1. Introduction
Thank you for choosing the Delta Stryke Mid-Height Faucet. This manual provides detailed instructions for the safe installation, proper operation, and effective maintenance of your new faucet. Please read this manual thoroughly before installation and retain it for future reference.
Image: Delta Stryke Mid-Height Faucet, model 676-SSLHP-DST, featuring a stainless steel finish and a single-hole deck mount design. The faucet includes a separate handle for water flow and temperature control.
2. Safety Information
Observe all local plumbing and building codes. Ensure the main water supply is turned off before beginning any installation or maintenance. Wear appropriate personal protective equipment, such as safety glasses, during installation. If you are unsure about any part of the installation process, consult a qualified plumber.
3. Package Contents
Verify that all components are present before beginning installation:
- Faucet Body
- Handle Assembly
- Mounting Hardware
- Water Supply Lines
- Installation Guide (this document)
4. Setup (Installation)
4.1 Pre-Installation Steps
- Turn off the main water supply to the installation area.
- Clear the area under the sink for easy access.
- Remove any existing faucet if applicable.
- Clean the mounting surface thoroughly.
4.2 Faucet Installation
This faucet is designed for a single-hole, deck-mounted installation.
- Mount Faucet Body: Insert the faucet body through the single hole in the sink or countertop. From underneath, secure it with the provided mounting hardware, ensuring the faucet is centered and stable.
- Connect Water Supply Lines: Attach the hot and cold water supply lines to the corresponding inlets on the faucet body. Connect the other ends to the hot and cold water supply valves. Hand-tighten, then use a wrench for a quarter turn. Do not overtighten.
- Install Handle Assembly: Follow the specific instructions provided with your handle assembly to attach it to the faucet body. Ensure it operates smoothly.
- Test for Leaks: Slowly turn on the main water supply. Check all connections for leaks. If leaks occur, tighten connections slightly until they stop.
5. Operating Instructions
The Delta Stryke faucet is designed for ease of use and water efficiency.
- Water Flow: Lift the handle to turn on the water. The further the handle is lifted, the greater the water flow.
- Temperature Control: Move the handle left for hot water and right for cold water. Adjust to achieve the desired temperature.
- Water Saving Feature: This faucet is designed with a maximum flow rate of 1.2 gallons per minute (GPM) to conserve water without compromising performance.
6. Maintenance
6.1 Cleaning the Faucet
To maintain the stainless steel finish of your Delta Stryke faucet, follow these guidelines:
- Clean with a soft, damp cloth and mild soap.
- Avoid abrasive cleaners, harsh chemicals, or scouring pads, as these can damage the finish.
- Rinse thoroughly after cleaning and dry with a soft cloth to prevent water spots.
6.2 Aerator Cleaning
If water flow decreases, the aerator may be clogged. To clean:
- Unscrew the aerator from the end of the faucet spout.
- Separate the components and rinse away any debris under running water.
- Reassemble the aerator and screw it back onto the spout.
7. Troubleshooting
Refer to the table below for common issues and their solutions.
| Problem | Possible Cause | Solution |
|---|---|---|
| Low Water Flow | Clogged aerator; partially closed supply valve. | Clean the aerator (see Section 6.2); ensure supply valves are fully open. |
| Leaks at Faucet Base | Loose mounting nut; worn O-rings. | Tighten mounting nut; replace O-rings if necessary (contact support). |
| Water Temperature Issues | Incorrect handle adjustment; issues with water heater. | Adjust handle position; check water heater settings. |
8. Specifications
| Feature | Detail |
|---|---|
| Brand | DELTA |
| Model Number | 676-SSLHP-DST |
| Material | Brass |
| Finish Type | Stainless |
| Mounting Type | Deck Mount |
| Hole Count | 1 |
| Maximum Flow Rate | 1.2 Gallons Per Minute |
| Product Dimensions | 6.59 x 3.75 x 8.94 inches |
| Item Weight | 1.32 pounds |
| Special Feature | Water Saving |
9. Warranty Information
DELTA faucets are manufactured to the highest quality standards and are backed by a comprehensive warranty. For specific warranty terms and conditions applicable to your product, please refer to the official DELTA Faucet website or contact DELTA customer support directly. Keep your proof of purchase for warranty claims.
10. Support
If you require further assistance, have questions about installation, or need to order replacement parts, please contact DELTA customer support. Contact information can typically be found on the official DELTA Faucet website or within the packaging materials.
