Introduction
This manual provides essential information for the assembly, operation, maintenance, and care of your Lexicon Home Theater Seating, Matteo Collection Reclining Sofa. Please read these instructions carefully before assembly and use to ensure safe and proper functioning of your product.
Image: The Lexicon Matteo Collection 3-Seat Reclining Sofa in two-tone brown, showcasing its design and three seating sections.
Safety Information
Adherence to the following safety guidelines is crucial for preventing injury and damage to the product.
- Fire Hazard: Keep the sofa away from naked flames or direct heat sources.
- Product Misuse: Do not allow horseplay on or under the sofa. Prohibit jumping on the sofa.
- Weight Limit: The sofa has a weight limit of 900 pounds. Do not exceed this capacity.
- Assembly: Ensure all components are correctly assembled and tightened before use.
- Moving: When moving the sofa, lift it rather than dragging to prevent damage to legs and frame.
Setup and Assembly
Your Lexicon Matteo Collection Reclining Sofa requires partial assembly. It ships in one box. It is recommended that two people perform the assembly.
Included Components:
- LSF (Left Side Facing) back rest
- RSF (Right Side Facing) back rest
- Middle back rest
- Seat base
Assembly Steps:
- Unpack all components from the box and lay them out on a clean, soft surface to prevent scratching.
- Identify the seat base.
- Align the metal brackets on the LSF back rest with the corresponding brackets on the left side of the seat base. Slide the back rest down firmly until it locks into place.
- Repeat the process for the RSF back rest on the right side of the seat base.
- Insert the middle back rest into its designated slot in the center of the seat base, ensuring it clicks securely.
- Verify that all back rests are securely attached and do not wobble.
- Ensure all assembly tools are used as provided. No additional tools should be required.
Image: Front view of the assembled Lexicon Matteo Collection Reclining Sofa, showing the three seat sections.
Operating Instructions
The Matteo Collection Reclining Sofa features manual reclining mechanisms and a convenient drop-down center console.
Manual Reclining Function:
- Locate the side-mounted tab on the outer arm of the left and right reclining seats.
- Pull the tab firmly towards you. This will release the footrest and allow the backrest to recline.
- Lean back gently to achieve your desired reclining position. The mechanism allows for two reclining positions.
- To return to the upright position, push down on the footrest with your legs while leaning forward. The backrest will follow. Ensure the footrest is fully closed before exiting the seat.
Image: The reclining sofa with both end seats in a reclined position, showing the extended footrests.
Center Drop-Down Console with Cup Holders:
- The middle seat's backrest can be folded down to reveal a console.
- Gently pull the top of the middle backrest forward and down.
- This action will transform the backrest into a flat tabletop surface with two integrated cup holders.
- To return the console to a seating position, lift the tabletop surface upwards until it locks back into place as a backrest.
Image: The reclining sofa with the center backrest folded down, revealing the integrated tabletop and cup holders.
Image: A close-up view of the two circular cup holders embedded in the center drop-down console.
Maintenance and Care
Proper care will extend the life and appearance of your sofa.
- Cleaning: For general cleaning, wipe clean with a dry cloth. For more thorough cleaning, use a soft brush or vacuum.
- Upholstery: The upholstery is made of two-tone brown faux leather. Refer to Upholstery Cleaning Code "X" for specific care instructions, which typically means professional cleaning is recommended or only vacuuming/brushing. Do not use water or solvent-based cleaners.
- Spills: Blot spills immediately with a clean, dry cloth. Do not rub.
- Sunlight: Avoid prolonged exposure to direct sunlight to prevent fading of the upholstery.
- Moving: When moving the sofa, lift it by the frame rather than pushing or pulling on the arms or backrests.
Image: A detailed view of the two-tone brown faux leather material used for the sofa's upholstery.
Troubleshooting
This section addresses common issues you might encounter with your reclining sofa.
| Problem | Possible Cause | Solution |
|---|---|---|
| Reclining mechanism is stiff or not engaging. | Mechanism may be obstructed or not fully lubricated. | Check for any obstructions around the mechanism. Ensure the pull tab is fully engaged. If new, the mechanism may require some use to loosen. |
| Backrest not locking into place after assembly. | Backrest not fully seated on the frame brackets. | Lift the backrest slightly and firmly push down until you hear a click, ensuring it is fully engaged with the seat base brackets. |
| Sofa wobbles or feels unstable. | Components not fully assembled or tightened. | Re-check all assembly points to ensure backrests are securely attached. Ensure the sofa is on a level surface. |
Specifications
Detailed specifications for the Lexicon Matteo Collection Reclining Sofa.
Image: A diagram illustrating the dimensions and key specifications of the Matteo Collection Sofa.
| Feature | Detail |
|---|---|
| Brand | Lexicon |
| Model Name | Matteo Collection Reclining Sofa |
| Product Dimensions (D x W x H) | 39"D x 85.5"W x 40"H |
| Item Weight | 187 Pounds |
| Weight Limit | 900 Pounds |
| Seating Capacity | 3 |
| Color | Two-tone Brown |
| Upholstery Fabric Type | Faux Leather (10% Polyurethane, 90% Polyester) |
| Frame Material Type | Pine Wood |
| Seat Fill Material | Foam, Pocketed Coil, Dacron |
| Back Fill Material | Foam, Synthetic Fiber |
| Reclining Seat Count | 2 (dual ends) |
| Reclining Position Count | 2 |
| Cup Holders | 2 (in center drop-down console) |
| Assembly Required | Yes (Partial Assembly) |
| Recommended People for Assembly | 2 |
| Minimum Required Door Width | 25 Inches |
| UPC | 194840080435 |
Image: A visual representation of the sofa's overall dimensions: 85.5 inches wide, 39 inches deep, and 40 inches high.
Warranty and Support
Your Lexicon Matteo Collection Reclining Sofa comes with a manufacturer's warranty and customer support options.
Warranty Information:
- Warranty Type: Limited
- Manufacturer Warranty: 1 Year (Parts, Labor)
For detailed warranty terms and conditions, please refer to the documentation included with your purchase or contact Lexicon customer service.
Customer Support:
For any questions, assistance with assembly, or to report issues, please contact Lexicon customer support. You can often find contact information on the manufacturer's website or through your retailer.
You may also visit the official Lexicon store page for more information: Lexicon Store
