BRAINWAVZ UltraT Under Desk Headphone Hanger Instruction Manual

1. Introduction

Thank you for choosing the BRAINWAVZ UltraT Under Desk Headphone Hanger. This product is designed to provide a convenient and space-saving solution for storing your headphones and managing cables. It features a robust design and uses strong adhesive for secure mounting without the need for screws. Please read this manual carefully before installation and use to ensure proper function and longevity of your hanger.

2. Safety Information

• Ensure the mounting surface is clean, dry, and smooth for optimal adhesive performance.
• Do not exceed the maximum recommended weight capacity of 2 kg (4.4 lbs) for the hanger.
• Avoid mounting on delicate or painted surfaces where adhesive removal might cause damage.
• Keep out of reach of small children to prevent accidental ingestion of small parts or misuse.
• This product is intended for indoor use only.

3. Package Contents

Please verify that all items are present in your package:

• 1 x BRAINWAVZ UltraT Under Desk Headphone Hanger
• Pre-applied 3M VHB adhesive tape

4. Setup and Installation

The BRAINWAVZ UltraT uses strong 3M VHB adhesive tape for installation. Follow these steps carefully for a secure mount.

1. Choose a Location: Select a flat, smooth, and clean surface under your desk or shelf. Ensure there is enough clearance for your headphones to hang freely.
2. Clean the Surface: Thoroughly clean the chosen mounting area with an alcohol wipe or a clean cloth and rubbing alcohol. Allow the surface to dry completely. This step is critical for optimal adhesion.
3. Prepare the Hanger: The 3M VHB tape is pre-applied to the top surface of the hanger. Carefully peel off the red protective backing from the adhesive pads.
4. Position and Press: Align the hanger in the desired position. Once aligned, firmly press the hanger against the cleaned surface for at least 30 seconds. Apply consistent pressure across the entire adhesive area.
5. Allow Curing Time: For maximum bond strength, allow the adhesive to cure for 24 hours before hanging any headphones. This allows the adhesive to fully set.

5. Operation

The UltraT hanger is designed for simple and efficient use.

5.1 Hanging Headphones

• The hanger features two wide cradles, allowing you to hang up to two large headphones simultaneously.
• Place the headband of your headphones onto the curved support arms of the hanger. Ensure the headphones are balanced to prevent them from falling.

5.2 Cable Management

• Integrated cable hooks are located on the underside of the hanger.
• Wrap excess headphone cables around these hooks to keep your desk tidy and prevent tangles.

6. Maintenance

• Cleaning: Wipe the hanger with a soft, damp cloth to remove dust or smudges. Avoid using harsh chemicals or abrasive cleaners, as these may damage the plastic material.
• Adhesive Check: Periodically check the adhesion to ensure it remains secure. If the hanger shows signs of loosening, remove all weight and re-apply pressure to the adhesive area.

7. Troubleshooting

7.1 Hanger is not sticking securely.

• Ensure the mounting surface was thoroughly cleaned and dry before application.
• Verify that sufficient pressure was applied during installation.
• Confirm that the adhesive was allowed to cure for the recommended 24 hours before use.
• The surface might be unsuitable for adhesive mounting (e.g., porous, textured, or freshly painted).

7.2 Hanger broke or cracked.

• Check if the total weight of the headphones exceeds the maximum capacity of 2 kg (4.4 lbs).
• Inspect for signs of impact or excessive force applied to the hanger.

8. Specifications

9. Warranty and Support

BRAINWAVZ products are manufactured to high-quality standards. For information regarding warranty coverage, product support, or to contact customer service, please visit the official BRAINWAVZ website or refer to the packaging for contact details. Please retain your proof of purchase for warranty claims.