Technical Pro FS2BT

Technical Pro FS2BT Rechargeable Camping Fan with AM FM Radio Speaker and LED Work Lamp User Manual

Model: FS2BT

1. Introduction

Thank you for choosing the Technical Pro FS2BT Rechargeable Camping Fan. This multi-purpose device is designed to enhance your outdoor experiences by providing cooling, illumination, and entertainment. It features an 8-inch fan, a 24-LED work lamp, an AM/FM radio, a built-in speaker, and multiple audio input options, all powered by an internal rechargeable battery.

This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your FS2BT unit. Please read it thoroughly before use and retain it for future reference.

Technical Pro FS2BT Camping Fan with LED lamp extended and controls visible

Figure 1.1: The Technical Pro FS2BT unit with its fan, LED work lamp, and control panel. The lamp is shown in an extended, rotating position.

2. Safety Instructions

To ensure safe operation and prevent damage to the device or injury, please observe the following safety precautions:

  • Do not expose the unit to rain, moisture, or immerse it in water.
  • Keep the unit away from direct sunlight and heat sources.
  • Do not attempt to disassemble, repair, or modify the unit. Refer all servicing to qualified personnel.
  • Ensure proper ventilation when operating the fan. Do not block the fan grille.
  • Keep fingers and other objects away from the fan blades during operation.
  • Use only the specified charging cable and power source.
  • Fully charge the battery before first use and recharge regularly to maintain battery health.
  • Store the unit in a cool, dry place when not in use.
  • This device is not a toy. Keep out of reach of children.

3. Setup and Initial Charging

Before using your Technical Pro FS2BT for the first time, it is recommended to fully charge the internal battery.

  1. Unpacking: Carefully remove the unit from its packaging and inspect for any damage.
  2. Initial Charge:
    • Locate the retractable power cord on the unit.
    • Extend the cord and plug it into a standard AC power outlet.
    • The "CHARGE" indicator light (red) will illuminate, indicating that the unit is charging.
    • Allow 8-10 hours for a full charge. The "POWER" indicator light (green) will illuminate when fully charged.
  3. Placement: Place the unit on a stable, flat surface. Ensure there is adequate space around the fan for optimal airflow.
Close-up of the control panel on the Technical Pro FS2BT

Figure 3.1: Detail of the control panel showing the charging indicators, power switch, and various function buttons.

4. Operating Instructions

4.1. Powering On/Off

Locate the main power switch on the control panel. Slide it to the "AC" position for wall power, or "DC" for battery power. Slide to "OFF" to power down the unit.

4.2. Fan Operation

  • To activate the fan, slide the "FAN" switch to "LOW" or "HIGH" for desired speed.
  • To turn off the fan, slide the "FAN" switch to "OFF".
  • The fan head can be manually adjusted to direct airflow.

4.3. LED Work Lamp Operation

Technical Pro FS2BT with its LED work lamp fully extended and illuminated

Figure 4.1: The FS2BT unit demonstrating the adjustable LED work lamp in an extended position.

  • The 24-LED work lamp can be folded out and rotated to various angles.
  • To turn on the lamp, slide the "LAMP" switch to the desired brightness setting (low or high).
  • To turn off the lamp, slide the "LAMP" switch to "OFF".
  • Emergency Lighting: When the unit is plugged into an AC outlet and the power goes out, the lamp will automatically activate (if the lamp switch is in an ON position) to provide emergency lighting.

4.4. Radio Operation

  • Extend the adjustable antenna for improved reception.
  • Use the "RADIO" controls (buttons for AM/FM selection, tuning, and volume) on the control panel to select your desired station.
  • The digital display will show the current frequency.

4.5. Audio Playback (Bluetooth, USB, TF Card)

The FS2BT features a built-in speaker and supports various audio input methods:

  • Bluetooth: Activate Bluetooth on your mobile device and pair with "FS2BT". Once connected, you can stream audio wirelessly.
  • USB Flash Drive: Insert a USB flash drive (up to 16GB) containing .mp3 audio files into the USB port. The unit will automatically detect and play the files.
  • TF Card (Micro SD): Insert a TF card (up to 16GB) containing .mp3 audio files into the TF card slot. The unit will automatically detect and play the files.
  • Use the playback controls (play/pause, skip track) on the unit to manage your audio.

5. Maintenance

  • Cleaning: Use a soft, dry cloth to clean the exterior of the unit. Do not use abrasive cleaners or solvents. For the fan grille, a soft brush can be used to remove dust.
  • Battery Care: To prolong the life of the internal rechargeable battery, avoid completely draining it. Recharge the unit fully after each use and at least once every three months if stored for extended periods.
  • Storage: When not in use, store the FS2BT in a cool, dry place, away from direct sunlight and extreme temperatures. Ensure the retractable cord is properly stored in its compartment.

6. Troubleshooting

ProblemPossible CauseSolution
Unit does not power on.Battery is depleted; Power switch is OFF.Charge the unit for 8-10 hours. Ensure the power switch is set to "AC" or "DC".
Fan is not working.Fan switch is OFF; Low battery.Slide the "FAN" switch to "LOW" or "HIGH". Recharge the unit.
LED lamp is not illuminating.Lamp switch is OFF; Low battery.Slide the "LAMP" switch to a brightness setting. Recharge the unit.
Poor radio reception.Antenna not extended; Weak signal.Fully extend the adjustable antenna. Try repositioning the unit.
USB/TF card audio not playing.Incorrect file format; Card/drive not inserted correctly; Card/drive capacity too large.Ensure files are .mp3 format. Reinsert the card/drive. Use a card/drive up to 16GB.
Bluetooth not connecting.Bluetooth not enabled on device; Unit not in pairing mode.Ensure Bluetooth is active on your device. Check the unit's display for pairing status.

7. Specifications

Diagram showing the dimensions of the Technical Pro FS2BT: 13 inches high, 4.5 inches wide, 12.5 inches long

Figure 7.1: Physical dimensions of the Technical Pro FS2BT unit.

Model NumberTPFS2BT
Dimensions (L x W x H)31.75 cm x 11.43 cm x 33.02 cm (12.5" x 4.5" x 13")
Weight2.47 kg (5.45 lbs)
Blade MaterialPlastic
Number of Blades3
Fan Speeds2 (Low, High)
LED Lamp Bulbs24
LED Lamp Brightness2 settings
Power SourceRechargeable Lithium Ion Battery, AC Power
Battery IncludedYes (1 Lithium Ion)
Charge Time8-10 hours
Playtime (Fan High)3-4 hours
Playtime (Light High)Up to 50 hours
Playtime (Speaker Medium)Up to 24 hours
Audio InputsBluetooth, USB (max 16GB), TF Card (max 16GB)
Radio TunerIntegrated Digital AM/FM
Material TypePlastic

8. Warranty and Support

Technical Pro products are designed for reliability and performance. For specific warranty information, please refer to the warranty card included with your purchase or visit the official Technical Pro website. If you encounter any issues or require technical assistance, please contact Technical Pro customer support through their official channels.

Please have your model number (FS2BT) and purchase details ready when contacting support.

Related Documents - FS2BT

Preview Technical Pro OFB18M Rechargeable Fan Instruction Manual
Comprehensive instruction manual for the Technical Pro OFB18M rechargeable fan, detailing assembly, operation, charging, specifications, and safety precautions. Includes guidance on using the fan's features, remote control, and maintenance.
Preview Olight Olantern Classic 2 Pro Camping Lantern: User Manual, Specs, and Operation Guide
Comprehensive user manual for the Olight Olantern Classic 2 Pro camping lantern. Find detailed information on specifications, charging methods (USB-C, magnetic), battery indicator, reverse charging function, operating instructions, and warranty.
Preview GÜDE L 18 LED Work Lamp - User Manual and Technical Specifications
Comprehensive user manual and technical specifications for the GÜDE L 18 LED work lamp (Model L 18, Art. No. 58519). Covers operation, safety precautions, battery care and disposal, maintenance, and technical data.
Preview VONROC WL502DC Rechargeable Work Light 10W - User Manual and Specifications
Official user manual and technical specifications for the VONROC WL502DC Rechargeable Work Light 10W. Covers safety instructions, intended use, operation, maintenance, environment, and warranty information.
Preview Goal Zero Crush Light Chroma LED Lantern User Guide
Comprehensive user guide for the Goal Zero Crush Light Chroma LED Lantern, covering setup, operation modes, charging instructions, technical specifications, and warranty information.
Preview LUMAK PRO LED Rechargeable Hand Lamp User Manual
User manual for the LUMAK PRO LED rechargeable hand lamp, including safety instructions, usage guide, charging information, and disposal guidelines. Model 10462542.