Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your Genie Garage Door Opener Controller, model 39165R. This controller is compatible with Genie garage door openers that use models 34026A-R1, Series II, and 37351R. Please read this manual thoroughly before use to ensure proper function and safety.
A gray Genie garage door opener controller with a white faceplate, featuring a large primary button, lock/unlock icons, and a light bulb icon. The Genie logo is prominently displayed in red.
Important Safety Instructions
- Always keep the remote controls out of reach of children.
- Do not allow children to operate the garage door opener.
- Ensure the garage door is visible and clear of obstructions before operating.
- Regularly inspect the garage door system for proper balance and operation.
Setup and Installation
Programming Your Controller
This section outlines the steps to program your new Genie Garage Door Opener Controller 39165R to your existing Genie garage door opener.
Step 1: Locate the Learn Button
The "Learn" button is typically found on the motor head of your garage door opener. Its color may vary (e.g., red, purple, orange, green). Refer to your specific garage door opener's manual if you cannot locate it.
Step 2: Initiate Programming
- Press and immediately release the "Learn" button on your garage door opener motor head. The LED indicator light next to the button will illuminate.
- Within 30 seconds, press and hold the desired button on your new 39165R controller for approximately 2 seconds.
- Release the button. The garage door opener's light will flash once, or you may hear a click, indicating successful programming.
Step 3: Test the Controller
Press the programmed button on your 39165R controller. The garage door should activate. If it does not, repeat the programming steps.
Operating Instructions
Your 39165R controller features buttons for opening/closing the garage door and controlling the opener's light.
- Garage Door Operation: Press the large primary button to open or close the garage door. Pressing it again during operation will stop the door.
- Light Control: Press the button with the light bulb icon to turn the garage door opener's light on or off, independent of door movement.
- Lock Feature (if applicable): Some models may have a lock button (represented by padlock icons). Consult your opener's manual for specific functionality.
Maintenance
Battery Replacement
The 39165R controller uses a standard coin cell battery (e.g., CR2032). When the range decreases or the LED indicator on the controller fails to light up, it's time to replace the battery.
- Locate the small screw or tab on the back or side of the controller casing.
- Use a small screwdriver or coin to open the casing.
- Carefully remove the old battery. Note its orientation (+/-).
- Insert the new battery with the correct polarity.
- Close the casing securely.
Cleaning
Wipe the controller with a soft, dry cloth. Avoid using harsh chemicals or abrasive cleaners.
Troubleshooting
Common Issues and Solutions
- Controller Not Working:
- Check Battery: Replace the battery if it's low or dead.
- Reprogram: The controller may have lost its programming. Follow the "Setup and Installation" steps to reprogram it.
- Range Issues: Ensure there are no obstructions between the controller and the garage door opener. Check for interference from other electronic devices.
- Garage Door Not Responding:
- Power Supply: Verify the garage door opener has power.
- Safety Sensors: Check if the safety sensors are aligned and free of obstructions.
- Manual Disconnect: Ensure the emergency release cord has not been pulled, disconnecting the door from the opener.
If problems persist after attempting these solutions, consult a qualified garage door technician.
Specifications
Product Specifications
- Model: 39165R
- Compatibility: Genie garage door openers compatible with models 34026A-R1, Series II, 37351R.
- Power Source: Battery (e.g., CR2032, not included)
- Dimensions: Approximately 5 x 3 x 1.4 inches (Package Dimensions)
- Weight: Approximately 7.2 ounces (Item Weight)
- Manufacturer: Generic (functions as a Genie compatible part)
