Introduction
Thank you for choosing the Lepro Remote Controller for your Tunable White LED Strip Light. This manual provides detailed instructions for setting up, operating, and maintaining your remote control to ensure optimal performance and longevity. Please read this manual thoroughly before use and retain it for future reference.
Product Overview
The Lepro Remote Controller is designed to provide convenient control over your tunable white LED strip lights, allowing you to adjust brightness, color temperature, and activate various lighting modes.
Image: Front view of the Lepro Remote Controller.
Remote Control Button Functions
Image: Diagram illustrating the functions of each button on the Lepro Remote Controller.
- ON/OFF Buttons: Power on or off the LED strip light.
- 60S OFF Button: Activates a 60-second auto-off timer.
- Brightness +/- Buttons: Adjust the brightness level of the light.
- WW (Warm White) Button: Sets the light to a warm white color temperature.
- NW (Neutral White) Button: Sets the light to a neutral white color temperature.
- DW (Daylight White) Button: Sets the light to a daylight white (cool white) color temperature.
- Colour Temperature +/- Buttons: Fine-tune the color temperature between warm and cool white.
- MODE Button: Cycles through fast/slow flash modes.
- Scene Buttons (Morning/Evening/Night): Activates pre-set lighting scenes.
Setup
Battery Installation
The remote controller requires 1 Lithium Metal battery (included). Before first use, please remove the insulation sheet from the battery compartment.
Image: Illustration showing how to remove the insulation sheet from the battery compartment.
- Locate the battery compartment on the back of the remote control.
- Pull out the plastic insulation sheet if it is present.
- If replacing the battery, open the battery cover and insert the new battery, ensuring correct polarity (+/-).
- Close the battery cover securely.
Pairing (If Applicable)
This remote control uses Radio Frequency (RF) technology and is typically pre-paired with compatible Lepro tunable white LED strip lights (e.g., models 410098, 410049). If your remote does not respond to the light strip, ensure the light strip is powered on and within the maximum range of 10 meters. No manual pairing procedure is usually required for this model.
Operating Instructions
Once the battery is installed, you can begin controlling your LED strip light.
- Power On/Off: Press the ON button to turn the light on, and the OFF button to turn it off.
- Brightness Adjustment: Use the Brightness +/- buttons (sun icon with up/down arrows) to increase or decrease the light intensity.
- Color Temperature Selection:
- Press WW for Warm White.
- Press NW for Neutral White.
- Press DW for Daylight White (Cool White).
Image: Visual representation of Warm White, Natural White, and Cool White color temperatures.
- Fine-tuning Color Temperature: Use the Colour Temperature +/- buttons (yellow up/down arrows) to incrementally adjust the color temperature.
- Flash Modes: Press the MODE button to cycle through different fast/slow flash modes.
- Scene Modes: Select pre-set scenes using the dedicated buttons:
- Morning Scene: (Sunrise icon)
- Evening Scene: (Sunset icon)
- Night Scene: (Moon and stars icon)
- 60-Second Auto Off: Press the 60S OFF button to activate a timer that will turn off the light after 60 seconds.
Maintenance
Cleaning
To clean the remote controller, gently wipe it with a soft, dry cloth. Do not use abrasive cleaners, solvents, or immerse the remote in water.
Battery Replacement
If the remote control's range decreases or it becomes unresponsive, the battery may need to be replaced. Refer to the "Battery Installation" section under Setup for instructions.
Note: Dispose of used batteries responsibly according to local regulations.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Remote not responding to light strip. |
|
|
| Limited range of control. |
|
|
Specifications
- Model: 500014
- Brand: Lepro
- Product Dimensions: 8.5 x 4 x 0.7 cm
- Weight: 20 g
- Battery: 1 Lithium Metal battery (required)
- Connectivity Technology: Radio Frequency (RF)
- Maximum Range: 10 Metres
- Number of Buttons: 14
- Compatible Devices: Lepro LED Strip Light 410098, LED Strip Light 410049
Important Information
Light Bulb Recycling
For information on recycling this product and other types of lamps, please consult local recycling guidelines and facilities.
Light Bulb Breakage and Clean Up Information
In case of breakage or damage to associated light bulbs, follow proper clean-up and disposal procedures as recommended by local authorities. Avoid direct contact with broken glass or internal components.
Warranty and Support
For warranty information and customer support, please refer to the official Lepro website or contact your retailer. Keep your purchase receipt as proof of purchase.
For further assistance, you may visit the Lepro Store on Amazon.
