WONNIE WN-UK612

WONNIE 7.5-inch Portable Dual DVD Player User Manual

Model: WN-UK612

Introduction

Thank you for choosing the WONNIE 7.5-inch Portable Dual DVD Player. This manual provides essential information for setting up, operating, and maintaining your device. Please read it thoroughly before use to ensure optimal performance and longevity of your product. This dual-screen system is designed to provide entertainment for passengers, especially during long car journeys, by playing the same video content on both screens simultaneously.

WONNIE 7.5-inch Portable Dual DVD Player

Image: The WONNIE 7.5-inch Portable Dual DVD Player system, featuring two screens.

Product Overview and Components

Before you begin, please ensure all components are present in the package. The following items are typically included:

Components included with WONNIE DVD Player

Image: Diagram showing all components included in the WONNIE Portable Dual DVD Player package.

  1. DVD Player (Main Unit)
  2. LCD Monitor (Slave Unit)
  3. Headrest Velcro Straps (2 sets)
  4. User Manual
  5. Car Adapter
  6. AC Adapter
  7. AV Cable
  8. DC Input Cable
  9. Signal Cable
  10. Remote Control

Setup

Initial Charging

Before first use, it is recommended to fully charge the main DVD player unit using the provided AC adapter. Connect the AC adapter to the DC IN port on the main unit and plug it into a wall outlet. The charging indicator will show the charging status.

Connecting the Dual Screens

To enable synchronized playback on both screens, connect the main DVD player unit to the slave LCD monitor using the provided DC Input Cable and AV Cable.

  • Connect one end of the DC Input Cable to the DC OUT port on the main DVD player and the other end to the DC IN port on the slave monitor.
  • Connect one end of the AV Cable to the AV OUT port on the main DVD player and the other end to the AV IN port on the slave monitor.
Dual screen connection diagram

Image: Diagram illustrating the connection points for the main DVD player and the slave monitor.

Side view of DVD player with ports labeled

Image: Side view of the DVD player units, showing the DC IN, DC OUT, USB, CARD, AV OUT, AV IN, and EARPHONE ports.

In-Car Installation

Use the provided headrest Velcro straps to securely attach both the main DVD player and the slave monitor to the back of the car seats. Ensure the units are firmly mounted to prevent movement during travel.

DVD players installed in car headrests

Image: The WONNIE dual DVD players installed on car headrests, providing entertainment for rear passengers.

For power in the car, connect the car adapter to the DC IN port of the main unit and plug it into your vehicle's cigarette lighter socket.

Operating Instructions

Power On/Off

Press the POWER button on the main unit or the remote control to turn the device on or off.

Disc Playback

  1. Gently insert a compatible DVD or CD into the disc slot of the main unit. Ensure the disc label faces upwards. Note: Remove any protective film or internal card before inserting a disc.
  2. The player will automatically detect and begin playing the disc.
  3. Use the controls on the unit or the remote control (e.g., PLAY/PAUSE, STOP, NEXT/PREV, VOLUME) to manage playback.
Front view of DVD player with control buttons

Image: Close-up of the main DVD player unit, showing the control buttons (POWER, SET UP, UP, DOWN, OK, LEFT, RIGHT).

USB/SD Card Playback

Insert a USB drive or SD card (up to 32GB) into the respective slot on the main unit. The player supports various media formats including VOB, AVI, MPEG1, MPEG2, XVID, MP3, WMA, and JPEG. Navigate through your files using the UP/DOWN/LEFT/RIGHT and OK buttons on the unit or remote.

270-Degree Rotation

The main DVD player unit features a screen that can rotate up to 270 degrees, allowing you to adjust the viewing angle for optimal comfort.

Break-Point Memory Function

The device is equipped with a break-point memory function, which allows it to resume playback from where it was last stopped, even after the unit has been powered off.

Break-point memory feature illustration

Image: Illustration demonstrating the break-point memory feature, showing the player resuming a movie from the last watched point after being powered off.

Maintenance

Cleaning

  • Use a soft, dry cloth to clean the exterior of the units.
  • For screen cleaning, use a microfiber cloth specifically designed for electronics. Do not use abrasive cleaners or solvents.
  • Keep the disc slot free from dust and debris.

Battery Care

  • To prolong the battery life, it is recommended to charge the device before the battery is completely depleted.
  • Avoid exposing the device to extreme temperatures, which can affect battery performance.
  • If storing the device for an extended period, charge the battery to about 50% and store in a cool, dry place.

General Care

  • Handle the units with care to avoid dropping or impacting them.
  • Keep the device away from water and other liquids.
  • Do not attempt to disassemble or repair the device yourself. Refer to qualified service personnel.

Troubleshooting

If you encounter issues with your WONNIE DVD player, refer to the following common problems and solutions:

ProblemPossible Cause / Solution
No power / Device won't turn onBattery is depleted. Connect the AC adapter or car adapter and charge the unit. Ensure power cables are securely connected.
Disc not playing / Disc errorDisc is dirty or scratched. Clean the disc with a soft cloth. Ensure the disc is inserted correctly with the label facing up. Verify the disc format is supported (CD/DVD/CD-R/RW/VCD). HD/Blu-ray discs are not supported.
No picture on slave monitorAV cable or DC input cable is not properly connected between the main and slave units. Check connections. Note that the pixel resolution of the slave monitor may be lower than the main DVD player due to audio/video transmission.
USB/SD card not recognizedEnsure the USB drive or SD card is formatted correctly and its capacity does not exceed 32GB. Check if the media files are in supported formats (VOB/AVI/MPEG1/MPEG2/XVID, MP3/WMA, JPEG).
No soundVolume is too low or muted. Adjust the volume. Check if headphones are plugged in.
Remote control not workingEnsure there are no obstructions between the remote and the player. Replace the remote control battery if necessary.

Specifications

FeatureDetail
BrandWONNIE
Model NumberWN-UK612
ColorBlack
Screen Size7.5 Inches
Display TypeLCD
Display Resolution1024 x 800
Connectivity TechnologyRCA, USB
Supported Media TypesCD, DVD, CD-R/RW, VCD, USB, SD (up to 32GB)
Supported File FormatsVOB, AVI, MPEG1, MPEG2, XVID, MP3, WMA, JPEG
Special FeaturesMulti-region, Last Memory Function (Break-point Memory), Built-in Rechargeable Battery, Synchronized Dual Screen Playback, Anti-shock Function, 270-degree Screen Rotation
Battery CompositionLithium-ion

Warranty and Support

Your WONNIE Portable Dual DVD Player comes with a 12-month warranty from the date of purchase. This warranty covers manufacturing defects and ensures the quality of your product.

If you encounter any problems or have questions regarding your device, please do not hesitate to contact WONNIE customer support. You can reach us via Amazon message or through our after-sales mailbox. We are committed to providing the best service to our customers.

© 2024 WONNIE. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.