Passion-Electro Replacement Remote Control for TRIAX THR 9600 HD

1. Introduction

This manual provides instructions for the Passion-Electro replacement remote control designed for the TRIAX THR 9600 HD receiver. This remote control is a specialized replacement, not a generic universal remote, and is engineered to provide full functionality equivalent to the original remote control.

Image 1.1: Overview of the remote control. The button layout is designed for intuitive use with the TRIAX THR 9600 HD.

No programming is required for this remote control. Simply insert the batteries, and it is ready for immediate use.

2. Setup

2.1 Battery Installation

The remote control requires two (2) AAA 1.5V batteries (LR03-AAA). Batteries are not included with the remote control and must be purchased separately.

1. Locate the battery compartment on the back of the remote control.
2. Slide the battery compartment cover downwards or in the direction indicated by an arrow to open it.
3. Insert two AAA batteries, ensuring that the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
4. Replace the battery compartment cover by sliding it back into position until it clicks securely.

Image 2.1: Rear view of the remote control, highlighting the battery compartment. Ensure correct battery polarity during installation.

Important: Always use new batteries and replace both batteries at the same time. Do not mix old and new batteries or different types of batteries.

3. Operating Instructions

Once batteries are installed, the remote control is ready to operate your TRIAX THR 9600 HD receiver. Point the remote control directly at the receiver during use.

3.1 Basic Functions

• Power Button: Press to turn the receiver ON or OFF.
• Number Buttons (0-9): Use to directly select channels or input numerical values.
• Channel Up/Down: Navigate through channels sequentially.
• Volume Up/Down: Adjust the audio output level.
• Mute Button: Temporarily silence the audio.
• Navigation Buttons (Up, Down, Left, Right, OK): Used to navigate menus and confirm selections.
• Menu Button: Access the main menu of the receiver.
• Exit Button: Exit current menu or function.
• Info Button: Display program information.
• Colored Buttons (Red, Green, Yellow, Blue): These buttons correspond to specific functions within menus or interactive services, as indicated on your TV screen.

Image 3.1: Front view of the remote control, illustrating key operational buttons.

3.2 LED Indicator

The remote control features an LED indicator, typically located near the top. This LED will illuminate briefly with each button press, confirming that a signal is being transmitted.

4. Maintenance

4.1 Cleaning

To clean the remote control, use a soft, dry cloth. For stubborn dirt, slightly dampen the cloth with water or a mild, non-abrasive cleaner. Do not use harsh chemicals, solvents, or abrasive cleaning pads, as these can damage the remote's surface or internal components.

4.2 Storage

When not in use for extended periods, it is recommended to remove the batteries to prevent leakage, which can damage the remote control. Store the remote in a cool, dry place away from direct sunlight and extreme temperatures.

5. Troubleshooting

• Remote control not responding:
  • Check if the batteries are inserted correctly with the correct polarity.
  • Replace old batteries with new AAA batteries.
  • Ensure there are no obstructions between the remote control and the TRIAX THR 9600 HD receiver.
  • Make sure you are within the effective operating range (up to 10 meters).
• LED indicator not lighting up:
  • This usually indicates dead or incorrectly inserted batteries. Follow the steps above to check and replace batteries.
• Certain functions not working:
  • While this remote is designed for full compatibility, ensure the function you are trying to use is supported by your specific TRIAX THR 9600 HD model.
  • If the issue persists, contact customer support.

6. Specifications

7. Support

For further assistance or inquiries regarding your Passion-Electro replacement remote control, please contact the manufacturer or your retailer. Please have your product model (TRIAX THR 9600 HD) and ASIN (B07PWLZ8WG) available when seeking support.