Klark Teknik LEDLAMP18 User Manual

1. Introduction

This manual provides detailed instructions for the safe and efficient use of your Klark Teknik LEDLAMP18. Please read this manual thoroughly before operating the device and retain it for future reference.

2. Product Overview

The Klark Teknik LEDLAMP18 is an 18-inch gooseneck LED lamp designed for professional audio and lighting applications, featuring a straight 4-pin XLR connector for power and compatibility.

2.1 Components

• LED Lamp Head: Contains the warm white LED illumination.
• Gooseneck Shaft: Flexible 18-inch shaft for precise positioning.
• 4-Pin XLR Connector: Standard connector for power input.

Figure 2.1: The Klark Teknik LEDLAMP18, illustrating its full length with the LED lamp head on one end and the 4-pin XLR connector on the other, connected by the flexible gooseneck shaft.

Figure 2.2: The Klark Teknik LEDLAMP18 in a curved position, demonstrating the flexibility of the gooseneck shaft. The LED lamp head and the 4-pin XLR connector are clearly visible.

Figure 2.3: A detailed close-up of the LED lamp head of the Klark Teknik LEDLAMP18, showing the arrangement of the warm white LED lights and the robust housing.

3. Setup

The LEDLAMP18 is designed for simple plug-and-play operation. Follow these steps to set up your lamp:

1. Identify Compatible Port: Locate a standard 4-pin XLR lamp port on your mixing console, audio interface, or compatible equipment. Ensure the port provides 12 Volts DC power.
2. Insert Connector: Carefully align the 4-pin XLR connector of the LEDLAMP18 with the compatible port.
3. Secure Connection: Push the connector firmly into the port until it clicks into place, ensuring a secure electrical connection.
4. Position Lamp: Adjust the flexible gooseneck shaft to direct the light as needed. The 18-inch shaft allows for versatile positioning.

Note: This lamp is compatible with "little* 18x-4-led lamp" systems and other standard 4-pin XLR lamp ports providing 12V DC.

4. Operating

Once connected to a powered 4-pin XLR port, the LEDLAMP18 will illuminate automatically. There are no additional controls on the lamp itself.

• Illumination: The lamp provides warm white LED illumination, designed for long-term viewing comfort in various professional environments.
• Power Consumption: The lamp operates with a low power consumption of 5 Watts at 12 Volts DC.
• Adjusting Light Direction: Gently bend the gooseneck shaft to position the light precisely where it is needed. Avoid excessive force or sharp bends to prevent damage to the shaft.

5. Maintenance

The Klark Teknik LEDLAMP18 requires minimal maintenance to ensure its longevity and optimal performance.

• Cleaning: To clean the lamp head or gooseneck, gently wipe with a soft, dry cloth. Do not use abrasive cleaners, solvents, or excessive moisture, as these can damage the LEDs or the lamp's finish.
• Storage: When not in use, store the lamp in a clean, dry environment, away from extreme temperatures and direct sunlight. Avoid coiling the gooseneck too tightly.
• Inspection: Periodically inspect the XLR connector and the gooseneck shaft for any signs of wear or damage. If any damage is observed, discontinue use and contact support.

6. Troubleshooting

If you encounter issues with your LEDLAMP18, refer to the following common problems and solutions:

7. Specifications

8. Warranty and Support

For warranty information and technical support regarding your Klark Teknik LEDLAMP18, please refer to the official Klark Teknik website or contact their customer service directly.

You can visit the official Klark Teknik store on Amazon for more information: Klark Teknik Store

For service or repair, please contact an authorized service center or your dealer.