Invicta Pro Diver 43mm Quartz Watch Instruction Manual

Important Safety Precautions

WARNING: Ingestion Hazard

This product contains a button cell or coin battery. Death or serious injury can occur if ingested. A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours. Keep new and used batteries OUT OF REACH OF CHILDREN. Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.

This product is intended to be opened only by professionals. Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate. Even used batteries may cause severe injury or death. Non-rechargeable batteries are not to be recharged. Do not force discharge, recharge, disassemble, heat above (manufacturer's specified temperature rating) or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.

Image showing a warning label with symbols for battery ingestion hazard and proper disposal. It advises keeping batteries away from children and seeking medical attention if ingested.

General Safety Information:

This manual contains instructions that should be strictly followed at all times not only for optimal use, but to prevent any injuries to yourself, other persons or property. We encourage you to read the entire booklet and understand the meaning of the following symbols:

• ⚠ DANGER: Highly likely to cause death or serious injury.
• ⚠ WARNING: Can cause serious injury or death.
• ⓘ CAUTION: Can or will cause minor or moderate injury or damage.

Product Overview

The Invicta Pro Diver is a men's quartz watch featuring a 43mm stainless steel case, a blue dial, and a magnified date window. It is designed for recreational water activities with 100-meter water resistance.

Front view of the Invicta Pro Diver watch, showcasing the blue dial, silver-tone stainless steel case, and red and blue uni-directional bezel.

A detailed close-up of the watch dial, highlighting the luminous hands, hour markers, magnified date window, and the Invicta logo.

Side view of the watch, showing the textured push/pull crown used for setting time and date.

Setup and Initial Use

1. Setting the Time

1. Pull the crown (located on the right side of the watch case) out to the second click position.
2. Rotate the crown to move the hands clockwise until the correct time is displayed. Ensure AM/PM is correctly set if your watch has a 24-hour indicator (not applicable for this model, but good general advice).
3. Push the crown back into its normal position to start the watch.

2. Setting the Date

1. Pull the crown out to the first click position.
2. Rotate the crown counter-clockwise to adjust the date. Adjust the date to the day before the current date.
3. Pull the crown out to the second click position.
4. Rotate the crown clockwise to advance the time. As the hour hand passes midnight, the date will change to the current date. Continue rotating until the correct time is set.
5. Push the crown back into its normal position.

3. Adjusting the Bracelet

The stainless steel band is adjustable by adding or removing links. This procedure typically requires specialized tools and is best performed by a qualified jeweler or watch technician to avoid damage to the watch or injury.

Image showing the fold-over safety clasp of the Invicta Pro Diver watch's stainless steel bracelet. The clasp mechanism is visible.

Operating the Watch

Uni-directional Bezel

The watch features a uni-directional rotating bezel with a blue and red top ring. This bezel rotates only counter-clockwise. It is commonly used to measure elapsed time, particularly in diving. To use:

1. Align the zero marker (triangle) on the bezel with the minute hand at the start of an event.
2. Read the elapsed time by noting the position of the minute hand against the bezel's scale.

Note: The uni-directional rotation prevents accidental increases in measured time, which is a safety feature for divers.

Water Resistance

This watch is 100 meters (330 feet) water resistant. This rating makes it suitable for recreational surfing, swimming, snorkeling, sailing, and water sports. It is not suitable for diving.

• Ensure the crown is fully pushed in before any contact with water.
• Do not operate the crown or pushers (if any) while the watch is wet or submerged.
• After exposure to saltwater, rinse the watch with fresh water and dry it thoroughly.

Maintenance and Care

Cleaning

Regularly clean your watch with a soft, damp cloth. For the stainless steel bracelet, a soft brush and mild soap can be used, ensuring to rinse thoroughly with fresh water and dry completely. Avoid harsh chemicals or abrasive materials.

Battery Replacement

The watch is powered by a Japanese quartz movement (PC32 Caliber) and uses an SR626SW battery. When the battery life ends, it should be replaced by a qualified watch technician to ensure proper sealing and water resistance. Do not attempt to replace the battery yourself.

Crystal Care

The watch features a Flame Fusion crystal, which offers enhanced scratch resistance. While durable, avoid impacts and contact with abrasive surfaces to maintain its clarity.

Storage

When not wearing the watch, store it in a cool, dry place away from direct sunlight, extreme temperatures, and strong magnetic fields. The original Invicta box provides suitable protection.

Image of an open Invicta watch box, showing the interior cushioning designed to protect the watch during storage or transport.

Troubleshooting

• Watch Not Running: Check if the crown is fully pushed in. If the watch still does not run, the battery may need replacement.
• Date Not Changing: Ensure the time is set correctly, passing midnight for the date to advance. If the date changes at noon, the AM/PM setting needs adjustment (advance the time by 12 hours).
• Condensation Under Crystal: This may indicate a breach in water resistance. Avoid further water exposure and have the watch inspected by a professional immediately.
• Bracelet Discomfort: If the bracelet is too tight or too loose, consider having links added or removed by a professional.

Specifications

Warranty and Support

Invicta offers a standard warranty for its products. You may be eligible to upgrade to an extended 3-year warranty by registering your watch online.

For detailed warranty information, to register your watch, or to find service centers, please visit the official Invicta service website:

Invicta Service Manuals and Registration

You can also scan the QR code found on the product packaging for direct access to the manual and registration portal.

Image showing the bottom of the watch box with instructions to upgrade to a 3-year warranty by registering online, including a QR code to scan for the manual.

For further assistance, you may contact Invicta customer support. Contact details can typically be found on the official Invicta website or within the warranty booklet included with your watch.