YONGJIANGXIA PEG-USB

Download PDF
Contents

YONGJIANGXIA USB Cable for Peugeot/Citroen RD43/RD45 Audio Systems

Model: PEG-USB

Introduction

This manual provides detailed instructions for the installation and use of the YONGJIANGXIA USB Cable. This cable allows you to connect USB devices to your vehicle's audio system, specifically designed for select Peugeot and Citroen models equipped with RD43 or RD45 stereo units. Please read this manual thoroughly before installation and operation to ensure proper functionality and avoid damage.

YONGJIANGXIA USB Cable with blue connector and standard USB-A female port

Image 1: The YONGJIANGXIA USB Cable, featuring a blue multi-pin connector on one end and a standard USB-A female port on the other.

Product Compatibility

This USB cable is compatible with the following vehicle models and audio systems:

  • Peugeot: 207, 307, 308, 407
  • Citroen: C2, C3, C4
  • Audio Systems: RD43, RD45

Ensure your vehicle's stereo unit is either an RD43 or RD45 model for proper compatibility. The cable is designed to connect to the specific USB input port found on these stereo units.

Comparison of RD43, RD45, and RD9 car stereo units, highlighting USB ports

Image 2: Visual guide to identifying RD43, RD45, and RD9 stereo units, with compatible USB ports highlighted for RD43 and RD45.

Setup and Installation

  1. Locate the USB Port: Identify the dedicated USB input port on the rear of your RD43 or RD45 car stereo unit. This port is typically a multi-pin connector.
  2. Close-up of the back of an RD45 car stereo showing the USB input port highlighted with a yellow box

    Image 3: The USB input port on the rear of an RD45 stereo unit, where the cable connects.

  3. Connect the Cable: Carefully insert the blue multi-pin connector of the YONGJIANGXIA USB cable into the corresponding port on your stereo unit. Ensure it clicks securely into place.
  4. Close-up of the blue multi-pin connector of the USB cable

    Image 4: Detailed view of the blue multi-pin connector, designed for secure fit.

  5. Route the Cable: Route the 90cm cable to a convenient location within your vehicle, such as the glove compartment, center console, or dashboard, where you intend to connect your USB devices. Ensure the cable is not pinched or obstructing any vehicle controls.
  6. Secure the Connection: Once connected, ensure the cable is firmly seated to prevent intermittent connections.

Operating Instructions

After successful installation, you can use the YONGJIANGXIA USB Cable to connect various USB devices to your car's audio system:

  • USB Flash Drives: Connect a USB flash drive containing MP3 or other compatible audio files. Your stereo unit should recognize the device and allow you to browse and play music.
  • Smartphones/MP3 Players: Connect your smartphone or MP3 player using its charging/data cable to the USB-A female port of this cable. The stereo may recognize it as a mass storage device or provide charging capabilities, depending on the stereo's features.
  • Other USB Devices: The cable provides a standard USB-A female port, allowing connection of various USB devices for data transfer or power, as supported by your car's audio system.

Refer to your vehicle's audio system manual (RD43 or RD45) for specific instructions on how to select the USB input source and control playback.

Maintenance

The YONGJIANGXIA USB Cable requires minimal maintenance:

  • Cleaning: Keep the connectors free from dust and debris. Use a dry, soft cloth to gently wipe the cable if necessary.
  • Storage: Avoid sharp bends or kinks in the cable, especially near the connectors, to prevent internal wire damage.
  • Handling: Always grasp the connector ends when plugging or unplugging the cable, rather than pulling on the cable itself.

Troubleshooting

ProblemPossible CauseSolution
No device detected / No audio playback.
  • Incorrect connection.
  • Incompatible stereo unit.
  • Damaged cable.
  • Incompatible USB device/file format.
  • USB input not selected on stereo.
  • Ensure the blue connector is fully seated in the stereo's port.
  • Verify your stereo is an RD43 or RD45 model.
  • Inspect the cable for visible damage.
  • Try a different USB device or ensure audio files are in a compatible format (e.g., MP3).
  • Select the USB or AUX input source on your car stereo.
Intermittent connection.
  • Loose connection.
  • Cable damage.
  • Re-seat both ends of the cable firmly.
  • Check for kinks or damage along the cable length.
USB device not charging.
  • Stereo unit does not provide sufficient power.
  • Device requires more power than available.
  • Not all car stereos provide high-power USB charging. This cable is primarily for data transfer.
  • Use a dedicated car charger for devices requiring faster charging.

Specifications

  • Model: PEG-USB
  • Brand: YONGJIANGXIA
  • Connector Type: Multi-pin (vehicle specific) to USB-A Female
  • Cable Length: Approximately 90 cm (35.4 inches)
  • Color: Black
  • Compatible Audio Systems: RD43, RD45
  • Compatible Vehicles: Peugeot 207, 307, 308, 407; Citroen C2, C3, C4
  • Item Weight: 2 ounces (approx. 56 grams)
  • ASIN: B082MQNLBX

Support

For further assistance or inquiries regarding the YONGJIANGXIA USB Cable, please refer to the seller's contact information on the purchase platform or visit the YONGJIANGXIA brand page.

Manufacturer: Sky International

© 2024 YONGJIANGXIA. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.