be automatic). To ensure accurate measurements, always zero the caliper before use.

1. Close the jaws completely, ensuring they are clean and free of debris.
2. Press the 'ZERO' button (or 'SET' button, as indicated on the device) to set the display to 0.00 mm (or 0.000 inch).
3. The caliper is now ready for measurement.

Operating Instructions

Measuring External Dimensions

Use the outside jaws to measure external dimensions of an object.

1. Open the outside jaws wider than the object to be measured.
2. Place the object between the jaws.
3. Gently close the jaws until they make firm contact with the object. Do not apply excessive force.
4. Read the measurement displayed on the digital screen.

Measuring Internal Dimensions

Use the inside jaws to measure internal dimensions, such as bore diameters.

1. Insert the inside jaws into the opening to be measured.
2. Open the jaws until they make firm contact with the internal surfaces.
3. Read the measurement displayed on the digital screen.

Measuring Depth

Use the depth rod to measure the depth of holes or steps.

1. Place the end of the main beam firmly on the surface from which the depth is to be measured.
2. Extend the depth rod into the hole or down to the step until it makes contact with the bottom surface.
3. Read the measurement displayed on the digital screen.

Measuring Steps

Use the step measuring faces to measure the height of steps.

1. Place the fixed jaw's step face on the higher surface.
2. Slide the movable jaw's step face down to the lower surface.
3. Read the measurement displayed on the digital screen.

Unit Conversion

If your model supports it, press the 'MODE' button to switch between millimeter (mm) and inch (in) units. The current unit will be indicated on the display.

Maintenance

Cleaning

Regular cleaning ensures the longevity and accuracy of your caliper.

• Wipe the caliper clean with a soft, lint-free cloth after each use.
• For stubborn dirt, use a cloth lightly dampened with isopropyl alcohol. Avoid harsh solvents.
• Ensure no liquid enters the electronic components.

Storage

Proper storage protects the caliper from damage and environmental factors.

• Store the caliper in its protective case when not in use.
• Keep it in a dry environment, away from direct sunlight, extreme temperatures, and corrosive substances.
• Slightly open the jaws before storing to relieve tension on the measuring faces.

Battery Replacement

Replace the battery when the display becomes dim or shows a low battery indicator. Refer to the "Battery Installation" section for replacement steps.

Troubleshooting

Specifications

Warranty and Support

For information regarding product warranty, please refer to the documentation provided with your purchase or visit the official Sylvac website. For technical support or service inquiries, please contact Sylvac customer service directly. Contact details are typically available on the manufacturer's website or product packaging.

Manufacturer: Sylvac SA