Bissell PowerGlide Slim Corded Vacuum 3070 Instruction Manual

Introduction

The BISSELL PowerGlide Slim Corded Vacuum 3070 is a versatile 3-in-1 cleaning solution designed for powerful pet hair pickup on various surfaces. Its lightweight design, Tangle-Free Brush Roll, and specialized tools make it an efficient choice for maintaining a clean home. This manual provides essential information for assembly, operation, maintenance, and troubleshooting to ensure optimal performance of your vacuum cleaner.

The Bissell PowerGlide Slim Corded Vacuum in action, demonstrating its lightweight and powerful suction on carpet.

What's in the Box

Upon unboxing your BISSELL PowerGlide Slim Corded Vacuum, you should find the following components:

• BISSELL PowerGlide Pet Slim Corded Vacuum Unit
• Dusting Brush
• Crevice Tool
• Wall Mount & Tool Storage Station
• Febreze Filter (pre-installed or separate)

Video: An unboxing and overview of the components included with the BISSELL PowerGlide Pet Slim Corded Vacuum.

Assembly

Follow these steps to assemble your BISSELL PowerGlide Slim Corded Vacuum:

1. Attach the Foot to the Extension Wand: Align the foot of the vacuum with the bottom of the extension wand and push until it clicks securely into place.
2. Attach the Handheld Vacuum to the Extension Wand: Align the handheld vacuum unit with the top of the extension wand and push until it clicks securely into place.
3. Attach Specialty Tools: The dusting brush and crevice tool can be attached directly to the handheld vacuum or the end of the extension wand for specialized cleaning tasks.
4. Install Wall Mount (Optional): Use the provided hardware to securely mount the tool storage station to a wall stud. Ensure it is at a convenient height and can support the vacuum and accessories.

The fully assembled Bissell PowerGlide Slim Corded Vacuum, ready for use.

Operating Instructions

Powering On/Off

• Plug the 27-foot power cord into a suitable electrical outlet.
• Press the power button located on the handle of the handheld unit to turn the vacuum on or off.

3-in-1 Capabilities

The PowerGlide Slim offers three versatile cleaning modes:

• Stick Vacuum Mode: Use the vacuum fully assembled for floor cleaning on carpets and hard floors. The swivel steering allows for easy maneuverability around furniture.
• Handheld Vacuum Mode: Detach the handheld unit from the extension wand to clean upholstery, stairs, car interiors, and other small areas.
• High-Reach Vacuum Mode: Attach a specialty tool (like the crevice tool or dusting brush) directly to the extension wand (without the foot) to reach high ceilings, corners, or under furniture.

Using the handheld vacuum mode to effectively clean upholstery.

Utilizing the high-reach mode with the extension wand for elevated cleaning.

Tangle-Free Brush Roll & Swivel Steering

• The patented Tangle-Free Brush Roll is designed to prevent hair wrap, making it ideal for pet owners.
• The swivel steering mechanism allows the vacuum head to pivot easily, enabling you to navigate around furniture and obstacles with minimal effort.

A close-up view of the Tangle-Free Brush Roll, designed to prevent hair from wrapping around it.

Video: Demonstrating the vacuum's powerful suction and maneuverability on various surfaces.

Maintenance

Emptying the Dirt Tank

The Easy Empty™ dirt tank should be emptied regularly to maintain optimal suction power.

1. Ensure the vacuum is unplugged and turned off.
2. Press the release button on the handheld unit to detach the dirt tank.
3. Hold the dirt tank over a trash bin and press the bottom release button to open the flap and empty contents.
4. Close the flap and reattach the dirt tank to the handheld unit until it clicks.

The Easy Empty™ dirt tank being emptied into a waste bin.

Cleaning the Filter

The washable filter should be cleaned monthly or as needed to ensure efficient operation.

1. Remove the dirt tank as described above.
2. Twist the filter assembly to unlock and remove it from the dirt tank.
3. Separate the mesh filter from the foam filter.
4. Rinse both filters under warm water until clean. Allow them to air dry completely for at least 24 hours before reassembling.
5. Reassemble the filters and place them back into the dirt tank, then reattach the dirt tank to the vacuum.

The washable filter component of the vacuum, ready for cleaning.

Brush Roll Maintenance

The Tangle-Free Brush Roll minimizes hair wrap, but occasional inspection and cleaning may be necessary.

• Ensure the vacuum is unplugged.
• Inspect the brush roll for any debris or tangled hair. The brush roll cover can be opened for easier access if needed.
• Remove any obstructions using scissors or your fingers.

Video: A short demonstration of the vacuum's brush roll and its functionality.

Troubleshooting

If your vacuum is not performing as expected, refer to the following common issues and solutions:

• No Suction or Low Suction: Check if the dirt tank is full and empty it. Ensure the filter is clean and properly installed. Check for blockages in the hose, foot, or extension wand.
• Vacuum Will Not Turn On: Ensure the power cord is securely plugged into a working outlet. Check the power button on the handheld unit.
• Brush Roll Not Rotating: Unplug the vacuum and check the brush roll for any obstructions. Ensure the foot is properly attached.
• Hair Wrapped Around Brush Roll: The Tangle-Free Brush Roll is designed to minimize this, but if it occurs, unplug the vacuum and carefully remove any wrapped hair.

Video: A user's experience with a potential issue after several months of use, which may offer insights for troubleshooting.

Specifications

Support & Warranty

For additional support, troubleshooting tips, or warranty information, please visit the official BISSELL website or contact their customer service.

BISSELL proudly supports the BISSELL Pet Foundation and its mission to help save homeless pets. Your purchase contributes to this cause.

BISSELL's commitment to pet welfare through the BISSELL Pet Foundation.