Intermatic Cycle Timer Plastic Tripper Pins Instruction Manual

Introduction

This manual provides instructions for the proper use and installation of Intermatic Cycle Timer Plastic Tripper Pins. These pins are essential components for setting the ON/OFF times on compatible Intermatic and Hayward mechanical timers, ensuring automatic operation of connected devices.

Image: A clear plastic bag containing two red and two black Intermatic plastic tripper pins. The Intermatic logo is visible on the bag.

Setup and Compatibility

The Intermatic Tripper Pins are designed for easy installation into compatible mechanical timers. Each package includes two red pins for "ON" settings and two black pins for "OFF" settings.

Compatible Timer Models:

• Intermatic SB Series
• Intermatic HB11, HB111, HB112C, HB113C, HB114C (Indoor)
• Intermatic HB211R (Outdoor)
• Intermatic AL300RTW, AL600TW, AL900TW, AL60TW
• Intermatic 154LV24409
• Intermatic ML Series Heavy Duty Plug-In Appliance Timers
• Hayward SPX1500TZ2 On/off Timer Tripper Pak Replacement for Hayward Unions and Abg Pumps

Image: A close-up of an Intermatic "Heavy Duty Time-All" timer dial, showing a black tripper pin and a red tripper pin inserted into the dial's edge.

Operating Instructions

To set your timer, locate the rotating dial on your compatible Intermatic or Hayward timer. The dial typically has small slots around its perimeter where the tripper pins are inserted.

1. Identify ON/OFF Times: Determine the specific times you want your connected device to turn ON and OFF.
2. Insert Red (ON) Pins: Insert the red tripper pins into the slots on the timer dial corresponding to the desired "ON" times. Ensure the pins are fully seated.
3. Insert Black (OFF) Pins: Insert the black tripper pins into the slots on the timer dial corresponding to the desired "OFF" times. Ensure the pins are fully seated.
4. Verify Settings: Rotate the timer dial manually to observe the pins engaging the internal switch mechanism, confirming they are correctly positioned.

Image: A close-up view of two black and two red Intermatic plastic tripper pins, highlighting their distinct shapes and colors.

Maintenance

These plastic tripper pins require minimal maintenance. Keep them clean and free from debris to ensure proper engagement with the timer mechanism. Store spare pins in a safe place to prevent loss.

Troubleshooting

• Timer Not Activating/Deactivating:
  • Ensure the red (ON) and black (OFF) pins are securely inserted into the timer dial slots.
  • Verify that the pins are positioned at the correct times on the dial.
  • Check if the timer itself is functioning correctly and receiving power.
• Pins Falling Out:
  • Ensure the pins are fully pushed into the slots.
  • Inspect the timer dial slots for any damage or wear that might prevent the pins from holding securely.

Image: An Intermatic timer connected to an air conditioner unit, with a magnified inset showing the red and black tripper pins.

Specifications

Warranty and Support

For specific warranty information regarding Intermatic products, please refer to the documentation provided with your Intermatic timer or visit the official Intermatic website. For technical assistance or customer support, please contact Intermatic directly.

You can find more information and contact details on the Intermatic Store on Amazon.