1. Introduction
Thank you for purchasing the NutriChef Countertop Ice Maker Water Dispenser, Model PICEM75.6. This appliance is designed to provide convenient ice production and water dispensing for your home or office. Please read this manual thoroughly before operating the unit to ensure safe and efficient use. Keep this manual for future reference.
Key Features:
- 2-in-1 Ice Maker & Water Dispenser functionality.
- Produces ice in as little as 9 minutes.
- Daily ice production capacity of up to 33 lbs.
- Offers two selectable ice cube sizes: small and large.
- Equipped with a front panel button control center and LED digital display.
- Features an ultra-quiet operation.
- Includes an option for direct water line connection.
- Easy-to-clean and stain-resistant engineered ABS housing.
2. Important Safety Instructions
To reduce the risk of fire, electric shock, or injury when using your appliance, follow these basic precautions:
- Read all instructions before use.
- Connect to a properly grounded outlet only.
- Do not immerse cord, plug, or any part of the appliance in water or other liquids.
- Close supervision is necessary when any appliance is used by or near children.
- Unplug from outlet when not in use, before cleaning, or if a malfunction occurs.
- Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions or has been damaged in any manner.
- Do not use outdoors.
- Do not place on or near a hot gas or electric burner, or in a heated oven.
- Do not use the appliance for other than its intended use.
- Ensure proper ventilation for the appliance.
- Use only potable water.
- Keep the appliance away from heat sources and direct sunlight.
3. Setup and Installation
3.1 Unpacking the Unit
Carefully remove the ice maker from its packaging. Inspect the unit for any damage. Ensure all components listed in the "What's in the Box" section are present.

Figure 3.1: Contents of the box, including the ice maker, water tapping installation kit, and ice scoop.
3.2 Placement
Place the ice maker on a stable, level surface away from direct sunlight and heat sources. Ensure there is adequate ventilation around the unit, especially at the sides and back.
3.3 Water Supply Connection
The unit offers two methods for water supply:
- Manual Fill: Open the top lid and pour potable water directly into the 1.8L water reservoir.
- Direct Water Tapping: For continuous water supply, connect the provided water tapping installation kit to a water pipeline. Refer to the diagram below for proper connection. It is recommended to have this installed by a licensed plumber.

Figure 3.2: Illustration of manual water addition and the water supply pipe line connection points (A to water pipe, B to water faucet, C to unit).
4. Operating Instructions
4.1 Control Panel Overview
The front panel features easy-touch buttons and an LED digital display for controlling the unit and monitoring its status.

Figure 4.1: The control panel and key components of the ice maker.
4.2 Making Ice
- Ensure the water reservoir is filled (either manually or via direct connection).
- Press the ON/OFF button to start the ice making cycle.
- Select your desired ice cube size (Small or Large) using the corresponding buttons.
- The unit will begin producing ice, with the first batch ready in approximately 9 minutes.
- The LED display will indicate when ice making is in progress and when the ice tray is full.

Figure 4.2: Ice dispensing and selection of ice cube sizes.
4.3 Dispensing Water
To dispense water, place your cup under the water dispenser spout and press the WATER button. The unit will dispense water from the reservoir.
5. Maintenance
Regular cleaning and maintenance will ensure the longevity and optimal performance of your ice maker.
5.1 Cleaning the Unit
- Unplug the appliance before cleaning.
- Clean the interior components, including the water reservoir and ice storage area, with a mild detergent and warm water. Rinse thoroughly.
- The exterior housing is stain-resistant and can be wiped clean with a soft, damp cloth.
- Regularly empty and clean the water drip tray.
5.2 Descaling
Over time, mineral deposits may accumulate. To descale the unit, use a solution of water and vinegar or a commercial descaling agent designed for ice makers. Follow the product's instructions for descaling.
6. Troubleshooting
If you experience issues with your ice maker, refer to the following table for common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Unit not turning on | No power supply | Check power cord connection and wall outlet. |
| "Add Water" indicator is on | Water reservoir is empty | Fill the water reservoir. |
| Ice making cycle starts but no ice is produced | Water temperature too high | Ensure the unit is in a cool environment and water is cold. |
| Ice cubes are too small or not forming properly | Insufficient water or mineral buildup | Ensure adequate water supply. Perform descaling if necessary. |
| Unit is noisy | Normal operation sounds or improper placement | Some noise is normal during operation. Ensure the unit is on a level surface and not touching other objects. |
If the problem persists after trying these solutions, please contact customer support.
7. Specifications
| Feature | Detail |
|---|---|
| Brand | NutriChef |
| Model Number | PICEM75.6 |
| Ice Storage Capacity | 600g |
| Water Reservoir Capacity | 1.8L |
| Daily Ice Production | Up to 33 lbs. |
| Housing Material | Engineered ABS |
| Power Supply | 120V |
| Product Dimensions (D x W x H) | 14.6'' x 12.2'' x 13.8'' inches |
| Item Weight | 6.6 pounds |
| Power Cord Length | 4.6' Ft. |

Figure 7.1: Physical dimensions of the NutriChef Countertop Ice Maker Water Dispenser.
8. Warranty and Support
For warranty information or technical support, please refer to the warranty card included with your product or visit the official NutriChef website. Please have your model number (PICEM75.6) and purchase date available when contacting support.