Air Hogs Zero Gravity Light Wall Racer Instruction Manual

Introduction

The Air Hogs Zero Gravity Light Wall Racer utilizes patented Wall Climber Technology to operate on various smooth surfaces, including floors, walls, and ceilings. This lightweight vehicle is guided by an LED light beam from its controller, allowing for precise movement and control. This manual provides essential information for setup, operation, maintenance, and troubleshooting to ensure a safe and enjoyable experience.

Package Contents

Ensure all items are present before beginning setup:

• 1 Zero Gravity Light Vehicle
• 1 Controller
• 1 USB Charging Cable
• 1 Instruction Guide

Image: The Air Hogs Zero Gravity Light vehicle, its controller, and the USB charging cable are displayed on a flat surface, illustrating the complete package contents.

Setup

1. Charging the Vehicle

The Zero Gravity Light vehicle is equipped with a USB rechargeable battery. Use the provided USB charging cable to charge the vehicle. Connect the small end of the USB cable to the charging port on the vehicle and the other end to a standard USB power source (e.g., computer, USB wall adapter). The charging indicator light on the vehicle will show its status. A full charge typically provides approximately 15-20 minutes of play time.

Image: A close-up view of the blue Air Hogs Zero Gravity Light vehicle, highlighting the USB charging port located on its rear side.

2. Installing Controller Batteries

The controller requires 3 AAA batteries (not included). Open the battery compartment on the back of the controller, insert the batteries according to the polarity indicators, and close the compartment securely.

Operating Instructions

1. Powering On

Turn on the vehicle using the power switch located on its underside. Turn on the controller using its power switch.

2. Selecting Driving Mode

The vehicle features patented Wall Climber Technology. A switch on the vehicle allows you to select between "Ground Mode" and "Wall Mode".

• Ground Mode: For driving on flat floor surfaces.
• Wall Mode: Activates the vacuum technology, allowing the vehicle to adhere to and drive on smooth vertical surfaces (walls) and even ceilings. Ensure the surface is clean and smooth for optimal adhesion.

3. Laser-Guided Control

Use the controller's built-in LED light gun to direct the vehicle. Point the light beam on any smooth surface (floor, wall, or ceiling) within a 1-foot radius of the vehicle. The Zero Gravity Light will chase the light in the direction you point it. The multi-direction control allows for sharp turns and spins.

Image: A child aims the laser controller at the floor, guiding the blue Air Hogs Zero Gravity Light vehicle as it follows the red laser dot.

Image: The blue Air Hogs Zero Gravity Light vehicle is shown driving vertically up a light-colored wall, demonstrating its wall-climbing capability.

Important Safety Information

• CHOKING HAZARD: Small parts. Not for children under 3 years.
• For indoor use only.
• Avoid driving on rough or textured surfaces, as this may affect wall-climbing performance and potentially damage the vehicle.
• Do not expose the vehicle or controller to water or excessive moisture.
• Always supervise children during play.

Specifications

Troubleshooting

• Vehicle not climbing walls: Ensure the vehicle is in "Wall Mode" and the surface is smooth, clean, and free of debris or textures (like grout lines). Check if the battery is fully charged.
• Vehicle not responding to controller: Check if both the vehicle and controller are powered on. Ensure the controller has fresh AAA batteries. Make sure the laser beam is pointed within a 1-foot radius of the vehicle.
• Short play time: The vehicle's battery provides approximately 15-20 minutes of play. Ensure it is fully charged before each use.

Warranty and Support

This product is covered by the Spin Master Care Commitment. If you encounter a problem with a Spin Master product purchased from an authorized seller, Spin Master will resolve it. The Care Commitment is limited to the original end-user purchaser and may require proof of purchase and/or a picture of your product to verify eligibility. Spin Master reserves the right to verify information and deny requests at its discretion.

Official Product Video