Elmchee FFR0001 Electric Foot Callus Remover Kit User Manual

Introduction

Welcome to the user manual for your Elmchee Electric Foot Callus Remover Kit. This guide provides essential information for safe and effective use, maintenance, and care of your device. Please read all instructions carefully before first use and retain this manual for future reference.

Safety Information

Do not use on skin for more than 2-3 seconds in one area to prevent irritation or injury.
Close the product after each use.
Clean the grinding head immediately after use.
Ensure the grinding head is properly installed before operating the device.
Do not submerge the device in water for extended periods, despite its waterproof design.
Use only a 5V/1A charging voltage to avoid affecting the service life of the battery.

What's in the Box

Your Elmchee Electric Foot Callus Remover Kit includes the following items:

Electric Foot Callus Remover Device
USB Charging Cable
3 Replaceable Grinding Heads (Fine, Medium, Rough)
Cleaning Brush
User Manual

Elmchee Electric Foot Callus Remover Kit with device, three grinding heads, cleaning brush, and charging cable. — The complete Elmchee Electric Foot Callus Remover Kit, including the main device, three interchangeable grinding heads, a small cleaning brush, and a USB charging cable.

Setup

Charging the Device

Before initial use, fully charge your device. The high-quality 1200mAh lithium battery features overcharge protection and a battery display function, allowing you to monitor the remaining charge. A full charge takes approximately 3 hours and provides about 90 minutes of continuous operation. Ensure you use a 5V/1A charging voltage to maintain battery health.

Elmchee Electric Foot Callus Remover being charged via USB, illustrating compatibility with power banks, laptops, and car chargers. — The Elmchee Electric Foot Callus Remover connected for USB charging, highlighting its versatility with various power sources like power banks, laptops, and car chargers.

Attaching/Replacing Grinding Heads

The kit includes three different quartz sand grinding heads: a rough grinding head for stubborn horny dead skin, a medium grinding head for rough dead skin, and a fine grinding head for daily care. Select the appropriate head based on your skin's condition.

Hold the main body of the device.
Press the body switch key.
Press the grinding head switch key and pull out the head with one hand to remove.
Align the new grinding head and push it into place until it clicks securely.

Step-by-step guide on how to remove and replace the washable grinding heads on the Elmchee Electric Foot Callus Remover. — A sequence of images demonstrating the simple process of detaching and reattaching the grinding heads for the Elmchee foot callus remover.

Illustration of the three different quartz sand grinding heads for the Elmchee Electric Foot Callus Remover: fine for daily care, medium for newly formed dead skin, and rough for old hard thick cocoon. — A visual guide to the three types of grinding heads included with the Elmchee device: fine for daily maintenance, medium for moderate dead skin, and rough for stubborn calluses.

Operating Instructions

Preparation

For best results, first clean your feet or soak them in warm water for 10 minutes to soften the skin. Then, thoroughly dry your feet before using the device.

Usage

The Electric Foot Callus Remover offers two speeds: 1700x/min for low speed and 2000x/min for high speed. Select the desired speed by pressing the power button. Gently rub the chosen grinding head over the dead skin until it is removed. The device is designed to automatically stop if too much pressure is applied, preventing damage to healthy skin.

Three steps for foot care using the Elmchee Electric Foot Callus Remover: 1. Clean feet, 2. Choose a roller and use the device, 3. Apply foot cream. — A three-step guide for a complete foot care routine: cleaning feet, using the callus remover with the appropriate head, and applying moisturizing foot cream.

Post-Usage

After removing dead skin, wipe your feet with a dry cloth. Apply a moisturizing cream and gently massage your feet to hydrate and soothe the skin.

Maintenance

Cleaning

The electric foot file has an IPX7 waterproof design, allowing the entire body to be rinsed under running water. After each use, close the product and clean the grinding head thoroughly. Do not soak the device in water for a long time.

Close-up of the Elmchee Electric Foot Callus Remover showing how to remove and clean the grinding head, emphasizing the 1200mAh battery. — A close-up view demonstrating the easy removal and cleaning of the grinding head on the Elmchee device, also noting its 1200mAh battery capacity.

Storage

Store the product in a dry and well-ventilated area, away from direct sunlight and extreme temperatures.

Troubleshooting

Device stops working during use: The device is equipped with a safety feature that automatically stops operation if excessive pressure is applied. This prevents damage to healthy skin. Reduce pressure and restart the device.
Device not turning on: Ensure the device is fully charged. Check the LED power display for battery level. If the battery is low, connect the device to a 5V/1A power source using the provided USB cable for 3 hours.
Ineffective callus removal: Ensure you are using the appropriate grinding head for your skin type (fine, medium, or rough). For very thick calluses, the rough grinding head is recommended. Make sure your feet are clean and dry before use.

Specifications

Feature	Detail
Model Number	FFR0001
Battery Capacity	1200mAh Lithium Polymer
Charging Time	Approx. 3 hours
Operating Time	Approx. 90 minutes (continuous)
Speed Settings	2 (1700x/min low, 2000x/min high)
Waterproof Rating	IPX7
Material	Quartz (grinding heads)
Color	White
Item Weight	0.5 Pounds
Package Dimensions	7.44 x 4.8 x 1.93 inches

Warranty and Support

Your Elmchee callus remover kit comes with a one-year warranty. If you encounter any problems during use, please contact us in time, and we will provide you with satisfactory after-sales service. Please refer to your purchase documentation for specific contact details.