1. Introduction
Thank you for choosing the Beurer HD 75 Nordic Heated Throw. This luxurious faux fur heated throw is designed to provide soothing warmth and comfort. Please read this user manual carefully before first use and keep it for future reference. Following these instructions will ensure safe and optimal operation of your heated throw.
Image 1.1: The Beurer HD 75 Nordic Heated Throw, presented in its retail packaging, highlighting its design and features.
Image 1.2: A woman comfortably relaxing on a sofa, covered by the Beurer HD 75 Nordic Heated Throw, illustrating its use for personal warmth and relaxation.
2. Important Safety Instructions
Always observe the following safety instructions to prevent personal injury or damage to the appliance.
- Do not use the heated throw if it is wet or damp.
- Do not insert pins or other sharp objects into the heated throw.
- Do not use if folded or bunched up, as this can cause overheating.
- The heated throw is equipped with the Beurer Safety System (BSS) which automatically switches off the device in case of a fault.
- Automatic shut-off occurs after approximately 3 hours of continuous operation.
- Ensure the control unit is not covered or placed under the throw during use.
- This appliance is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
- Keep children away from the appliance.
Image 2.1: A couple enjoying the warmth of the Beurer HD 75 Nordic Heated Throw, emphasizing the product's safety features for worry-free use.
3. Setup
- Unpack the heated throw and check for any signs of damage.
- Lay the heated throw flat on a bed, sofa, or other suitable surface.
- Connect the control unit to the heated throw by inserting the plug firmly into the socket on the throw.
- Plug the power cord into a suitable electrical outlet.
4. Operating Instructions
The Beurer HD 75 Nordic Heated Throw features 6 temperature settings for personalized comfort.
Image 4.1: A detailed view of the Beurer HD 75 controller, showing the slider for selecting one of the six temperature levels and the power indicator light.
- Turning On: Slide the switch on the control unit from '0' to your desired temperature setting (1-6). The indicator light will illuminate.
- Temperature Settings:
- Setting 1: Minimum warmth
- Settings 2-5: Moderate warmth
- Setting 6: Maximum warmth
- Pre-heating: For faster heating, select setting 6 initially, then reduce to your preferred comfort level after 10-15 minutes.
- Automatic Shut-off: The heated throw will automatically switch off after approximately 3 hours. To reactivate, slide the switch to '0' and then back to your desired setting.
- Turning Off: Slide the switch on the control unit to '0'. The indicator light will turn off. Unplug the heated throw from the mains socket when not in use.
5. Maintenance and Cleaning
Proper care ensures the longevity and hygiene of your heated throw.
Image 5.1: An illustration showing the detachable controller and a washing machine icon, indicating that the Beurer HD 75 heated throw is machine washable after removing the control unit.
- Before Cleaning: Always unplug the heated throw from the mains and disconnect the control unit from the throw.
- Machine Washing: The heated throw is machine washable at 30°C (86°F) on a gentle cycle. Use a mild detergent.
- Hand Washing: If preferred, the throw can be hand washed in lukewarm water with a mild detergent.
- Drying: Do not wring or tumble dry. Gently reshape the throw and lay it flat or hang it over a line to air dry completely. Ensure it is fully dry before reconnecting the control unit and storing or using.
- Storage: When not in use, store the heated throw in a clean, dry place, preferably in its original packaging. Do not place heavy objects on top of it.
6. Troubleshooting
If your Beurer HD 75 Nordic Heated Throw is not functioning as expected, please refer to the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Heated throw does not turn on. | Not plugged in correctly, control unit not connected, or power outage. | Check power plug and control unit connection. Verify power supply. |
| Heated throw turns off automatically. | Automatic shut-off activated (after 3 hours) or Beurer Safety System (BSS) detected a fault. | If 3 hours have passed, turn off and on again. If BSS activated, unplug and contact customer support if issue persists. |
| Heated throw is not warm enough. | Temperature setting too low. | Increase the temperature setting on the control unit. Allow time for heating. |
If the problem persists after trying these solutions, please contact Beurer customer support.
7. Specifications
- Model: Beurer HD 75 Nordic
- Dimensions: Approximately 180 x 130 cm (70.8 x 51.1 inches)
- Material: Soft faux fur (microplush fabric)
- Color: Nordic (Beige/Brown)
- Temperature Settings: 6 levels
- Safety Features: Beurer Safety System (BSS), Automatic shut-off after approx. 3 hours
- Care: Machine washable at 30°C (86°F) (removable switch)
- Certification: Oeko-Tex Standard 100
Image 7.1: The Beurer HD 75 Nordic Heated Throw packaging, illustrating the product dimensions (130 x 180 cm) and highlighting the 3-year warranty.
Image 7.2: The Oeko-Tex Standard 100 certification label displayed on the Beurer HD 75 heated throw, confirming its compliance with human-ecological safety standards.
8. Warranty and Support
The Beurer HD 75 Nordic Heated Throw comes with a 3-year warranty from the date of purchase, covering manufacturing defects.
For warranty claims, technical support, or any questions regarding your product, please contact Beurer customer service. You can find contact information on the official Beurer website or through your retailer.
Please have your proof of purchase and the product model number (HD 75) ready when contacting support.
