Lights4fun CA19026

Lights4fun TruGlow Flameless LED Taper Candles (CA19026) Instruction Manual

Set of 8 Ivory Real Wax 8.6" Flickering Flameless LED Battery Operated Taper Dinner Candles with Remote Control

Introduction

Thank you for choosing Lights4fun TruGlow Flameless LED Taper Candles. This set includes 8 ivory real wax taper candles designed to provide the ambiance of traditional candles without the open flame. Each candle features a flickering warm white LED bulb and is operated by batteries, controlled conveniently with an included remote. These candles are crafted from real wax, offering a realistic appearance and feel.

Set of 8 Lights4fun TruGlow Ivory Real Wax Flameless LED Taper Candles

Image: A full set of 8 Lights4fun TruGlow Ivory Real Wax Flameless LED Taper Candles, showcasing their realistic design.

Safety Information

Setup Instructions

1. Battery Installation

  1. Gently twist the base of each taper candle counter-clockwise to open the battery compartment.
  2. Insert 2 x AAA batteries (not included) into each candle, ensuring correct polarity (+ and -).
  3. Twist the base clockwise to securely close the battery compartment.
Close-up of the base of a TruGlow taper candle, showing the battery compartment.

Image: A detailed view of the candle base, indicating where batteries are inserted.

2. Remote Control Preparation

The remote control typically comes with a protective plastic tab in the battery compartment. Pull this tab out before first use to activate the remote's battery.

Remote control for Lights4fun TruGlow candles, showing ON/OFF and timer buttons.

Image: The remote control used to operate the flameless taper candles, highlighting its buttons.

Operating Instructions

Using the Remote Control

Point the remote control towards the candles you wish to operate. The remote has a range of approximately 10-15 feet.

Note: The flickering effect is an inherent feature of the LED bulb and cannot be adjusted.

Maintenance

Cleaning

To clean the candles, gently wipe them with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these can damage the wax finish.

Battery Replacement

When the light output dims or the candles stop responding to the remote, it's time to replace the batteries. Follow the "Battery Installation" steps in the Setup section. Dispose of old batteries responsibly according to local regulations.

Storage

Store the candles in a cool, dry place away from direct sunlight and extreme temperatures to preserve the wax and battery life. Remove batteries if storing for extended periods.

Troubleshooting

ProblemPossible CauseSolution
Candle does not turn on.
  • Batteries are inserted incorrectly.
  • Batteries are depleted.
  • Remote control battery is depleted or tab not removed.
  • Candle is out of remote range.
  • Check battery polarity and reinsert.
  • Replace with fresh AAA batteries.
  • Remove plastic tab from remote or replace remote battery.
  • Move closer to the candle and ensure direct line of sight.
Remote control is not working.
  • Protective tab not removed.
  • Remote battery is depleted.
  • Obstruction between remote and candle.
  • Remove the plastic tab from the remote's battery compartment.
  • Replace the remote control battery (typically a CR2025 coin cell).
  • Ensure a clear line of sight to the candle's sensor.
Candle light is dim.Batteries are low.Replace with fresh AAA batteries.
Timer function is not working as expected.Timer was not set correctly or was interrupted.Press the "OFF" button, then press the "6H TIMER" button again to reset the timer. Ensure the candles remain powered on for the full 6-hour cycle.

Product Specifications

Warranty Information

Lights4fun products are manufactured to high-quality standards. For specific warranty details, please refer to the product packaging or contact Lights4fun customer support. Keep your purchase receipt as proof of purchase.

Customer Support

Should you encounter any issues or have questions regarding your Lights4fun TruGlow Flameless LED Taper Candles, please visit the Lights4fun website or contact their customer service department for assistance.