Introduction
This manual provides detailed instructions for the proper application, use, and maintenance of your MightySkins Carbon Fiber Skin for the Razor Hovertrax 1.5 Hover Board. This product is designed to provide a protective and stylish finish to your device.
Setup: Skin Application
Follow these steps for optimal application of your MightySkins Carbon Fiber Skin:
- Prepare Your Device: Ensure your Razor Hovertrax 1.5 Hover Board is clean, dry, and free of dust, dirt, or oils. Use a microfiber cloth for best results.
- Identify Skin Sections: Carefully lay out all pieces of the MightySkins decal. Familiarize yourself with which piece goes on each section of your Hover Board.
- Peel and Align: Gently peel a section of the skin from its backing. Align it carefully with the corresponding part of your Hover Board. Start from one edge and slowly lay the skin down.
- Smooth Application: Use your fingers or a soft, flat tool (like a credit card wrapped in a cloth) to smooth out the skin, working from the center outwards. This helps to remove any air bubbles. The patented low-grip air release adhesive assists in a smooth, bubble-free application.
- Repeat for All Sections: Continue this process for all remaining skin pieces until your Hover Board is fully covered. Take your time to ensure precise alignment and a smooth finish.
Operating: Product Use
Your MightySkins Carbon Fiber Skin is designed to enhance and protect your Razor Hovertrax 1.5 Hover Board. Please note the following:
- Protective Layer: The skin acts as a protective barrier against scratches, minor dings, dust, and fingerprints from everyday use.
- Textured Finish: The carbon fiber texture provides an improved grip and a distinct aesthetic.
- Not a Hard Case: This product is a vinyl decal sticker and does not offer the same level of impact protection as a hard case.
Maintenance
To keep your MightySkins Carbon Fiber Skin in optimal condition:
- Cleaning: Wipe the skin with a soft, damp cloth to remove dust and smudges. Avoid harsh chemicals or abrasive cleaners.
- Removal: When you wish to change your skin or remove it, gently peel it off. The patented adhesive is designed to remove cleanly without leaving sticky residue on your device.
Troubleshooting
- Air Bubbles: If small air bubbles appear after application, gently press them towards the nearest edge with your finger or a soft cloth. The air release channels in the adhesive should allow them to dissipate.
- Misalignment: If a section is misaligned during initial application, carefully peel it back slowly and reapply. The adhesive allows for repositioning during the application process.
Specifications
- Product Type: Vinyl Decal Sticker
- Finish: Textured Carbon Fiber Laminate
- Material: High-quality Vinyl with 3M material adhesive
- Protection: UV Protection, Scratch Resistance, Dust Protection
- Adhesive: Patented low-grip air release adhesive for easy application and residue-free removal
- Design: High-quality imaging (Cyclone Wave design)
- Compatibility: Specifically designed for Razor Hovertrax 1.5 Hover Board
- Included Components: One Skin set
- Item Weight: Approximately 8 ounces
- Product Dimensions: Designed to fit Razor Hovertrax 1.5 Hover Board (approx. 3 x 3 x 3 inches packaged)
Warranty & Support
MightySkins products are manufactured with quality and customer satisfaction in mind.
- Satisfaction Guarantee: MightySkins stands by its products. If you encounter any issues or are not satisfied with your order, please contact customer support for assistance.
- Manufacturing: Proudly made in the U.S.A. in a state-of-the-art production facility.
For further support or inquiries, please refer to the official MightySkins website or contact their customer service.