Introduction
Thank you for choosing the Subcold Super35 LED Mini Fridge. This appliance is designed for efficient cooling of beverages and snacks, featuring a 35-liter capacity, LED lighting, and a secure lock. Please read this manual thoroughly before installation and operation to ensure proper use and maintenance.
Important Safety Information
Always follow basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, or injury.
- Ensure the appliance is unplugged before cleaning or performing any maintenance.
- Do not operate the appliance with a damaged cord or plug.
- Keep ventilation openings clear of obstruction.
- Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
- Do not damage the refrigerant circuit.
- Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
Package Contents
Upon unpacking, please ensure all items are present and undamaged:
- Subcold Super35 LED Mini Fridge Unit
- 2 x Removable Chrome Wire Shelves
- 2 x Keys for Security Lock
- Instruction Manual (this document)
Setup and Installation
1. Unpacking and Placement
Remove all packaging materials. Place the fridge on a firm, level surface away from direct sunlight or heat sources. Ensure there is adequate ventilation around the unit (at least 10cm clearance on sides and back) for efficient operation. Allow the unit to stand upright for at least 2-4 hours before plugging it in to allow the refrigerant to settle.
2. Installing Shelves
The fridge comes with two removable and adjustable chrome wire shelves. Insert the shelves into the desired slots inside the cabinet.
Figure 1: Interior of the fridge showing the removable and adjustable chrome wire shelves.
3. Reversible Door Installation
The door of the Subcold Super35 is reversible, allowing it to open from either the left or right side. If you wish to change the door swing direction, refer to the detailed instructions provided in the separate door reversal guide (not included in this general manual, typically found with the product or online). This process usually involves unscrewing hinges and reattaching them on the opposite side.
Figure 2: Detail of the reversible door hinge, allowing for flexible placement.
4. Security Lock and Key
The fridge is equipped with a security lock to keep contents safe. Insert the key into the lock located at the bottom of the door and turn to secure or unlock. Two keys are supplied.
Figure 3: The integrated security lock and keyhole for securing contents.
Operating Instructions
1. Power Connection
After allowing the fridge to stand for 2-4 hours, plug the power cord into a suitable 230V electrical outlet.
2. Temperature Control
The Subcold Super35 features an adjustable thermostat located inside the unit. Turn the dial to set the desired temperature. The temperature range is typically between 3°C and 18°C. A lower number on the dial usually indicates a colder setting.
Figure 4: Adjustable thermostat dial for precise temperature control.
3. Internal LED Light
The fridge is equipped with an internal LED light to illuminate the contents. This light can typically be turned on or off via a switch located near the light fixture or control panel.
4. Loading the Fridge
Arrange bottles, cans, and snacks on the shelves. Avoid overloading the fridge, as this can restrict airflow and reduce cooling efficiency. Ensure items do not block the internal fan or air vents.
Figure 5: The fridge interior, demonstrating typical loading with beverages.
Maintenance
1. Cleaning the Interior
Unplug the fridge before cleaning. Remove all contents and shelves. Wipe the interior surfaces with a soft cloth dampened with a mild detergent solution. Rinse with clean water and dry thoroughly. Do not use abrasive cleaners or solvents.
2. Cleaning the Exterior
Clean the exterior surfaces with a soft, damp cloth. For the glass door, use a glass cleaner. Ensure no water enters the electrical components.
3. Defrosting
This appliance features manual defrosting. Frost buildup can occur over time, especially in humid environments. When frost accumulation exceeds 5mm, unplug the unit and allow the frost to melt naturally. Place a towel at the bottom to absorb water. Do not use sharp objects to remove frost.
4. Door Seal Maintenance
Regularly check and clean the door gasket to ensure a tight seal. A damaged or dirty seal can lead to inefficient cooling and increased energy consumption.
Troubleshooting Guide
| Problem | Possible Cause | Solution |
|---|---|---|
| Fridge does not operate | No power supply; Plug not properly inserted; Circuit breaker tripped. | Check power connection; Ensure plug is secure; Reset circuit breaker. |
| Fridge is not cold enough | Temperature setting too high; Door not closed properly; Excessive door opening; Warm items placed inside; Poor ventilation. | Adjust thermostat to a colder setting; Ensure door is fully closed; Reduce frequency of door opening; Allow warm items to cool before placing in fridge; Ensure adequate clearance around the unit. |
| Excessive noise | Fridge not level; Objects vibrating against the unit; Compressor noise (normal operation). | Adjust leveling feet; Ensure no objects are touching the fridge; Compressor noise is normal, especially when starting or stopping. |
| Internal LED light not working | Light switch off; LED bulb failure. | Check the light switch; Contact customer support for bulb replacement if necessary. |
Technical Specifications
| Feature | Specification |
|---|---|
| Model Number | SUPER35 |
| Capacity | 35 Litres (Gross), 33 Litres (Net) |
| Dimensions (W x D x H) | 405 x 440 x 552 mm |
| Temperature Range | 3°C - 18°C (Adjustable) |
| Cooling Method | Compressor |
| Voltage | 230 Volts |
| Annual Energy Consumption | 48 kWh/year |
| Noise Level | 42 dB |
| Number of Shelves | 2 (Chrome Wire, Removable & Adjustable) |
| Door Type | Dual Glazed Safety Glass, Reversible |
| Lock Type | Key Lock (2 keys supplied) |
| Item Weight | 15.6 Kilograms |
| Certifications | CE, ROHS, WEEE Compliant |
Figure 6: New EU Energy Rating Label for the Subcold Super35 LED Mini Fridge.
Warranty and Support
The Subcold Super35 LED Mini Fridge comes with a 1 Year Full Warranty from the date of purchase. This warranty covers manufacturing defects and ensures the product meets high quality standards.
For warranty claims, technical support, or any inquiries regarding your product, please contact Subcold customer service. You can find more information and contact details on the official Subcold website: https://subcold.com/
All Subcold products are tested to high UK standards and come complete with CE and ROHS Certification, along with WEEE compliance.