1. Introduction
Thank you for choosing the Faber 152 SRM LG A90 Built-in Hood. This manual provides essential information for the safe installation, operation, and maintenance of your new kitchen appliance. Please read these instructions carefully before use and keep them for future reference.
1.1 Safety Information
Always follow basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and personal injury. Ensure the appliance is correctly installed and grounded by a qualified technician. Do not allow children to operate the hood. Clean the grease filters regularly to prevent fire hazards.
2. Package Contents
Verify that all components are present in the packaging:
- Faber 152 SRM LG A90 Built-in Hood unit
- Synthetic Grease Filter (pre-installed or separate)
- Mounting hardware (screws, brackets)
- Instruction Manual (this document)
3. Setup and Installation
Installation should be performed by a qualified technician in accordance with local regulations and safety standards. Ensure the power supply is disconnected before beginning installation.
3.1 Mounting the Hood
The Faber 152 SRM LG A90 is a built-in hood designed for integration into kitchen cabinetry. Ensure adequate clearance above the cooking surface as specified by local regulations and the hood's technical specifications.
Image 1: Installation diagram showing dimensions and mounting points for the Faber 152 SRM LG A90 built-in hood. The diagram illustrates the hood's placement within a cabinet, indicating measurements for width, depth, and height, as well as the air outlet diameter.
3.2 Electrical Connection
Connect the hood to a grounded 220 Volt (AC) power supply. The electrical connection must comply with all local electrical codes. Do not use extension cords or adapters.
3.3 Ducting Connection
The hood is designed for exhaust ventilation. Connect the 120 mm diameter air outlet to an appropriate ducting system that vents outdoors. Ensure the ducting is free from obstructions and has minimal bends for optimal performance.
4. Operating Instructions
The Faber 152 SRM LG A90 hood features electromechanical controls for easy operation of its functions.
Image 2: The Faber 152 SRM LG A90 built-in hood shown installed under a kitchen cabinet. The image highlights its discreet design and the integrated LED lighting illuminating the cooking area.
4.1 Power On/Off
Press the power button to turn the hood on or off.
4.2 Fan Speed Selection
The hood offers three fan speeds to suit different cooking needs:
- Speed 1: For light cooking and simmering.
- Speed 2: For normal cooking.
- Speed 3: For heavy frying or strong odors.
Use the dedicated speed buttons to select the desired fan speed.
4.3 Lighting Control
Press the light button to turn the LED lighting on or off. The LED lights provide illumination for your cooking area.
5. Maintenance
Regular maintenance ensures optimal performance and extends the lifespan of your hood.
5.1 Cleaning the Grease Filters
The hood is equipped with synthetic grease filters. These filters should be cleaned regularly, typically every 2-4 weeks depending on usage, to prevent grease buildup and maintain extraction efficiency. To clean:
- Turn off and unplug the hood from the power supply.
- Remove the grease filters by releasing their locking mechanisms.
- Wash the filters by hand in hot soapy water or in a dishwasher on a low-temperature cycle.
- Allow the filters to dry completely before reinstalling them.
Replace synthetic filters if they show signs of damage or excessive wear.
5.2 Cleaning the Hood Surface
Clean the exterior surfaces of the hood with a soft cloth and a mild, non-abrasive detergent. Do not use abrasive cleaners, steel wool, or harsh chemicals, as these can damage the finish.
5.3 LED Light Replacement
LED lights are long-lasting. If replacement is necessary, contact a qualified service technician. Do not attempt to replace LED lights yourself.
6. Troubleshooting
Before contacting customer service, refer to the following table for common issues and their solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Hood does not turn on | No power supply; Power cord unplugged; Circuit breaker tripped | Check power connection; Check circuit breaker; Ensure power outlet is functional |
| Low suction power | Grease filters are dirty; Ducting is obstructed or too long/bent; Fan motor issue | Clean or replace grease filters; Check ducting for obstructions; Contact service technician |
| Lights not working | LED lights faulty; Electrical connection issue | Contact service technician for LED replacement; Check power supply |
| Excessive noise | Loose components; Fan obstruction; Motor issue | Check for loose parts; Clear any obstructions; Contact service technician |
7. Technical Specifications
| Feature | Specification |
|---|---|
| Brand | FABER |
| Model Number | 152 SRM LG A90 |
| Mounting Type | Built-in |
| Control Type | Electromechanical Buttons |
| Lighting Type | LED |
| Grease Filter Type | Synthetic |
| Air Outlet Diameter | 120 mm |
| Width | 900 mm |
| Energy Efficiency Class | D |
| Motor Quantity | 1 |
| Fan Speeds | 3 |
| IEC Suction Capacity (Speed 1/2/3) | 115 / 160 / 225 m³/h (converted from Litri al minuto) |
| Pressure (Speed 1/2/3) | 190 / 310 / 370 Pa |
| Power Consumption (Speed 1/2/3) | 80 / 95 / 115 W |
| Noise Level (Speed 1/2/3) | 52 / 59 / 68 dB |
| Voltage | 220 V (AC) |
| Color | Light Grey |
| Material | Synthetic |
| Ventilation Type | Exhaust |
8. Warranty and Support
8.1 Warranty Information
For information regarding product warranty and returns, please refer to the terms and conditions provided at the point of purchase or consult the official Faber website. Typically, if you wish to return a product within 30 days of receipt because you have changed your mind, please consult the relevant help page. If you have received a defective or damaged product, please consult the help page on returns and refunds. For specific information on purchases made through marketplaces, consult the marketplace's help page.
8.2 Customer Support
Should you encounter any issues not covered in this manual or require professional assistance, please contact Faber customer support or your authorized dealer. Have your product model number (152 SRM LG A90) and purchase details ready when contacting support.
