Prestige PWG08

Prestige PWG08 2 Litre Table-Top Wet Grinder Instruction Manual

Introduction

This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your Prestige PWG08 2 Litre Table-Top Wet Grinder. Please read these instructions carefully before using the appliance and retain them for future reference.

Prestige PWG08 2 Litre Table-Top Wet Grinder with idli, dosa, and vada on a banana leaf
Figure 1: Prestige PWG08 2 Litre Table-Top Wet Grinder. The image shows the compact design of the wet grinder alongside traditional South Indian dishes like idli, dosa, and vada, illustrating its primary use for preparing batters.

Product Features

  • High Quality Grinding Stones
  • Stainless Steel Drum
  • Compact table top design
  • Fast and consistent grinding
  • Attractive designer body
  • 2 litre capacity
  • 200 watts motor
Front-left view of Prestige PWG08 Wet Grinder
Figure 2: Front-left view of the Prestige PWG08 Wet Grinder, highlighting the motor unit, drum, and transparent lid. This view provides a clearer perspective of the appliance's overall structure.

Setup

Unpacking

Carefully remove the wet grinder from its packaging. Inspect the appliance for any signs of damage. Retain the packaging for future storage or transport.

Placement

Place the wet grinder on a stable, flat, and dry surface, away from direct heat sources or water. Ensure there is adequate ventilation around the motor unit.

Initial Cleaning

Before first use, clean the stainless steel drum, grinding stones, and lid with mild soap and water. Rinse thoroughly and dry completely. Do not immerse the motor unit in water.

Operating Instructions

Preparation of Ingredients

Soak ingredients like rice and lentils as per recipe requirements. Drain excess water before adding them to the grinder. For best results, add ingredients in small batches.

Assembly

  1. Place the grinding stones assembly inside the stainless steel drum.
  2. Position the drum securely on the motor unit base.
  3. Ensure the interlocking mechanism is engaged correctly.

Grinding Process

  1. Add the prepared ingredients to the drum.
  2. Secure the transparent lid on top of the drum.
  3. Plug the appliance into a suitable power outlet.
  4. Switch on the grinder.
  5. Gradually add water through the lid opening as needed to achieve the desired consistency. Avoid adding too much water at once.
  6. Allow the grinder to operate until the ingredients are finely ground. The grinding time will vary depending on the ingredients and desired texture.
  7. Once grinding is complete, switch off the appliance and unplug it from the power outlet.

Removing Batter

Carefully remove the lid, then lift out the grinding stone assembly. Scrape the batter from the stones and drum using a spatula.

Maintenance

Cleaning

  • Always unplug the grinder before cleaning.
  • Wash the stainless steel drum, grinding stones, and lid immediately after use with mild detergent and water.
  • Wipe the motor unit with a damp cloth. Do not use abrasive cleaners or immerse the motor unit in water.
  • Ensure all parts are thoroughly dry before reassembling or storing.

Storage

Store the wet grinder in a clean, dry place when not in use. Keep it away from children.

Troubleshooting

ProblemPossible CauseSolution
Grinder does not startNot plugged in; Power outage; Interlocking mechanism not engaged.Check power connection; Verify power supply; Ensure drum and lid are correctly placed and locked.
Slow grinding or motor strugglingOverloading with ingredients; Insufficient water; Ingredients not soaked properly.Reduce quantity of ingredients; Add water gradually; Ensure ingredients are adequately soaked.
Excessive noise during operationImproper assembly of grinding stones; Dry grinding; Foreign object in drum.Reassemble stones correctly; Ensure sufficient water is added; Check for and remove any foreign objects.
Motor heating upProlonged continuous operation; Overloading.Allow the motor to cool down between grinding sessions; Do not overload the grinder.

If the problem persists after attempting these solutions, please contact customer service.

Specifications

  • Model: PWG08
  • Capacity: 2 Litres
  • Wattage: 200 Watts
  • Drum Material: Stainless Steel
  • Body Material: Plastic
  • Item Weight: 12.3 Kilograms
  • Dimensions (L x W x H): 49L x 30W x 31H Centimeters
  • Power Source: AC adapter
  • Country of Origin: India

Warranty and Support

The Prestige PWG08 Wet Grinder comes with a 2-year warranty on the product and a 5-year warranty on the motor from the date of purchase.

For service requests, queries, or support, please contact:

  • Customer Care No: 080-46824000
  • Email: Customercare@ttkprestige.com
  • Manufacturer Contact: TTK PRESTIGE LIMITED, NATIONAL SERVICE MANAGER, NO. 110/5, ARUNA ARCADE, 1st FLOOR, LALBAGH ROAD, SUDHAMANAGAR, NEAR URVASHI THEATRE, BANGALORE - 560027, Phone: 1800-123-334411

Please retain your purchase receipt for warranty claims.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.