Introduction
This manual provides essential information for the proper installation, operation, and maintenance of your TAMIYA 54860 T3-01 Type 370 Sport-Tuned Motor. This motor is designed to enhance the performance of T3-01 chassis models, including the Dancing Rider and Dual Rider kits, by increasing top speed.
Safety Information
Please read and understand all safety warnings before using this product. Failure to do so may result in injury or damage to the product.
- Always disconnect the battery before installing or removing the motor.
- Ensure proper ventilation during operation to prevent overheating.
- Keep fingers and loose clothing away from moving parts.
- This product is not a toy. Adult supervision is recommended for users under 14 years of age.
- Use only with compatible TAMIYA T3-01 chassis models and recommended accessories.
Package Contents
- 1 x TAMIYA Type 370 Sport-Tuned Motor
- 1 x Brass Pipe Adapter (for use with separately sold 26T pinion gear, Item 54228)
Setup and Installation
Follow these steps to properly install the TAMIYA 54860 Type 370 Sport-Tuned Motor into your T3-01 chassis.
- Prepare the Chassis: Ensure your T3-01 chassis is clean and free of debris. Disconnect the battery from the Electronic Speed Controller (ESC).
- Remove Existing Motor: Carefully remove the stock motor from the motor mount according to your T3-01 chassis manual. Disconnect any wiring.
- Install Pinion Gear (if applicable): If using the 26T pinion gear (Tamiya Item 54228), attach the included brass pipe adapter to the motor shaft, then secure the pinion gear onto the adapter. Ensure the pinion gear is properly aligned with the spur gear.
- Mount the Motor: Insert the TAMIYA 54860 Type 370 Sport-Tuned Motor into the motor mount on your T3-01 chassis. Secure it using the appropriate screws, ensuring proper gear mesh between the pinion and spur gears. Refer to your chassis manual for specific gear mesh adjustment procedures.
- Connect Wiring: Connect the motor wires to the ESC. Pay close attention to polarity (positive to positive, negative to negative) to ensure correct motor rotation. Incorrect wiring can damage the ESC or motor.
- Final Check: Before connecting the battery, manually rotate the wheels to ensure smooth movement and proper gear mesh.
Operating Instructions
Once installed, the TAMIYA 54860 Type 370 Sport-Tuned Motor operates like a standard brushed DC motor. Ensure your ESC is compatible with brushed motors and can handle the motor's current draw.
- Power Source: Use a 7.2 Volt battery pack as specified for the T3-01 chassis.
- Initial Run: Perform a short test run at low speed to confirm correct operation and motor direction. If the motor spins in reverse, reverse the polarity of the motor wires connected to the ESC (consult your ESC manual).
- Performance: This sport-tuned motor provides increased RPM (approximately 22200 RPM) compared to stock motors, resulting in higher top speeds for your T3-01 model.
Maintenance
Regular maintenance will prolong the life and performance of your motor.
- Cleaning: Periodically clean the motor exterior to remove dust and debris. Use a soft brush or compressed air. Avoid using liquids directly on the motor.
- Inspection: Regularly inspect motor wires for damage or fraying. Check motor mounting screws for tightness.
- Brush Wear: As a brushed motor, the carbon brushes will wear over time. While this motor is generally sealed, if performance degrades significantly, it may indicate brush wear. Replacement of the entire motor is typically recommended for this type of sealed unit.
- Storage: Store the motor in a clean, dry environment away from extreme temperatures.
Troubleshooting
If you encounter issues with your motor, consider the following common troubleshooting steps:
- Motor Not Spinning:
- Check battery charge level.
- Verify all wiring connections between the motor, ESC, and battery are secure and correct.
- Ensure the ESC is properly calibrated and functioning.
- Check for any obstructions preventing the motor or gears from turning freely.
- Reduced Performance/Overheating:
- Check gear mesh; it should be smooth but not too loose or too tight.
- Ensure the motor is not overloaded (e.g., by incorrect gearing or excessive friction in the drivetrain).
- Verify the battery is providing adequate power.
- Clean any debris from the motor's cooling vents.
- Unusual Noise:
- Inspect gears for damage or foreign objects.
- Check motor mounting for looseness.
Specifications
| Feature | Specification |
|---|---|
| Brand | TAMIYA |
| Model Name | TAM54860 |
| Item Model Number | 54860 |
| Type | Brushed Electric Motor |
| Compatibility | T3-01 Chassis Models (Dancing Rider, Dual Rider) |
| Speed | Approximately 22200 RPM |
| Voltage | 7.2 Volts |
| Material | Plastic |
| Item Weight | 0.32 ounces (approx. 9 grams) |
| Package Dimensions | 5.28 x 3.31 x 0.98 inches |
Official Product Videos
No official product videos from the seller are available for embedding at this time. Please refer to the manufacturer's website or official channels for any available video content.
Description: This section would typically feature videos demonstrating installation, operation, or key features of the Tamiya 54860 motor. As no relevant seller-created videos were provided, this space serves as a placeholder for future video integration.
Warranty Information
Specific warranty details for the TAMIYA 54860 T3-01 Type 370 Sport-Tuned Motor are not provided in the product information. Please refer to TAMIYA's official website or contact their customer support for current warranty policies.
Customer Support
For further assistance, technical support, or inquiries regarding the TAMIYA 54860 T3-01 Type 370 Sport-Tuned Motor, please contact TAMIYA customer service directly. Visit the official TAMIYA website for contact information and support resources.
Note: Always refer to the latest information available on the official TAMIYA website for the most accurate and up-to-date support details.
