Fishman Rare Earth Bajo Quinto Soundhole Pickup

Introduction

The Fishman Rare Earth Bajo Quinto Soundhole Pickup (Model PRO-REP-BQ1) is a high-quality humbucking pickup designed specifically for Bajo Quinto instruments. Featuring cutting-edge neodymium magnets, it delivers a warm, full tone with exceptional accuracy and increased musicality. The stacked coils effectively eliminate noise, and an integrated volume control wheel allows for easy, accessible adjustments during performance.

Product Overview

Image: The Fishman Rare Earth Bajo Quinto Soundhole Pickup, showcasing its compact design and integrated volume control. The pickup is designed to fit securely within the soundhole of a Bajo Quinto instrument.

Setup

1. Unpacking: Carefully remove the pickup from its packaging. Inspect for any visible damage.
2. Preparation: Ensure your Bajo Quinto is clean and free of debris around the soundhole area. Loosen the strings slightly to allow access to the soundhole.
3. Installation: Gently slide the pickup into the soundhole, positioning it between the strings and the soundboard. The cork-lined clamps on the pickup should rest against the edges of the soundhole.
4. Securing the Pickup: Tighten the two screws on the pickup to secure it firmly in place. Do not overtighten, as this may damage the instrument or the pickup.
5. Cable Connection: Route the output cable from the pickup to your amplifier, mixer, or audio interface.

Operating Instructions

1. Power On: Connect your instrument to an amplifier or PA system and power it on.
2. Volume Control: Use the integrated volume control wheel on the pickup to adjust the output level. Start with a low volume and gradually increase it to your desired level.
3. Tone Adjustment: The Rare Earth pickup is designed for a balanced tone. Further tone shaping can be done using the EQ controls on your amplifier or mixer.
4. Noise Reduction: The stacked coil design inherently reduces hum and noise. Ensure proper grounding of your audio equipment for optimal performance.

Maintenance

• Cleaning: Wipe the pickup gently with a soft, dry cloth to remove dust and grime. Avoid using abrasive cleaners or solvents.
• Cable Care: Avoid sharp bends or kinks in the output cable to prevent internal damage.
• Storage: When not in use for extended periods, store the pickup in a cool, dry place, preferably in its original packaging or a protective case.

Troubleshooting

• No Sound:
  • Check all cable connections between the pickup, amplifier, and power source.
  • Ensure the amplifier is powered on and its volume is not set to zero.
  • Verify the pickup's volume wheel is not set to minimum.
• Hum or Buzz:
  • Ensure all audio equipment is properly grounded.
  • Move away from sources of electromagnetic interference (e.g., fluorescent lights, computer monitors).
  • Check for loose connections in the signal chain.
• Weak Output:
  • Increase the pickup's volume using the control wheel.
  • Check the input gain settings on your amplifier or mixer.

Specifications

Relevant Product Videos

Warranty and Support

For specific warranty information and technical support, please refer to the official Fishman website or contact their customer service directly. Product registration may be required for warranty claims.