1. Introduction
This manual provides essential information for the safe and efficient use of your Hitachi CV950 Cylinder Vacuum Cleaner. Please read these instructions thoroughly before operating the appliance and retain them for future reference. The Hitachi CV950 is designed for effective cleaning of various surfaces, featuring a powerful 2000W motor and an 18-liter dust capacity.

Figure 1: Main unit of the Hitachi CV950 Cylinder Vacuum Cleaner.
2. Safety Information
Always observe basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and personal injury.
- Ensure the power supply voltage matches the rating label on the vacuum cleaner.
- Do not use the vacuum cleaner on wet surfaces or to pick up liquids.
- Do not pick up flammable or combustible materials, hot ashes, or sharp objects.
- Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts.
- Unplug from the outlet when not in use and before servicing.
- Do not operate with a damaged cord or plug.
- This appliance is for indoor use only.
3. Package Contents
Verify that all components are present in the package:
- Hitachi CV950 Cylinder Vacuum Cleaner Main Unit
- Flexible Hose
- Extension Pipe
- Floor Nozzle
- Crevice Tool
- Dusting Brush
- Cloth Filter (pre-installed)
- User Manual
4. Setup
Follow these steps to assemble your vacuum cleaner before first use:
- Attach the Flexible Hose: Insert the hose end into the suction inlet on the main unit until it clicks securely into place.
- Connect Extension Pipe and Nozzle: Attach the extension pipe to the handle end of the flexible hose. Then, connect the desired cleaning nozzle (e.g., floor nozzle) to the end of the extension pipe.
- Power Connection: Extend the power cord and plug it into a suitable electrical outlet (220V).

Figure 2: Detail of the hose connection to the main unit.
5. Operating Instructions
To operate your Hitachi CV950 vacuum cleaner:
- Power On: Press the ON/OFF button located on the main unit to start the vacuum cleaner.
- Adjust Suction Power: If available, adjust the suction power using the control dial or slider on the unit or hose handle.
- Cleaning Surfaces: Use the appropriate nozzle for the surface you are cleaning. The floor nozzle is suitable for carpets and hard floors. The crevice tool is for narrow spaces, and the dusting brush for delicate surfaces.
- Blower Function: To use the blower function, detach the hose from the suction inlet and attach it to the blower outlet (refer to the diagram on the unit if unsure). This function is useful for blowing away dust from hard-to-reach areas.
- Power Off: After cleaning, press the ON/OFF button to turn off the vacuum cleaner and unplug it from the power outlet.

Figure 3: Extension pipe with a brush attachment for versatile cleaning.
6. Maintenance
Regular maintenance ensures optimal performance and extends the life of your vacuum cleaner.
6.1. Emptying the Dust Container
- The dust indicator will show when the dust container is full and needs emptying.
- Unplug the vacuum cleaner.
- Open the lid of the main unit and carefully remove the dust container.
- Empty the collected dust into a waste bin.
- Reinsert the dust container and close the lid securely.
6.2. Cleaning the Cloth Filter
- The cloth filter should be cleaned regularly, especially when suction power decreases.
- Unplug the vacuum cleaner and remove the dust container.
- Carefully remove the cloth filter.
- Shake off loose dust or gently brush it clean. If heavily soiled, hand wash the filter in lukewarm water without detergent.
- Allow the filter to air dry completely before reinserting. Do not use the vacuum cleaner without a dry filter.
6.3. General Cleaning
- Wipe the exterior of the vacuum cleaner with a soft, damp cloth. Do not use abrasive cleaners.
- Check nozzles and hoses for blockages and remove any debris.
7. Troubleshooting
Refer to the table below for common issues and their solutions.
| Problem | Possible Cause | Solution |
|---|---|---|
| Vacuum cleaner does not start | No power supply; Power switch off | Check power cord connection; Press ON/OFF switch |
| Low suction power | Dust container full; Filter clogged; Hose/nozzle blocked | Empty dust container; Clean/replace filter; Remove blockage |
| Unusual noise | Foreign object in hose/nozzle; Motor issue | Check and remove foreign objects; Contact service center |
If the problem persists after attempting these solutions, please contact Hitachi customer support.
8. Specifications
| Feature | Specification |
|---|---|
| Brand | Hitachi |
| Model Name | CV-950 |
| Power Source | Corded Electric |
| Voltage | 220 Volts |
| Motor Power | 2000 Watts |
| Dust Capacity | 18 Liters |
| Filter Type | Cloth Filter |
| Special Feature | Blower Function, Spotless Cleaning |
| Recommended Surface | Carpet, Hardwood Floors |
| Noise Level | 80 dB |
| Item Weight | 8.42 Kilograms |
| Product Dimensions (LxWxH) | 42 x 33.5 x 54.5 cm |
| Color | Grey |

Figure 4: Internal motor components, highlighting the 2000W power unit.
9. Warranty and Support
This product is covered by a manufacturer's warranty. For specific warranty terms and conditions, please refer to the warranty card included with your purchase or visit the official Hitachi website. Extended warranty plans may also be available for purchase.
9.1. Protection Plans
Additional protection plans are available to cover accidental damages or extend the warranty period. These plans typically offer:
- 2-year accidental damage protection plan for floor care.
- 1-year extended warranty plan for floor care.
- 2-year extended warranty plan for floor care.
Details regarding coverage and pricing for these plans can be found at the point of purchase or by contacting your retailer.
9.2. Customer Support
For technical assistance, spare parts, or service inquiries, please contact Hitachi customer support through their official channels. You can find contact information on the Hitachi website or in your product documentation.