1. Introduction
Thank you for choosing the Candy CBT6130/3X Telescopic Hood. This appliance is designed to effectively remove cooking fumes and odors from your kitchen, providing a cleaner and more comfortable cooking environment. Its telescopic design allows it to be discreetly integrated into your kitchen cabinetry, extending only when in use. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your new hood.
This image shows the Candy CBT6130/3X telescopic hood in its extended position, revealing the stainless steel front panel and the metal grease filters.
2. Important Safety Instructions
Please read all instructions carefully before using the appliance. Keep this manual for future reference.
- Ensure the electrical installation complies with local regulations and is properly grounded.
- Do not operate the hood with wet hands or bare feet.
- Regularly clean the grease filters to prevent fire hazards.
- Do not flambé under the range hood.
- Ensure adequate ventilation in the room when the hood is used simultaneously with gas or other fuel-burning appliances.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Disconnect the appliance from the power supply before any cleaning or maintenance.
3. Setup and Installation
The Candy CBT6130/3X is designed for built-in or under-cabinet installation. Professional installation is recommended to ensure proper functioning and safety.
3.1 Unpacking
Carefully remove the hood from its packaging. Inspect the appliance for any signs of damage during transit. Ensure all components listed below are present.
3.2 Included Components
- Telescopic Hood Unit
- Metal Grease Filters
- Installation Material (screws, brackets, etc.)
- Active Carbon Filters (pre-installed or separate for recirculation mode)
3.3 Mounting
Refer to the detailed installation diagram provided with the physical product for precise measurements and mounting instructions. Ensure the hood is securely fastened to the cabinet or wall structure. For recirculation mode, ensure the carbon filters are correctly installed and air outlets are unobstructed.
This image provides an angled view of the hood's underside, highlighting the removable metal grease filters and the internal structure, which is relevant for installation and maintenance.
4. Operating Instructions
Your Candy telescopic hood is designed for ease of use with intuitive controls.
4.1 Control Panel
The hood features tactile controls located on the front panel. These controls allow you to manage the fan speed and lighting.
This image displays a detailed view of the hood's control panel, featuring the tactile buttons for adjusting fan speed and activating the LED lighting.
4.2 Telescopic Function
To activate the hood, gently pull the front panel outwards. This action will automatically turn on the fan and lights. Push the panel back in to retract the hood and turn it off.
4.3 Fan Speed Adjustment
The hood offers 2 fan speeds. Use the dedicated buttons on the control panel to select the desired extraction power. A higher speed is recommended for intense cooking, while a lower speed is suitable for lighter tasks.
4.4 Lighting
Press the light button on the control panel to turn the integrated LED lighting on or off. The LED lights provide illumination for your cooking area.
This image shows the Candy telescopic hood installed above a cooking hob in a kitchen setting, demonstrating its function by extracting steam from a pot.
5. Maintenance and Cleaning
Regular maintenance ensures the longevity and optimal performance of your hood.
5.1 Cleaning the Exterior
Clean the exterior surfaces of the hood with a soft cloth dampened with mild detergent. Do not use abrasive cleaners or corrosive products, as they can damage the stainless steel finish.
5.2 Cleaning/Replacing Grease Filters
The metal grease filters should be cleaned regularly (approximately every 2 months, or more frequently with heavy use) to maintain extraction efficiency and prevent fire hazards. The filters can be washed by hand with hot water and mild detergent, or in a dishwasher on a low-temperature cycle. Allow them to dry completely before re-installing.
This image provides an angled view of the hood's underside, highlighting the removable metal grease filters, which are essential for regular cleaning and maintenance.
5.3 Replacing Carbon Filters (for Recirculation Mode)
If your hood operates in recirculation mode, the active carbon filters absorb odors and should be replaced approximately every 3-6 months, depending on usage. Refer to the product's specific instructions for carbon filter replacement.
5.4 Replacing LED Lights
LED lights have a long lifespan. If a light needs replacement, consult a qualified technician or refer to the specific instructions provided with the product for safe replacement procedures.
6. Troubleshooting
Before contacting customer service, please check the following common issues and their solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Hood does not turn on. | No power supply; Hood not extended; Fuse tripped. | Check power connection; Fully extend the hood; Check household fuse/circuit breaker. |
| Poor extraction performance. | Grease filters clogged; Carbon filters saturated; Insufficient room ventilation. | Clean grease filters; Replace carbon filters; Ensure adequate air intake in the kitchen. |
| Excessive noise. | Filters incorrectly installed; Foreign object in fan; Loose mounting. | Re-install filters correctly; Inspect fan for obstructions (unplug first); Check mounting screws. |
| LED lights not working. | Light switch off; Faulty LED module. | Ensure light switch is on; Contact qualified technician for replacement. |
7. Technical Specifications
Below are the key technical specifications for the Candy CBT6130/3X Telescopic Hood:
| Feature | Value |
|---|---|
| Model | CBT6130/3X |
| Model Number | 36901045 |
| Brand | Candy |
| Dimensions (L x W x H) | 35 x 66 x 47 cm |
| Weight | 2 Kilograms |
| Control Type | Tactile (Touch) |
| Voltage | 220 Volts |
| Number of Speeds | 2 |
| Light Source | LED |
| Motor Power | 125 W |
| Max Extraction Capacity | 305 m³/h |
| Airflow Capacity | 264 m³/h |
| Filter Type | Active Carbon Filters, Anti-grease Aluminum Panels |
| Noise Level | 64 dB |
| Annual Energy Consumption | 26.4 kWh/year |
| Installation Type | Built-in / Under-cabinet |
| Compliance | Energy Star |
| Included Components | Filters, Installation Material |
8. Warranty and Support
Specific warranty terms and conditions for your Candy CBT6130/3X Telescopic Hood are typically provided with the product packaging or can be found on the official Candy website. Please retain your proof of purchase for warranty claims.
For technical support, spare parts, or service inquiries, please contact Candy customer service or your authorized dealer. Ensure you have your model number (CBT6130/3X) and serial number ready when contacting support.
