Introduction
This manual provides comprehensive instructions for the safe and effective use of your Little Experimenter Projector Telescope. Please read this manual thoroughly before operating the device and retain it for future reference.
Package Contents
Verify that all items listed below are present in your package:
- Projector Telescope Unit
- Foldable Tripod
- 3 Projection Discs (24 space-themed images)
- Educational Activity Book
- 3 x AG13/LR44 Batteries (pre-installed or included)
Setup Instructions
1. Tripod Assembly
Carefully unfold the three legs of the tripod until they are fully extended and form a stable base. Ensure the central support mechanism is securely in place.

Image: The Projector Telescope fully assembled on its tripod, ready for use.
2. Battery Installation (if not pre-installed)
The telescope requires 3 AG13/LR44 batteries. Locate the battery compartment, usually near the projector light source. Open the compartment, insert the batteries according to the polarity markings (+/-), and close the cover securely.
3. Attaching the Telescope Unit
Align the base of the telescope unit with the mounting point on the tripod. Securely attach the telescope to the tripod by tightening the knob or screw until it is firm and stable.
Video: Unboxing and Initial Setup
Video: An unboxing demonstration of the Little Experimenter Projector Telescope, showing the contents and initial assembly steps.
Operating Instructions
1. Telescope Viewing Mode
- Ensure the projector light is off.
- Look through the eyepiece at the rear of the telescope.
- Adjust the telescope's angle by gently tilting it up or down, or rotating it left or right, to view desired objects.
- The telescope provides 2x magnification for observing distant objects.

Image: A child looking through the telescope eyepiece, demonstrating its use for observation.
2. Projector Mode
- Insert a Projection Disc: Select one of the three projection discs. Locate the disc slot on the projector unit (usually on the side or top). Gently slide the disc into the slot until it clicks into place.
- Turn On the Projector: Locate the power switch for the projector (often a button or slider near the projector lens) and turn it on.
- Adjust Focus: Rotate the focus ring around the projector lens until the projected image on your wall or ceiling is clear and sharp.
- Change Images: Rotate the projection disc manually to cycle through the 8 images on the disc.
- Adjust Projection Angle: The projector unit can often be swiveled or tilted independently to direct the image onto different surfaces.

Image: The included educational activity book and the three projection discs, each containing 8 space-themed images.

Image: A clear space-themed image, such as an astronaut in space, projected onto a wall from the telescope's projector.
Video: Projector Function Demonstration
Video: A demonstration of the projector feature, showcasing how to insert discs and project space images onto a surface.
Video: Explaining Telescope Features
Video: An overview explaining the various features and functionalities of the Projector Telescope.
Maintenance
Cleaning
To clean the telescope and projector lenses, use a soft, lint-free cloth. For stubborn smudges, slightly dampen the cloth with water. Avoid abrasive cleaners or solvents, as these can damage the optical surfaces.
Battery Replacement
When the projector light dims or the telescope functions become erratic, it is time to replace the batteries. Follow the battery installation steps (Setup Section 2) to replace the 3 AG13/LR44 batteries.
Storage
Store the telescope in a cool, dry place away from direct sunlight and extreme temperatures. If storing for extended periods, remove the batteries to prevent leakage.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Projector light does not turn on. | Batteries are dead or incorrectly installed. | Check battery polarity; replace batteries. |
| Projected image is blurry. | Focus is not adjusted; projector lens is dirty. | Rotate the focus ring; gently clean the projector lens. |
| Telescope view is unclear. | Eyepiece or objective lens is dirty. | Gently clean the eyepiece and objective lens with a soft cloth. |
| Tripod is unstable. | Legs not fully extended or locked. | Ensure all tripod legs are fully extended and the central support is locked. |
Specifications
| Feature | Detail |
|---|---|
| Brand | Little Experimenter |
| Model Name | Kids Telescopes |
| Model Number | LE-2603 |
| Optical Tube Length | 14 inches |
| Eyepiece Lens | Flexible, soft eyepiece |
| Objective Lens Diameter | 5 inches |
| Telescope Mount | Alt-azimuth mount with foldable tripod |
| Product Dimensions (D x W x H) | 14.13"D x 15.5"W x 22.25"H |
| Focus Type | Manual Focus |
| Power Source | Battery Powered |
| Batteries Required | 3 LR44 batteries (included) |
| Focal Length | 11.125 inches |
| Zoom Ratio | 2:1 |
| Additional Features | Projector |
| Item Weight | 1.4 pounds |
| UPC | 818907026036 |
Warranty & Support
This Little Experimenter Projector Telescope comes with a 90-day warranty from the date of purchase. This warranty covers manufacturing defects. For warranty claims, technical support, or any questions regarding your product, please contact Little Experimenter customer service. Refer to the product packaging or the official Little Experimenter website for contact details.