Introduction
This manual provides instructions for the installation, use, and maintenance of your Nyko Screen Armor tempered glass screen protector for the Nintendo Switch Lite. The Screen Armor is designed to protect your device's screen from scratches, chips, fingerprints, and smudges with its 9H hardness rating and oleophobic coating.
Package Contents
- 1x Nyko Screen Armor Tempered Glass Screen Protector
- 1x Wet Cleaning Wipe
- 1x Dry Cleaning Wipe
The Nyko Screen Armor package includes one tempered glass screen protector, one wet cleaning wipe, and one dry cleaning wipe.
Installation Instructions
Follow these steps carefully for optimal installation of your Nyko Screen Armor:
- Prepare the Screen: Use the included wet cleaning wipe to thoroughly clean the Nintendo Switch Lite screen, removing all dust, dirt, and smudges.
- Dry the Screen: Use the included dry cleaning wipe to dry the screen completely. Ensure no lint or moisture remains.
- Align the Screen Protector: Carefully peel off the protective film from the adhesive side of the Nyko Screen Armor. Align the screen protector with the edges of your Nintendo Switch Lite screen. Ensure the cutouts for speakers and sensors match perfectly.
- Apply the Screen Protector: Once aligned, gently lower the screen protector onto the screen. It will begin to adhere automatically.
- Remove Air Bubbles: If any air bubbles are present, gently push them towards the edges of the screen using a soft cloth or your finger. Small bubbles should disappear within 24-48 hours.
This diagram shows the key features of the Nyko Screen Armor, including its precision fit for the Nintendo Switch Lite, 9H tempered glass hardness, oleophobic coating to resist smudges, and rounded edges to prevent chipping. The image also indicates the included cleaning wipes.
Usage and Care
Once installed, the Nyko Screen Armor provides continuous protection for your Nintendo Switch Lite screen. The oleophobic coating helps reduce fingerprints and smudges during normal use.
- Avoid placing sharp objects directly against the screen protector to prevent damage, despite its high hardness rating.
- For cleaning, gently wipe the screen protector with a soft, lint-free cloth. Avoid harsh chemicals.
The Nyko Screen Armor provides a clear protective layer over the Nintendo Switch Lite screen.
Maintenance
Regular maintenance ensures the longevity and clarity of your screen protector.
- Periodically clean the screen protector with a microfiber cloth to remove fingerprints and dust.
- If the screen protector becomes severely scratched or damaged, it is recommended to replace it to maintain optimal screen protection and visibility.
Troubleshooting
Air Bubbles After Installation
If small air bubbles remain after installation, gently push them towards the nearest edge with a soft cloth. Most small bubbles will dissipate naturally within 24-48 hours as the adhesive fully settles.
Misalignment
If the screen protector is significantly misaligned, it may be necessary to carefully lift it from one corner and reapply. This should be done immediately after initial application before the adhesive fully cures. Avoid excessive force to prevent damage to the screen protector or device.
Screen Protector Not Sticking
Ensure the screen was thoroughly cleaned and dried before application. Any dust, oil, or moisture can prevent proper adhesion. If the issue persists, the screen protector may be defective or damaged, and replacement might be necessary.
Product Specifications
| Feature | Detail |
|---|---|
| Model Number | 87288 |
| Hardness Rating | 9H |
| Material | Tempered Glass |
| Special Features | Oleophobic Coating, Rounded Edges, Precision Fit |
| Product Dimensions | 0.39 x 0.39 x 0.5 inches |
| Item Weight | 0.81 ounces |
| Manufacturer | Nyko |
| Release Date | September 16, 2019 |
Warranty and Support
For warranty information or technical support regarding your Nyko Screen Armor, please refer to the official Nyko website or contact their customer service directly. Keep your proof of purchase for any warranty claims.
