1. Introduction
This manual provides instructions for the BOMAZ Replacement Remote Control, designed for use with various Jensen AudioVox TV models. This remote offers a straightforward solution for controlling your television without complex setup procedures. It is built with durable ABS material and features soft plastic buttons for comfortable use.
Image 1.1: Front and side view of the BOMAZ Replacement Remote Control, showcasing its ergonomic design and button layout.
2. Setup
2.1 Battery Installation
The remote control requires two (2) AA alkaline batteries for operation. Please follow these steps to install the batteries:
- Locate the battery compartment cover on the back of the remote control.
- Press down on the tab and slide the cover downwards to open the compartment.
- Insert two AA batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
- Slide the battery compartment cover back into place until it clicks securely.
Image 2.1: View of the back of the remote control with the battery compartment open, showing the correct orientation for AA battery insertion.
2.2 Initial Use
This BOMAZ replacement remote control is designed for immediate use with compatible Jensen AudioVox TV models. No programming or pairing is required. Simply install the batteries, point the remote at your television, and begin operation.
3. Operating Instructions
The remote control utilizes infrared technology for precise control over a distance of more than 8 meters (approximately 26 feet). Ensure a clear line of sight between the remote's emitter and your TV's infrared receiver for optimal performance.
Image 3.1: The remote control being used in a living room setting, demonstrating its long-distance precise control capability.
3.1 Button Functions
The remote control features standard buttons for TV and DVD functions. Refer to the layout on your remote for specific button locations:
- POWER (TV/DVD): Turns the TV or DVD player on/off.
- Number Buttons (0-9): Directly select channels.
- CH +/-: Changes channels up or down.
- VOL +/-: Adjusts volume up or down.
- MUTE: Mutes or unmutes the TV audio.
- SOURCE: Selects input sources (e.g., HDMI, AV).
- MENU: Accesses the TV's main menu.
- Navigation Buttons (Up, Down, Left, Right, ENTER): Navigates through menus and confirms selections.
- EXIT: Exits the current menu or function.
- INFO: Displays information about the current program or input.
- EPG: Accesses the Electronic Program Guide (if supported by TV).
- Playback Controls (Play, Pause, Stop, Rewind, Fast Forward, Skip): Controls DVD playback functions.
- Other Function Buttons (e.g., T/F, ZOOM, SUB-T, DISP, SETUP, AUDIO, EQ, TITLE, C-LIST, F-LIST, MTS/SAP, SOUND, SLEEP, CC, SCALE, PICTURE): These buttons correspond to specific functions on your Jensen AudioVox TV or DVD player. Refer to your TV's original manual for detailed explanations of these features.
4. Maintenance
4.1 Battery Replacement
When the remote control's range decreases or it becomes unresponsive, it is time to replace the batteries. Follow the battery installation steps in Section 2.1. Always replace both batteries at the same time with new AA alkaline batteries.
4.2 Cleaning
To clean the remote control, use a soft, dry cloth. For stubborn dirt, slightly dampen the cloth with water or a mild, non-abrasive cleaner. Do not use harsh chemicals or immerse the remote in water.
5. Troubleshooting
If you experience issues with your BOMAZ Replacement Remote Control, please refer to the following common solutions:
- Remote not responding:
- Ensure the batteries are correctly installed with the proper polarity (+/-).
- Replace old batteries with new AA alkaline batteries.
- Check for any obstructions between the remote control and the TV's infrared sensor.
- Ensure you are within the effective operating range (within 8 meters) and pointing the remote directly at the TV.
- Specific buttons not working:
- Verify that the remote is in the correct mode (TV or DVD, if applicable).
- Clean the remote control, especially around the buttons, to remove any debris that might be causing sticking.
- Remote works intermittently:
- This often indicates low battery power. Replace the batteries.
- Ensure no strong light sources (like direct sunlight or bright fluorescent lights) are interfering with the infrared signal.
If these steps do not resolve the issue, please refer to the Warranty and Support section for further assistance.
6. Specifications
| Feature | Specification |
|---|---|
| Brand | BOMAZ |
| Compatible Devices | Jensen AudioVox Televisions (various models including JE1914, JE2414, JE2613, JE3215, JE4015, JE3914, JE4614, JE5015, JE5014, etc.) |
| Power Supply | 2 x 1.5V AA Alkaline Batteries |
| Operable Distance | More than 8 meters (approx. 26 feet) |
| Material | ABS Material |
| Special Feature | No Programming Required |
| Color | Black |
| Item Weight | 4.3 ounces |
| Package Dimensions | 9.69 x 4.25 x 1.42 inches |
7. Warranty and Support
7.1 Warranty Information
This BOMAZ Replacement Remote Control comes with a 90-day warranty from the date of purchase. This warranty covers manufacturing defects under normal use. It does not cover damage caused by misuse, accidents, unauthorized modifications, or improper battery installation.
7.2 Customer Support
For any questions, concerns, or warranty claims regarding your remote control, please contact the seller or manufacturer through the platform where the purchase was made. Provide your order details and a clear description of the issue for prompt assistance.