Introduction
This manual provides essential information for the safe and effective operation, maintenance, and troubleshooting of your NorthStar 16-Gallon ATV Spot Sprayer. Please read this manual thoroughly before assembly, setup, or operation to ensure proper use and to prevent injury or damage.
Safety Information
Always observe safety precautions when operating this equipment. Failure to do so may result in serious injury or property damage.
- Read and understand all instructions before use.
- Wear appropriate personal protective equipment (PPE), including eye protection, gloves, and protective clothing, especially when handling chemicals.
- Ensure the sprayer is securely mounted to your ATV or vehicle before operation.
- Do not spray flammable liquids.
- Keep children and pets away from the sprayer during operation and storage.
- Disconnect power before performing any maintenance or cleaning.
Product Overview
The NorthStar 16-Gallon ATV Spot Sprayer is designed for efficient application of various liquids. Key features include:
- 12V, 2.2 GPM NorthStar NSQ Series quick-connect on-demand pump: Generates 70 PSI for consistent spray.
- Patented DXS-3 pump valves: Made with chemical-resistant Viton for faster priming, better performance, and extended life.
- Santoprene diaphragm: Offers superior reliability and chemical resistance.
- Regulator and pressure gauge: Allows for fine-tuning of spray pressure.
- Deluxe trigger spray gun: Features an adjustable stream-to-cone brass nozzle.
- 15 feet of hose: Provides extended reach for various spraying tasks.
Figure 1: NorthStar 16-Gallon ATV Spot Sprayer. This image shows the complete sprayer unit, including the white tank, black pump housing, and the spray gun with its wand.
Figure 2: Sprayer with hose and gun. This view highlights the 15-foot hose coiled on the side of the tank and the deluxe trigger spray gun with its adjustable nozzle.
Figure 3: Close-up of the pump and regulator. This image details the 12V pump, pressure gauge, and regulator for precise control over spray output.
Setup
- Mounting: Securely place the sprayer unit in the cargo bed of your ATV or other suitable vehicle. Use straps or bungee cords through the designated tie-down points on the tank to prevent movement during transport and operation.
- Power Connection: Connect the 12V power leads from the sprayer pump to a compatible 12V power source on your ATV. Ensure a secure connection to prevent power interruptions.
- Hose Connection: Connect the spray gun hose to the pump outlet. Ensure all connections are tight to prevent leaks.
- Wand Storage: Utilize the integrated clips on the sprayer tank to secure the spray gun wand when not in use, preventing it from flopping around during transit.
Operating Instructions
- Filling the Tank: Unscrew the large cap on top of the tank. Carefully pour the desired liquid into the 16-gallon tank. Ensure the liquid is compatible with the sprayer components. Securely fasten the cap after filling.
- Activating the Pump: Turn on the 12V power to the sprayer pump. The pump is on-demand and will activate when the spray gun trigger is pressed.
- Adjusting Pressure: Use the pressure regulator and gauge located on the pump assembly to set the desired spray pressure. Adjust clockwise to increase pressure and counter-clockwise to decrease.
- Using the Spray Gun: Press the trigger on the deluxe spray gun to begin spraying. The brass nozzle can be adjusted by twisting it to change the spray pattern from a fine mist to a solid stream.
- Hose Management: The 15-foot hose allows for extended reach. When finished, coil the hose neatly around the integrated hooks on the sprayer unit.
Maintenance
- Cleaning the Tank: After each use, especially when using chemicals, thoroughly rinse the tank with clean water. Utilize the drain plug for complete drainage.
- Pump and Hose Flush: Run clean water through the pump and hose system for several minutes to remove any chemical residue.
- Nozzle Cleaning: Periodically check the spray gun nozzle for clogs and clean as needed.
- Storage: Store the sprayer in a clean, dry place, protected from freezing temperatures. For extended storage, ensure the system is completely drained and dry.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Pump does not run | No power, loose connection, blown fuse | Check 12V power source, tighten connections, replace fuse if necessary. |
| Low or no pressure | Clogged nozzle, kinked hose, low liquid level, air in system | Clean nozzle, straighten hose, refill tank, prime pump by running water through. |
| Leaking connections | Loose fittings, damaged O-rings/seals | Tighten all fittings, inspect and replace O-rings/seals if damaged. |
Specifications
- Brand: NorthStar
- Tank Volume: 16 Gallons
- Pump: 12V, 2.2 GPM NorthStar NSQ Series
- Maximum Pressure: 70 PSI
- Hose Length: 15 Feet
- Nozzle: Adjustable stream-to-cone brass nozzle
- Material: Brass, Viton (for pump valves)
- Item Weight: 26.2 Pounds
- Package Dimensions: 27 x 19 x 15.5 inches
- Model Name: ATV Spot Sprayer
- Item Model Number: 4ce029a9-d947-43e4-8d75-b799c7e70acf
Warranty and Support
For warranty information or technical support, please refer to the documentation included with your purchase or contact NorthStar customer service directly. Keep your proof of purchase for warranty claims.
