Legrand 773611

Legrand Cariva Model 773611 White Double Pole Light Switch Instruction Manual

Model: 773611 | Brand: Legrand

1. Overview

This manual provides essential information for the safe installation, operation, and maintenance of your Legrand Cariva Model 773611 White Double Pole Light Switch. This switch is designed for ON-OFF control of electrical circuits, featuring a double pole configuration and screw terminals for secure wiring. It is constructed from durable plastic and is suitable for various indoor electrical applications.

Legrand Cariva White Light Switch

This image shows the front view of the Legrand Cariva White Light Switch, highlighting its white plastic finish and button design.

2. Safety Information

  • Electrical Hazard: Installation must be performed by a qualified electrician or competent person in accordance with all local and national electrical codes.
  • Disconnect Power: Always turn off power at the circuit breaker or fuse box before installing, servicing, or removing the switch. Verify power is off using a voltage tester.
  • Voltage Rating: Do not exceed the specified voltage rating of 250V.
  • Indoor Use Only: This switch is intended for indoor use in dry locations. Do not expose to moisture or extreme temperatures.
  • Proper Wiring: Ensure all wire connections are secure and correctly terminated to prevent electrical shorts or hazards.

3. Package Contents

Verify that all components are present before beginning installation:

  • 1 x Legrand Cariva Model 773611 White Double Pole Light Switch

4. Setup (Installation)

  1. Turn Off Power: Locate the circuit breaker or fuse that controls the power to the switch location. Turn it OFF. Confirm power is off with a voltage tester.
  2. Remove Old Switch (if applicable): Carefully remove the wall plate and unscrew the old switch from the electrical box. Disconnect the wires, noting their connections.
  3. Prepare Wires: Strip approximately 1/2 inch (12-15mm) of insulation from the ends of the electrical wires if necessary.
  4. Connect Wires: The Legrand Cariva 773611 is a double pole switch. Connect the incoming live (hot) wires to the designated input terminals and the outgoing load wires to the designated output terminals. Ensure all screw terminals are tightened securely to prevent loose connections. A double pole switch typically controls two separate circuits or provides a full disconnection of both live and neutral for a single circuit (though this model specifies 'Normally Open' connection type, which implies it's a simple ON-OFF for a circuit). Consult a qualified electrician if unsure about wiring configurations.
  5. Mount the Switch: Gently fold the wires into the electrical box. Secure the new switch to the electrical box using the provided screws.
  6. Install Wall Plate: Attach the decorative wall plate over the switch.
  7. Restore Power: Turn the power back ON at the circuit breaker or fuse box.
  8. Test Operation: Test the switch to ensure it functions correctly.

5. Operating Instructions

The Legrand Cariva Model 773611 switch operates with a simple ON-OFF mechanism.

  • To Turn ON: Press the switch button to the 'ON' position.
  • To Turn OFF: Press the switch button to the 'OFF' position.

6. Maintenance

  • Cleaning: To clean the switch, ensure power is OFF at the circuit breaker. Wipe the surface with a soft, damp cloth. Do not use abrasive cleaners or solvents.
  • Inspection: Periodically inspect the switch for any signs of damage, loose connections, or discoloration. If any issues are observed, turn off power and consult a qualified electrician.

7. Troubleshooting

ProblemPossible CauseSolution
Light/Appliance does not turn ONNo power to the circuit
Loose wire connection
Faulty bulb/appliance
Check circuit breaker/fuse
Turn off power and check wire terminals
Test bulb/appliance with another power source
Switch feels looseMounting screws are looseTurn off power and tighten mounting screws

If troubleshooting steps do not resolve the issue, consult a qualified electrician.

8. Specifications

FeatureDetail
BrandLegrand
Model Number773611
Operating ModeON-OFF
Connection TypeNormally Open
Switch TypeDouble Pole Switch
Terminal TypeScrew
MaterialPlastic
ColorWhite
Item Dimensions (LxWxH)7 x 3.5 x 2 cm

9. Warranty and Support

Legrand products are manufactured to high standards and are backed by a manufacturer's warranty. For specific warranty details, please refer to the documentation provided with your purchase or visit the official Legrand website. For technical support or assistance, please contact Legrand customer service through their official channels.

Website: www.legrand.com

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.