Superer ADP190632

Superer 120W AC Charger Instruction Manual

For Asus Zenbook Flip Q535UD, Q536FD, Q546FDX, Q547FD Series Laptops

Model: ADP190632

1. Introduction

This manual provides essential instructions for the safe and effective use of your Superer 120W AC Charger. Please read this guide thoroughly before using the product to ensure optimal performance and longevity. This charger is designed to provide reliable power to compatible Asus Zenbook Flip laptops.

Superer 120W AC Charger and power cord

Image 1.1: Superer 120W AC Charger with power cord.

2. Safety Information

Your Superer AC Charger is equipped with multiple safety features to protect your device and ensure safe operation. Adhere to the following guidelines:

  • Do not expose the charger to liquids or extreme temperatures.
  • Avoid dropping or subjecting the charger to severe impacts.
  • Ensure proper ventilation around the charger during use to prevent overheating.
  • Use only with compatible devices as specified in this manual.
  • Disconnect the charger from the power outlet when not in use for extended periods.
Diagram illustrating multiple safety protections: Overheating, Overvoltage, Electrostatic, Short Circuit, Overcurrent, and Overcharge Protection.

Image 2.1: Built-in safety protections of the Superer AC Charger.

3. Compatibility

This Superer AC Charger is specifically designed for the following Asus Zenbook Flip laptop models:

  • Asus Zenbook Flip Q535UD, Q535U, Q535
  • Asus Zenbook Flip Q536FD, Q536F, Q536, Q536FD-BI7T15
  • Asus Zenbook Flip Q546FDX, Q546FD, Q546F, Q546
  • Asus Zenbook Flip Q547FD, Q547F, Q547

The charger features a 4.5mm x 3.0mm round connector. Please verify your laptop's charging port type and power requirements before use.

Diagram showing compatible 4.5mm x 3.0mm charging port and incompatible 5.5mm x 2.5mm port.

Image 3.1: Correct charging port type (4.5mm x 3.0mm) for compatibility.

Compatibility table showing 19V 6.32A 120W as compatible, and other voltage/wattage combinations as incompatible.

Image 3.2: Power specifications and compatibility check.

4. Setup Instructions

  1. Unpack the Charger: Carefully remove the AC adapter and power cord from the packaging.
  2. Connect the Power Cord: Insert the AC power cord into the adapter's input port. Ensure it is firmly seated.
  3. Connect to Power Outlet: Plug the AC power cord into a standard wall outlet (100-240V, 50-60Hz).
  4. Connect to Laptop: Insert the round connector tip of the adapter into your laptop's charging port.
  5. Verify Connection: Confirm that the charging indicator light on your laptop (if available) illuminates, indicating a successful connection and charging process.

5. Operating Instructions

Once connected, the charger will automatically begin supplying power to your laptop and charging its battery. The charger is designed to provide a consistent and stable power supply.

Superer AC Charger connected to a laptop and wall outlet, providing consistent power.

Image 5.1: Charger providing consistent power to a laptop.

6. Maintenance

  • Keep the charger and cables clean and free from dust. Use a soft, dry cloth for cleaning.
  • Store the charger in a cool, dry place when not in use.
  • Avoid tightly bending or twisting the cables, especially near the connectors, to prevent damage.
  • Regularly inspect the cables and connectors for any signs of wear or damage. Discontinue use if damage is observed.

7. Troubleshooting

ProblemPossible CauseSolution
Laptop not chargingLoose connection, incompatible device, faulty outlet, damaged charger.Ensure all connections are secure. Verify laptop compatibility. Try a different power outlet. Inspect charger for damage.
Charger overheatingPoor ventilation, excessive load, internal fault.Ensure adequate airflow around the charger. Disconnect and allow to cool. If problem persists, discontinue use and contact support.
Loose fit in laptop portIncorrect port size, worn port, charger tip damage.Confirm port type (4.5mm x 3.0mm). If port is worn, consider laptop service. If charger tip is damaged, replace charger.

8. Specifications

FeatureDetail
Model NumberADP190632
Input Voltage100-240V ~ 50-60Hz
Output Voltage19V
Output Current6.32A
Wattage120W
Connector TypeRound Connector (4.5mm x 3.0mm)
Cable LengthTotal 10 Ft (Adapter cord 6 Ft + Power cord 4 Ft)
Product Dimensions3.15 x 1.57 x 3.94 inches
Item Weight1.34 pounds
Special FeaturesOvercharge Protection, Robust and Drop-Proof, Short Circuit Protection
Diagram showing the dimensions of the Superer AC Charger: 6.26 inches length, 2.99 inches width, 1.05 inches height.

Image 8.1: Item dimensions of the Superer AC Charger.

9. Warranty and Support

Superer provides comprehensive after-sales services for this product:

  • 30-Day Refund: This product is eligible for replacement or returns within 30 days of purchase.
  • 12-Month Assurance: The manufacturer provides an additional 12 months of assurance for quality-related issues.

For any questions, concerns, or support needs, please contact Superer customer service through the retailer where the product was purchased. Please have your model number (ADP190632) and purchase date available.

Graphic illustrating positive customer support with 12 months replacement service and 30 days refund policy.

Image 9.1: Superer after-sales service details.

© 2026 Superer. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.