Introduction
This manual provides comprehensive instructions for the setup, operation, maintenance, and troubleshooting of your Karlsson Digital Alarm Clock, model KA5805BK. Please read this manual carefully before using the product to ensure proper functionality and longevity.

Figure 1: Front view of the Karlsson Digital Alarm Clock KA5805BK, displaying time, day, date, and temperature in a hexagonal design.
Setup
1. Battery Installation
The Karlsson Digital Alarm Clock KA5805BK operates on 3 AA batteries (not included). For optimal performance, use high-quality alkaline batteries.
- Locate the battery compartment on the back of the alarm clock.
- Open the battery compartment cover by sliding or lifting it.
- Insert 3 AA batteries, ensuring the correct polarity (+ and -) as indicated inside the compartment.
- Close the battery compartment cover securely.

Figure 2: Back view of the alarm clock, highlighting the battery compartment and wall mounting points.
2. Initial Power On
Once batteries are installed, the display should illuminate, and the clock will typically start in a default time setting. You may need to press a button to activate the display if it does not turn on automatically.
Operating Instructions
The Karlsson Digital Alarm Clock features intuitive controls, usually located on the back or side of the unit. Specific button functions may vary slightly, but common operations are described below.
1. Setting the Time
To set the current time:
- Locate the "SET" or "MODE" button. Press and hold it until the time display starts flashing.
- Use the "UP" or "DOWN" buttons (often labeled "+" or "-") to adjust the hours.
- Press "SET" or "MODE" again to move to minutes, then adjust using "UP" or "DOWN".
- Continue this process for setting the year, month, and day if applicable.
- Press "SET" or "MODE" one last time to confirm and exit the setting mode.
2. 12-Hour / 24-Hour Format
The clock supports both 12-hour (AM/PM) and 24-hour time formats. To switch between formats, look for a dedicated "12/24H" button or cycle through modes using the "MODE" button until the option appears. Adjust with "UP" or "DOWN" buttons.
3. Setting the Alarm
To set an alarm:
- Press the "ALARM" or "MODE" button until the alarm time display flashes.
- Use "UP" or "DOWN" buttons to set the desired alarm hour.
- Press "ALARM" or "MODE" again to move to minutes, then adjust.
- Confirm by pressing "ALARM" or "MODE" one last time.
- To activate or deactivate the alarm, there is usually a dedicated switch or button (e.g., "ALARM ON/OFF"). An alarm icon will typically appear on the display when active.
4. Temperature Display
The clock features a built-in temperature display. This display is usually automatic and cycles with the time and date. No specific action is typically required to view the temperature.
Maintenance
1. Cleaning
To clean your alarm clock, gently wipe the surface with a soft, dry cloth. Do not use abrasive cleaners, solvents, or chemical sprays, as these can damage the finish and electronic components.
2. Battery Replacement
When the display dims or the clock functions become erratic, it is time to replace the batteries. Follow the battery installation steps outlined in the "Setup" section. Always replace all 3 AA batteries at the same time with new ones.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Display is blank or dim. | Batteries are low or incorrectly installed. | Replace batteries with new ones, ensuring correct polarity. |
| Clock loses time or functions erratically. | Low battery power. | Replace batteries. Ensure the clock is not exposed to extreme temperatures. |
| Alarm does not sound. | Alarm is not activated or set incorrectly. | Verify alarm time and ensure the alarm function is turned ON. Check battery level. |
| Buttons are unresponsive. | Temporary electronic glitch or very low batteries. | Remove and reinsert batteries to perform a soft reset. Replace batteries if necessary. |
Specifications
- Brand: Karlsson
- Model Number: KA5805BK
- Color: Brown
- Product Dimensions (L x W x H): 18.9 x 3.81 x 14.1 cm
- Weight: 280 grams
- Material: Plastic, Plastic Plastic Rubber
- Features: Temperature display, 12h/24h indication, Alarm function
- Power Source: Battery powered (3 x AA batteries)
- Display Type: Digital
- Style: Design
- Shape: Square (hexagonal arrangement)
Warranty and Support
Warranty information for your Karlsson Digital Alarm Clock KA5805BK is typically provided at the point of purchase or can be found on the official Karlsson website. Please retain your proof of purchase for warranty claims.
For further support, technical assistance, or inquiries regarding spare parts, please refer to the contact information provided by your retailer or visit the official Karlsson brand website. Information regarding spare parts availability for this specific model is currently unavailable.





