1. Introduction
This manual provides essential information for the safe and efficient operation of your AKAI AQUA88K-M front-load washing machine. Please read these instructions carefully before installation and use, and keep them for future reference. This appliance is designed for domestic use only.
Figure 1: Front view of the AKAI AQUA88K-M washing machine. This image displays the appliance's overall design, including the control panel, detergent drawer, and main door.
2. Safety Information
To prevent personal injury or damage to the appliance, always observe the following safety precautions:
- Ensure the appliance is properly grounded before use.
- Do not allow children to play with or operate the washing machine.
- Never force the door open during operation.
- Unplug the appliance from the power supply before cleaning or maintenance.
- Do not wash items that have been soiled with flammable substances.
- Keep pets away from the appliance.
3. Setup and Installation
3.1 Unpacking
Carefully remove all packaging materials, including the transport bolts located at the rear of the machine. Retain these bolts for future transport if needed.
3.2 Location and Leveling
Place the washing machine on a firm, level surface. Adjust the adjustable feet at the bottom of the machine until it is perfectly level and stable. This prevents excessive vibration and noise during operation.
3.3 Water Connection
Connect the water inlet hose to a cold water tap with a 3/4-inch thread. Ensure all connections are tight to prevent leaks. The appliance requires a water pressure between 0.1 MPa and 1 MPa.
3.4 Drainage
Position the drain hose into a standpipe or over the edge of a sink, ensuring it is securely fastened to prevent displacement during the drain cycle. The drain hose should be between 60 cm and 100 cm from the floor.
3.5 Electrical Connection
Connect the power cord to a grounded electrical outlet. The appliance operates on 220-240V/50Hz. The power cable length is 1.5 meters. Do not use extension cords or adapters.
4. Operating Instructions
4.1 Control Panel Overview
The control panel features a program selector knob, LED indicators for cycle status, and buttons for functions like Start/Pause and Child Lock.
4.2 Loading Laundry
Open the washing machine door and load laundry into the drum. Do not exceed the maximum capacity of 8.0 kg. Ensure items are evenly distributed.
Figure 2: The AKAI AQUA88K-M washing machine with its door open, illustrating the drum access for loading and unloading laundry. The drum diameter is 30 cm.
4.3 Adding Detergent
Add the appropriate amount of detergent and fabric softener to the designated compartments in the detergent drawer. Refer to your detergent packaging for dosage recommendations.
4.4 Program Selection
Turn the program selector knob to choose one of the 16 available washing programs. The LED indicators will display the selected program and cycle status.
4.5 Starting a Cycle
Press the "Start/Pause" button to begin the selected washing cycle. The machine will automatically proceed through the wash, rinse, and spin phases.
4.6 Special Functions
- Child Lock: Activate this feature to prevent accidental changes to settings during a cycle. Refer to the control panel for specific activation instructions (usually a combination of buttons).
- Play & Pause: Use this button to temporarily pause a running cycle, for example, to add forgotten items. Press again to resume.
5. Maintenance
Regular maintenance ensures optimal performance and extends the lifespan of your washing machine.
5.1 Cleaning the Detergent Dispenser
Periodically remove and clean the detergent dispenser drawer to prevent residue buildup. Rinse it under running water and dry thoroughly before reinserting.
5.2 Cleaning the Drum
Run a maintenance wash cycle (e.g., a hot wash with no laundry and a descaling agent) regularly to clean the drum and remove any odors or residue.
5.3 Cleaning the Pump Filter
Locate the pump filter (usually at the bottom front of the machine). Open the cover, drain any residual water, and carefully remove and clean the filter of lint and debris. Reinstall securely. Perform this every few months or if drainage issues occur.
5.4 Exterior Cleaning
Wipe the exterior surfaces of the washing machine with a soft, damp cloth. Do not use abrasive cleaners or solvents.
6. Troubleshooting
Before contacting customer service, refer to the following table for common issues and their solutions.
| Problem | Possible Cause | Solution |
|---|---|---|
| Machine does not start | Power cord unplugged, door not closed properly, program not selected, Start/Pause button not pressed. | Check power connection, ensure door is latched, select a program, press Start/Pause. |
| Water not filling | Water tap closed, inlet hose kinked, water pressure too low. | Open water tap, straighten hose, check water supply. |
| Water not draining | Drain hose kinked or blocked, pump filter clogged. | Straighten drain hose, clean pump filter (see Section 5.3). |
| Excessive vibration/noise | Machine not level, transport bolts not removed, uneven load. | Adjust leveling feet, remove transport bolts, redistribute laundry. |
| Child Lock activated | Control panel is locked. | Deactivate Child Lock as per control panel instructions. |
7. Technical Specifications
| Model Number | AQUA88K-M |
| Brand | AKAI |
| Capacity | 8.0 kg |
| Power Supply | 220-240V / 50Hz |
| Rated Power | 2.05 kW |
| Maximum Spin Speed | 1400 RPM |
| Motor Type | Inverter Motor |
| Noise Level (Washing) | 54 dB |
| Noise Level (Spinning) | 76 dB |
| Annual Energy Consumption | 176 kWh |
| Annual Water Consumption | 11000 Liters |
| Drum Diameter | 30 cm |
| Number of Programs | 16 |
| Display Type | LED |
| Product Dimensions (W x D x H) | 59.5 x 56.5 x 85 cm |
| Product Weight | 72 kg |
| Power Cable Length | 1.5 m |
8. Warranty and Support
For warranty information and customer support, please refer to the warranty card included with your purchase or contact your retailer. Keep your proof of purchase for any warranty claims.
