Summer Waves P57100102 Type D Pool Filter Cartridge Instruction Manual

1. Product Overview

The Summer Waves P57100102 Type D Filter Cartridge is designed to maintain clean and clear water in your swimming pool or compatible portable spa. This disposable cartridge effectively captures debris and impurities, ensuring optimal filtration performance. Regular replacement is crucial for water quality and pump longevity.

Image 1.1: Summer Waves Type D Pool Filter Cartridge.

2. Setup and Installation

1. Power Off: Ensure your pool pump or spa filter system is completely turned off and unplugged before beginning installation.
2. Access Filter Housing: Open the filter housing according to your pump or spa's specific instructions. This usually involves unscrewing a cap or opening a latch.
3. Remove Old Cartridge: Carefully remove the used filter cartridge. Dispose of it properly.
4. Insert New Cartridge: Place the new Summer Waves Type D filter cartridge into the housing, ensuring it sits correctly and securely.
5. Secure Housing: Close and secure the filter housing. Make sure all seals are properly seated to prevent leaks.
6. Restore Power: Plug in and turn on your pool pump or spa filter system. Check for any leaks.

This filter cartridge is compatible with Summer Waves pool pumps and certain portable spa filter systems that require a Type D filter.

3. Operating Instructions

Once installed, the filter cartridge will continuously filter your pool or spa water during pump operation. For optimal water clarity and hygiene, it is recommended to operate your filter system for several hours daily, or as advised by your pool/spa manufacturer.

Monitor your water clarity regularly. A decrease in water flow or clarity indicates that the filter cartridge may be dirty and require cleaning or replacement.

4. Maintenance

To extend the life of your filter cartridge and maintain water quality, periodic cleaning is recommended. While these cartridges are disposable, a quick rinse can temporarily improve performance.

Cleaning the Filter Cartridge:

1. Power Off: Always turn off and unplug the pump before handling the filter.
2. Remove Cartridge: Take out the dirty filter cartridge from its housing.
3. Rinse: Use a garden hose with a strong spray nozzle to rinse off accumulated debris from the pleats of the cartridge. Work from top to bottom, ensuring all visible dirt is removed.
4. Reinstall: Once rinsed, reinstall the cartridge as per the setup instructions.

Replacement: For best results and water quality, replace the filter cartridge every two weeks, or more frequently if the pool/spa is heavily used or water clarity deteriorates rapidly, even after rinsing.

5. Troubleshooting

• Cloudy Water: If your pool or spa water remains cloudy despite regular filtration, check the filter cartridge. It may be clogged and require thorough cleaning or immediate replacement. Ensure proper chemical balance in your water.
• Reduced Water Flow: A noticeable reduction in water flow from your pump indicates a clogged filter. Perform maintenance as described in Section 4.
• Leaks from Filter Housing: If you observe leaks, turn off the pump immediately. Recheck the installation of the filter cartridge and ensure the housing lid is securely fastened with all O-rings or gaskets properly seated.

6. Specifications

7. Warranty and Support

For specific warranty information regarding your Summer Waves P57100102 Type D Filter Cartridge, please refer to the packaging or contact Summer Waves customer support directly. As a disposable item, warranty coverage typically applies to manufacturing defects upon purchase.

For further assistance or inquiries, please visit the official Summer Waves website or consult your product retailer.