Introduction
The Swiffer WetJet is an all-in-one mopping system designed for efficient and convenient floor cleaning. It utilizes a dual-nozzle spray system and absorbent pads to dissolve and trap dirt and grime. This system is safe for use on all finished floors, including wood, laminate, and tile, providing a hassle-free alternative to traditional mop and bucket methods.
Image: Swiffer WetJet Starter Kit showing the main components.
Kit Contents
Your Swiffer WetJet Hardwood and Floor Spray Mop Cleaner Starter Kit includes the following items:
- 1 Swiffer WetJet Power Mop
- 10 Swiffer WetJet Mopping Pads
- 1 Bottle of Swiffer WetJet Cleaning Solution
- 2 AA Batteries (included)
Image: Visual representation of the Swiffer WetJet Starter Kit contents.
Safety Information
Please read and understand all safety information before using your Swiffer WetJet.
- KEEP OUT OF REACH OF CHILDREN AND PETS to avoid accidental ingestion.
- In case of eye contact or prolonged exposure to skin with Swiffer WetJet solution, flush with water to reduce irritation. If irritation persists, call a physician.
- Avoid exerting excessive pressure on the mop pole as breakage may occur.
- Do not use on unfinished, oiled, or waxed wooden boards, non-sealed tiles, or carpeted floors as they may be water sensitive.
Setup Guide
- Connect Poles: Assemble the mop handle by connecting the pole sections until they click securely into place.
- Insert Batteries: Open the battery compartment on the mop head and insert the 2 AA batteries. Ensure correct polarity.
- Load Cleaning Solution: Insert the Swiffer WetJet cleaning solution bottle into the designated slot on the mop head. The bottle will click into place.
- Attach Mopping Pad: Place a fresh mopping pad on the floor with the absorbent side facing up. Align the mop head over the pad and press down firmly to attach it using the Velcro-like strips.
Image: Visual instructions for assembling and preparing the Swiffer WetJet.
Operating Instructions
- Prepare the Area: For best results, sweep or vacuum the floor to remove loose debris before mopping.
- Spray and Mop: Hold the mop upright and press the spray button located on the handle to dispense cleaning solution onto the floor. Move the mop back and forth over the area to clean.
- Tackle Tough Messes: The built-in scrubby strip on the mop head helps to clean tough dirt, grime, and sticky messes. Apply slight pressure and scrub as needed.
- Clean All Finished Floors: The Swiffer WetJet is safe for use on various finished floor types, including vinyl, hardwood, and tile.
Image: Swiffer WetJet being used to clean a floor.
Maintenance
- Replace Mopping Pads: After each cleaning session, or when the pad becomes visibly dirty, remove the used pad and dispose of it. Attach a new, fresh pad for the next use.
- Refill Cleaning Solution: When the cleaning solution bottle is empty, remove it from the mop head and replace it with a new Swiffer WetJet cleaning solution refill.
- Battery Replacement: If the spray function weakens or stops working, it may be time to replace the AA batteries in the mop head.
- Storage: Store the Swiffer WetJet in a cool, dry place. Ensure the cleaning solution bottle is securely in place to prevent leaks.
Image: A used Swiffer WetJet pad showing trapped dirt, ready for disposal.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Mop is not spraying. | Batteries are dead or incorrectly inserted. | Replace batteries with new AA batteries, ensuring correct polarity. |
| Mop is not spraying. | Cleaning solution bottle is empty or not properly seated. | Replace with a new cleaning solution bottle and ensure it clicks firmly into place. |
| Mop pad is not staying attached. | Velcro-like strips on the mop head or pad are worn or dirty. | Ensure the mop head's attachment points are clean. Use a new pad. If problem persists, the mop head may need replacement. |
| Floor appears streaky after cleaning. | Too much solution applied or pad is oversaturated/dirty. | Use less solution per spray. Replace the pad if it's too dirty. Ensure floor is swept/vacuumed before mopping. |
Specifications
- Product Dimensions: 4.53 x 18.9 x 6.02 inches
- Item Weight: 3.23 Pounds
- Model Number: 1
- Batteries: 2 AA batteries required (included)
- Manufacturer: Procter & Gamble Home Care
- Item Form: Pads, Liquid
- Scent: Fresh
- Specific Uses For Product: Tile, Floor
- Material Feature: Recyclable
Warranty and Support
For detailed warranty information and customer support, please refer to the official Swiffer website or contact Procter & Gamble Home Care directly. Additional instructions and safety information can be found in the provided PDF documents:
You can also visit the Swiffer Store on Amazon for more product information and accessories.
